Question about 2000 Ford Windstar

1 Answer

Where is the oil pan located on my 2000 ford winstar

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 90 Answers

The oil pan is on the bottom of the engine. It will have a drain plug to drain the oil at the lowest point on the oil pan.

Posted on Dec 13, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Psych0Thrash
  • 53 Answers

SOURCE: 2000 7.3 Liter diesel engine needing oil pan replacement

sadly I don't think there is. The oil pan is huge and sections of the frame are in the way of getting it in and out without damaging the pan severly. pulling that massive engine and replacing the pan, then putting the engine back in and reconnecting everything in 14 hours is a good estimate. sorry for the bad news

Posted on Aug 18, 2008

  • 66 Answers

SOURCE: 2000 ford winstar with 198000 km

The codes are lean fuel condition for both banks. A very common problem with this engine that will set these codes are the upper & lower intake gaskets. You may experience a rough or rolling idle at cold start up and the condition will go away as the engine warms up. If you have checked all the basics such as vacuum leaks or air inlet leaks between the air filter box and the throttle body, then I would consider replacing these intake gaskets. Good Luck and please leave rating. Thanks

Posted on Jan 05, 2009

  • 23 Answers

SOURCE: where is oil pan located?

YOU CAN SEE IT FROM BOTTOM,BETWEEN FRONT SUBFRAME,DIRECTLY BELOW ENGINE

Posted on May 16, 2009

emissionwiz
  • 77499 Answers

SOURCE: 2000 ford focus oil leak

Sounds like the valve cover gasket, clean off all the oil on the engine with a pressure washer or a steam cleaner and then drive it and recheck for the leak, that way you can pin it down for sure.

Posted on Oct 19, 2009

  • 439 Answers

SOURCE: i have a 2000 ford winstar with a code 1131 what

This has to do with your bank one O2 sensor. You may just need to clean it off, possible you may have to replace it.

Posted on Nov 06, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Oil light on at idle


Two reasons.... oil pressure sender is bad, check this first. You will have to install a manual guage where the oil pressure sending unit is located. If you have not changed you oil regularly, you might have built up sludge in the oil pan and some of the sludge has accumulated on the oil pickup tube located inside of the oil pan.

Jan 05, 2015 | 2000 Ford Taurus

2 Answers

My ford windstar 2003 is leaking from de oil pan by rusted


I think you know what has to be done, if you got under the
van & actually checked it out

You remove the oil pan,repair or replace it
& reseal it

Sep 23, 2011 | 2003 Ford Windstar

1 Answer

Where is the oil plug located on a 2000 ford ranger xlt


look under the truck and look to the oil pan, i believe on that truck its on the passenger side, on the side of the oil pan, torwards the back, it could be covered in oil and road dirt so it might be hard to see

Sep 18, 2010 | Ford Ranger Cars & Trucks

1 Answer

Need diagram for 2000 ford taurus oilpan


Oil Pan - Removal & Installation3.0L Engine
VIN S Engine
  1. Before servicing the vehicle.
  2. Drain the engine oil.
  3. Remove or disconnect the following:
    Negative battery cable Dual converter Y-pipe Transaxle support bracket Oil pan by following the bolt removal sequence shown

    8d11698.jpg
    Fig. Oil pan bolt removal sequence-2000-04 3.0L (VIN S) engine


    2272e92.jpg
    Fig. Oil pan bolt tightening sequence-2000-04 3.0L (VIN S) engine
Hope helps (remember rated and comment this).

Aug 15, 2010 | 2000 Ford Taurus

1 Answer

How do I get to the oil drain plug on a 2000 Ford E150


Under engine you will locate the OIL pan which is solid metal and you will notice Under OIL pan is a 17MM Bolt
Remove that to drain oil
Oil drain may take up to 45 Mins to fully drain

Jun 22, 2010 | 2003 Ford E150

1 Answer

I have a 2000 ford winstar with the engine light on codeP0705 transmission range sensor where is it located


Usually on Trans,on bottom of case,near oil pan. Follow shift cable and look for wire harness,going to it.

Apr 30, 2010 | 2000 Ford Windstar

2 Answers

Coolant is black in 2000 ford winstar


Flush the coolant system and replace with new antifreeze.

Jun 02, 2009 | 2000 Ford Windstar

1 Answer

Ford winstar 2000 lx


No, they use a timing chain.

Feb 28, 2009 | 2000 Ford Windstar

1 Answer

Coolant is black in 2000 ford winstar


2 types of engine coolant one is green other is pink wrong one is used it changes color to black! witch one did you use? your vehicle may be faced with this I found 5 cars like this with this problem= wrong coolant installed!

Jan 05, 2009 | 2000 Ford Windstar

Not finding what you are looking for?
2000 Ford Windstar Logo

68 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5626 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...