Question about Cars & Trucks

1 Answer

1995 GMC Sonoma high beams don't work - Cars & Trucks

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Check your high beam switch, if it doesn't make a clicking sound then it is possible you need to replace the high beam switch. I had the same problem with my car.

Posted on Dec 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 158 Answers

SOURCE: no reverse after rebuild on 4L60E Transmission from 1995 GMC Sono

There isn't a modulator on this trans as it is electronic

You can have first gear going forwrd but no reverse. It is possible. The low/ reverse clutch isn't needed to go forward.

Posted on Apr 02, 2009

ftw1952
  • 10319 Answers

SOURCE: No low beam, high beam and parking lights work

Bad headlight switch that needs replacing

Posted on May 23, 2009

  • 1 Answer

SOURCE: high beam lights and driving lights don`t work

Hi,
I got my daughter a 2003 Pontiac Sunfire. They are a lot of electrical work.
The problem is the wiring harness which splits and travels under the battery and the windshield washer reservoir. The wires oxidize and fall apart.
The low beams will work but if you turn on the high beams the lights will go completely out, right?
If this is the case I can pretty much guarantee that you will have to remove the battery, the drivers side front inner fender, the air filter housing, the air throat, and the windshield washer reservoir. You will then be able to open the wiring harness feeding the headlights. The wire that feeds your high beams is a pink wire. Test the wires from the harness plug (located just under the battery) to a point as close to the headlight as you can, Use a simple continuity tester. Also feel and bend the wires. If the insulation cracks and you see a green or lite blue powder then patch a new wire in.
All in all I found 4-wires which I replaced. Everything works now.
Good Luck,
Jay

Posted on Jun 15, 2009

SOURCE: 1995 gmc sonoma ignition key worn out

You have to remove the stering colum covers and in the ingnition key drum on the side there is a little hole, press the inside pin and pull the key ccylinder out, you can buy on autozone or pep boys.

Posted on Jul 18, 2009

ftw1952
  • 10319 Answers

SOURCE: 1995 GMC Sonoma ideals a little rough like it is

as time goes on yes so the idle speed control is wearing out

Posted on Mar 03, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1996 GMC Sonoma My high beam don't work,


The combination switch on the steering column operates a relay located under the hood to operate the Hi beams. The body control module controls it's operation too.

Dec 13, 2014 | 1996 GMC Sonoma

1 Answer

GMC Envoy 2003 SLT only the parking lights and fog lights work. The low beam and high beam don't work. Please help


Well, the problem is that I dont know the reason, you should investigate. There could be issues with lamps (must get new) or electricity problems (must head to auto-service)

Jun 29, 2012 | 2003 GMC Envoy

1 Answer

1995 gmc sonoma heater core removal, replacement. i need help removing the DASH.


About the heater core, in the manuel I bought at Auto zone, it gives all the steps and bolts necessary to unloose. The dash will swing out at the bottom, don't forget to remove the bolts under the speaker covers.
R/ Randy

Apr 14, 2011 | 1995 GMC Sonoma

1 Answer

1995 GMC Sonoma - blower motor works intermittently. Switch works fine. When switched to high, it might take a few minutes for blower to actually come on.


There is a relay under the dash on the passenger side that operates the fan. You can bump the dash on the under side passenger side. And the fan should come on. If so the relay needs replaced.

Dec 08, 2010 | 1995 GMC Sonoma

1 Answer

I JUST NEED A DIAGRAM OF THE SPARK PLUG FIRING ORDER ON A 1995 GMC SONOMA. GOD.


1995 GMC S15/T15 Sonoma P/U 2WD 2.2 liter L4 VIN "4"

fe2eb79.gif



1995 GMC S15/T15 Sonoma P/U 2WD 4.3 liter V-6 VIN "Z"

fd99af5.gif



1995 GMC S15/T15 Sonoma P/U 4WD 4.3 liter V-6 VIN "W"

38d92c6.gif

Hope help with this (remember rated and comment this).

Mar 28, 2010 | 1995 GMC Sonoma

1 Answer

1995 GMC Sonoma ideals a little rough like it is


as time goes on yes so the idle speed control is wearing out

Mar 03, 2010 | 1995 GMC Sonoma

1 Answer

High beams not working 1995 GMC Safari


The problem is the multifunction switch.

Nov 15, 2008 | 1995 GMC Safari

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...