Question about Cars & Trucks

1 Answer

I have a Possini Euro aluminum locus ceiling light

I have a Possini Euro aluminum locus ceiling light (#98523) with NO install instructions... It seems pretty straight forward to install but I can't seem to get it to work. Any ideas? I've changed bulbs and installation locations to be sure it wasn't me... Any suggestions? Does anyone have an installation manual? (here is a photo of the inside part of the ceiling cap)

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

Go talk to an electrician if your not sure. They should not charge you for advice.

Posted on Dec 13, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to get the car into neutral without the key


I have never done this before, but this instruction seems pretty straight forward:

How to Put Car in Neutral Without Key in the Ignition eHow

Jan 27, 2015 | Cars & Trucks

1 Answer

Installing bypass pulley on 1999 chevy blazer


Unbolt the a/c compressor. bolt in the a/c bypass pulley and install the belt. Its pretty straight forward.

Feb 13, 2013 | Cars & Trucks

1 Answer

2000 Ford Taurus - Installed a new radio and used the Meta 99-5716 install kit with wiring harness. After install, radio, pwr windows, pwr locks, dome light, windshield wipers, and speedomoter have stopped...


Sounds like you have blown fuses which could have happened if you accidently short circuted something while wiring up the new stereo. Check your fuses to see if any of them are blown.

Jan 07, 2011 | 2000 Ford Taurus

1 Answer

REAR BRAKES SHOES INSTALLATION HOW TO INSTALL


This is a pretty straight forward repair. Normally the hardest part of the repair is dis-assembly of the rear brake assembly components and retaining clips. There is a special tool, set of pliers you can purchase to simplify some of this but typically you can do the job with a Pair or Regular pliers, pair of Needle nose pliers and a large blades flat screw driver. For step by step instructions and illustrations of the work area I recommend the Haynes Repair manual for your vehicle.

Sep 30, 2010 | 1999 Mercury Cougar

1 Answer

How much work to replace a damaged oil pan on a 1984 Cressida


Its pretty straight forward if you have performed this job previously on other vehicles. Jack or support the vehicle to achieve enough clearance to perform the work safely. Drain all remaining oil, remove the oil pan. Clean the gasket surface, if its a cast iron engine block you can use some scotch brite with brake clean or carb cleaner to help remove all remaining gasket material if it is not a rubber gasket. If it is aluminum be very careful not to remove aluminum during the cleaning process. Make sure the gasket surface is dry and free of oily residue. Install new gasket, you may use silicone. Make sure you use a minimal amount, just enough to hold the gasket in place, or very thin layer on both sides of the gasket. reinstall the oil pan and tighten bolts to factory specifications in proper tightening sequence.

Jun 18, 2010 | 1984 Toyota Cressida

1 Answer

How to reset a battery light in a 2007 c70 volvo


Get an OBD II scanner and follow the instructions. Its pretty straight forward.

Mar 14, 2010 | 2002 Volvo C70

1 Answer

When replacing the spark plugs on a 3.7L 2006 liberty, should you disconnect the battery before taking the coils off? Is there anything else that I should know about this procedure?


You dont have too, but its always a good idea so you dont accidently touch the alternator or something similar. Its pretty straight forward, I like to put antiseize on the threads of the spark plugs when they are going in aluminum heads.

Jan 10, 2010 | 2006 Jeep Liberty

1 Answer

Replacing front shackle 1983 jeep cj7


Shackles are pretty straight forward. Remove the existing bolts, change the shackles and reverse the procedure to install. Good idea to change the bushings while you're in there if they are at all questionable. It's best to do this with the CJ in the air, supported on the frame and use a floor jack under the axle to lift/lower the spring in/out of the shackle, one side at a time.

Nov 19, 2009 | 1983 Jeep CJ7

1 Answer

I need instructions on how to install a DEH-P4900IB into a 2000 Honda Accord how to install the DEH-P4900IB into my 1998 Honda Accord car?


You need a kit and harness for both, easily obtained from Best Buy, eBay or Crutchfield. Pretty straight forward with the instructions that come with the dash kit.

Jun 01, 2009 | 1997 Honda Accord

1 Answer

1990 chevy lumina euro 2-door. passenger window


Chevy cheeped out and has been using aluminum rivots to hold the motor in place. to remove the motor remove the rivets.

Apr 25, 2009 | 1990 Chevrolet Lumina

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...