Question about Cars & Trucks

1 Answer

The car is unable to climb up a Hill what are the possible causes

I have change the ignition coil

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 17 Answers

Wires, tune up, transmission staying in high gear. low fuel pressure

Posted on Dec 12, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What causes Soltice to rev up and down shift when climbing hill but loose speed


That is the way gears in cars work. When you go up hill, the car needs more gas, so you put your foot down, kick down comes into play and the gearbox chooses one gear lower, for more engine revs and lower speed you get more torque to climb the hill.

Get the car tuned up, you might have failing sensors or ignition problems causing a general loss of power that is needing kick down on hills.

Dec 25, 2016 | Cars & Trucks

1 Answer

2003 buick park avenue misses badly on acceleration or hill climbing. ZSpark plugs show burn lines on ceramic part replace and it reoccurrs


Did you also replace the spark plug wires? The burn lines on the ceramic would indicate that it's jumping fire. Are the burn lines on ALL the plugs or just one or two? If you look closely at the wires in the dark, you will be able to see the spark jumping to ground if the wires are bad. If you have already replaced the wires and still have that issue, it's possible that you have a bad coil pack or ignition module.

Dec 18, 2014 | 2003 Buick Park Avenue

1 Answer

I have a 2004 3.9L Mustang with the "check engine soon" light on. I read the codes and 0300, 0301, 0305 and 0316 were up, while the car was still driving fine. Soon, it started to lose strenght, I bar


Best to read the codes first---code p0300 refers to random multiple cyl-- misfire detected causes-- spark plugs---HT leads--ignition coils--wiring.
code p0301 refers tocylinder 1-- misfire detected causes ---engine mechanical fault---wiring---ignition /fuel system ---injector---ECT/Maf sensor(Mass air flow) ECM.
code p0305 refers to cylinder 5 misfire detected causes ---same as 0301
code p0316 refers to misfire detected during start up -first 1000 rpms---causes--- engine mechanical fault---wiring----ignition/fuel system---injector. I would run a fuel system pressure pressure test as the common causes here is the fuel/injectors

PLEASE RATE THIS REPLY FOR ACCURACY

Mar 24, 2013 | 2004 Ford Mustang

1 Answer

I have 2006 kia rio the catalytic converter heated,i changed but still it can't climb hill.when idle i noise in the air cleaner housing.


You have not addressed why the cat overheated. One cause is the engine running rich. If you have not fixed that then the problem will still be present. That appears to be the case due to lack of power. Describe the noise

Mar 12, 2013 | Cars & Trucks

2 Answers

My toyota camry will not pick speed especially when it climbing a hill


this could be caused by an ignition problem, wrong parts, or a timing problem.
try using ngk or denso(ngk recommended) spark plugs, ngk spark plug wires, and if needed new coils. ngk and denso are the factory recommended parts for the model, i have a 98 camry lewith a 2.2.
also if it is low mileage, below 200k or doesnt leak oil, try castrol syntec 5w 30 oil and a k&n air filter

Jul 05, 2011 | 1998 Toyota Camry

1 Answer

My Toyota Siena 2002 model emits black heavy black smoke on motion. It jacks violently when climbing hill. My mechanic said I will change the brain box. Please help!


IS THE CHECK ENGINE LIGHT ON.IF YES COULD BE FAULTY PCM.BUT HAVE CAR CODE SCAN TO MAKE SURE BECAUSE YOU COULD HAVE A FUEL SOAK CHARCOAL CANISTER , WEAK IGNITION SPARK, FAULTY FUEL PRESSURE REGULATOR.AND LOW CYLINDER COMPRESSION ALL OF THESE THINGS WILL CAUSE BLACK RICH SMOKE MIXTURE.

Jan 26, 2011 | 1998 Toyota Sienna

1 Answer

Mercury Mountaineer sputters and backfires when climbing a hill


EGR Valve!
Do you have a MIL Light on? If so,what codes do you get?
Also,maybe a bad ignition coil

May 24, 2010 | 1997 Mercury Mountaineer

1 Answer

Engine light is on and the engine is running rough at certain speeds and climbing up hill


Most likely ignition coils. Not all of them. What code do you get. PO304 as an example. Have a code reader or scanner plugged in next to your right knee under dash and give me the codes

Feb 04, 2010 | 2002 Lincoln LS

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...