Question about 1993 Mitsubishi 3000GT

1 Answer

Get tec info for 93 gt 3000

Tec specs fuel ignition

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 5,351 Answers

Your need a shop manual.

Posted on Dec 12, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

97 caravan stumles when you give it gas


Very likely a low fuel pressure problem. Have you changed the fuel filter? Check the fuel pressure against vehicle spec's while running at idle and again at about 3000 RPM. Also check pressure with key on/engine off. If you lose pressure between idle and higher RPM's you probably have a weak fuel pump. Same goes for if you lose pressure after initial key on/engine off. You could also have a problem with a weak ignition coil, spark plug wires or spark plugs but not as likely.
12_24_2012_1_16_33_pm.png

Dec 24, 2012 | 1997 Dodge Caravan

1 Answer

Honda 93 will start on for seconds but wont stay started.had to use a jump wire


Hello! Tell me where you placed the jumper wire?...Also is the Check Engine light on?...If it is (See photo below) push a paper clip into the 2 female pins of the OBD 1 connector...Turn on the key and count the Check Engine Light flashes...Example; 5 long flashes followed by 2 short flashes= Code 52...code list below...Guru...saailer

Code 0 and 11 Electronic Control Module (ECM)
Code1 Heated oxygen sensor A
Code 2 Oxygen content B
Code 3 and 5 Manifold Absolute Pressure
Code 4 Crank position sensor
Code 6 Engine coolant temperature
Code 7 Throttle position sensor
Code 8 Top dead center sensor
Code 9 No.1 cylinder position sensor
Code 10 Intake air temperature sensor
Code 12 Exhaust recirculation system
Code 13 Barometric pressure sensor
Code 14 Idle air control valve or bad ECM
Code 15 Ignition output signal
Code 16 Fuel Injector
Code 17 Vehicle speed sensor
Code 19 A/T lock-up control solenoid
Code 20 Electric load detector
Code 21 V-TEC control solenoid
Code 22 V-TEC pressure solenoid
Code 23 Knock sensor
Code 30 A/T FI signal A
Code 30 A/T FI signal B
Code 41 Heated oxygen sensor heater
Code 43 Fuel supply system
Code 45 Fuel supply metering
Code 48 Heated oxygen sensor
Code 61 Front heated oxygen sensor
Code 63 Rear heated oxygen sensor
Code 65 Rear heated oxygen sensor heater
Code 67 Catalytic converter system
Code 70 Automatic transaxle
Code 71 Misfire detected cylinder 1
Code 72 Misfire detected cylinder 2
Code 73 Misfire detected cylinder 3
Code 74 Misfire detected cylinder 4
Code 75 Misfire detected cylinder 5
Code 76 Misfire detected cylinder 6
Code 80 Exhaust recirculation system
Code 86 Coolant temperature
Code 92 Evaporative emission control system


2_19_2012_12_11_48_pm.jpg

Feb 19, 2012 | Cars & Trucks

1 Answer

This 1999 dodge 1500 5.9l will start and run fine till about 1500 RPM and then misfires and pings severely. [ CHRYSLER ] Record1 -> 1998~2003 -> PCM -> ECU Information Module of year: ...


Hello.. looks like you are getting good fuel delivery. Is the fuel curve mixture on the scanner in specs? How is the timing, the timing chains on these engines will stretch and throw the timing off causing a ping and missfire -- a weak valve spring is something to consider. Also, the PCM may be faulty. I hope this helps.

Sep 27, 2011 | 1999 Dodge Ram

1 Answer

Where is the fuel pump relay located in a 93 toyota celica gt?


where is the fuel pump relay located in a 93 toyota celica gt?

Nov 17, 2010 | Toyota Celica Cars & Trucks

1 Answer

I have a 1993 Mitsubishi 3000 GT. It has a new


need more info whether you have fuel pressure etc.

Jul 31, 2010 | 1993 Mitsubishi 3000GT

1 Answer

I'm working on a 93 probe gt when I turn the ignition I get all the lights, fuel pump, bells but no cranking. Pulled the starter it's good. I can get it to run if I hot wire it from the solenoid to the...


have you replaced the ignition switch? not the key cylinder but the actual electrical switch, they are prone to this type of failure, pull the covers off the steering column and test the switch.

Oct 15, 2009 | 1993 Ford Probe

1 Answer

93 taurus s/w no power, backfires thru intake


Most fuel injection systems require around 35psi in order for the injectors to function properly.

Jul 10, 2009 | 1993 Ford Taurus

2 Answers

Will a GM 60 degree V6 work in my '97 Rodeo LS V6 4wd


NO! Call a salvage yard, they have info. on what will fit it.

Jun 04, 2009 | 1995 Isuzu Rodeo

Not finding what you are looking for?
1993 Mitsubishi 3000GT Logo

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

77202 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8743 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...