Question about Cars & Trucks

1 Answer

Digitalsphygmomanometer how to fix when they give high false readings how should i fix it

They give high false readings

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,249 Answers

There is no blood pressure gage on a car

Posted on Dec 12, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to fix yhis code it on a 2006 accord 4 cyl u 0107 how to fix this code

This code refers to a MAP sensor problem. This sensor uses engine vacuum to calculate fuel delivery. Check for any vacuum leaks from loose/disconnected hoses under the hood as these will give this sensor false readings and could cause a false code. If nothing found, the sensor plug will need to be checked for a ground, a 5vreference supply and the return signal wiring to the computer for communication. If all good suspect faulty sensor

Jul 12, 2015 | Cars & Trucks

1 Answer

Have problem with sender unit,it sticks at quater full,gives false reading miles left,

most likely you will need to pull fuel pump assembly. might as well change the whole thing once in there and it was save time later

Oct 15, 2014 | 2005 BMW X5

1 Answer

1990 GMC Sierra 5.0 TBI doesn't pass emissions high hydrocarbons. Tested 3 times 1st test 2.02 second test measured at 2.04 and the third test measured at 2.14. I have passed all other test but can't

other than changing the identified parts ,which i imagine are expensive ,check all air intake pipe work as a split or worn hose can cause irregular air intake thus giving a false exhaust reading

Mar 28, 2014 | 1990 GMC Sierra

2 Answers

Z71 high oil pressure


normally the engine will start cold and have about 60 lbs and as it gets warmer the pressure will start to fall and should idle at about 35 or 40 lbs. you also could have a bad oil pressure sending unit that is giving you a false reading, along with possibly a bad wiring connection or gauge in the dash. first thing is the sender and the connector to check.

Dec 31, 2013 | Chevrolet Silverado Cars & Trucks

1 Answer

2012 nissan Quest. on start up the blower runs on high in front and back. the climate control wont turn off , up or down. blowing in back as well.

may be faulty temp sensor ,,,,, or dust gathering on it giving false reading ,,,, you need to get a diagnostic reading to check internal temp readings and see if they are too low for the real temp of your area

Nov 22, 2013 | Cars & Trucks

1 Answer

My fuel gage is giving me a false reading on my peugot partner 1.8L van,how can I fix this problem?

The usual reasons for intermittent fuel readings are that a wire is loose from the sending unit in the tank or on top of the tank, the connection is not making good contact. If you are getting no reading and it was intermittent or "false" reading at different levels of gas in the tank, the sender unit in the tank is broken. It needs to be replaced.

Jan 16, 2013 | Cars & Trucks

1 Answer

P1763 governor sensor pressure voltage high. What will it cos to have new sensor, seleniod and whatever else that will be required to fix it?

HI. Ok, this may be a false reading. In most cases, driving into a large puddle in a rainy situation , will cause this false reading. I would reset the PCM and drive it for a while to see if the code returns. if it returns, simply, replace the Governor pressure sensor switch and solenoid. the total price, including parts and new trans oil, will be around $165.00.

Aug 11, 2010 | 2001 Jeep Grand Cherokee

2 Answers

Speedometer temprature guage is false readings

Pretty common problem with these. Here's a guide to learn how to fix GM instrument clusters yourself, I used it to fix mine and it worked great.How to guide for Monte Carlo instrument cluster repair

Jan 18, 2010 | 2004 Chevrolet Monte Carlo

1 Answer

Factory oil pressure gauge maxed out at 80psi and shakes

is oil level full? oil sending unit will either be near filter or near distributor buy one look both places replace if no change get live oil pressure reading if shows better or lower than guage has short at censor in dash giving false high readings

Apr 05, 2009 | 1992 Chevrolet S-10

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides