Question about Kia Cars & Trucks

1 Answer

What causes 15amp eng fuse to blow as soon as I change it , on kia k2700 diesel 2006

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 384 Answers

A short to ground pull pos cable off battery load test battery if good ,l\follow power back to fuse box looking for breaks pinches or other things that would cause a short. Look where the wires go throught the cab , make sure the fuse block bolt is tight if it has one . look for hot spots in fuse block repair as needed good look around any place that power is run to it

Posted on Dec 12, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 50 Answers

SOURCE: blows 15amp ecm fuse

replace ignition switch

Posted on May 30, 2009

  • 25 Answers

SOURCE: my 2001 porsche boxster s power windows will not

possible short in wireing

Posted on Jun 25, 2009

  • 713 Answers

SOURCE: FUEL PUMP RELAY LOCATION

Fuel pump relay should be in the under hood fuse box. going to be a small relay about 1x1/2 long.

Posted on Oct 03, 2009

  • 1 Answer

SOURCE: 2006 kia sedona a/c keeps

My kia sedona minivan keeps blowing the fuse to the a/c compressor. Does this mean that I have a bad compressor or is there a less expensive esier fix? Any ideas?

Posted on Aug 14, 2010

  • 2 Answers

SOURCE: AM2, 15amp, Starter system, "ST"

Have an auto electrician look at it.

I had the same problem just last week. It turned out to be the idle regulator. Every time the IR got hot it would blow the fuse. You can drive the car without it attached but get it fixed asap. Got one for $40 from a spare parts place ($200 brand new) and my mechanic mate changed it for me (looked easy enough to do it yourself). Good luck.

Posted on Sep 18, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is torque settings for head bolts on Kia pregio 2001


What are the cylinder head torque settings for a KIA K2700

www.answers.com > ... > Categories > Cars & Vehicles > Asian Cars > Kia
What is the torque specification for the cylinder head on a 2002 Kia Sportage? ... the correct torque for cylinder head bolt of kia pregio 2.7 diesel is 130-135ft-lbs. ... Thehead bolt torque settings, on your Kia 2.7 diesel engine, is 70 pounds per ...

Aug 17, 2015 | Kia Cars & Trucks

1 Answer

Where do I find the master cylinder on the Kia K2700 diesel bakkie?


on the end of the brake pedal ,but some vehicles were designed for LHD so their could be a cantilever mechanism so its on the opposite side to the driver ,never heard of this vehicle ,a kia carnival yes ,even a kia van but not many about ,everyone wants a ford transit or better still a VW or top of the range a merc vito

Jan 17, 2015 | Kia Cars & Trucks

1 Answer

How do I troubleshoot an eng fuse that keeps blowing out as soon as I turn the ignition on , on a kia k2700 diesel 2006.


You need a wiring diagram. If the fuse supplies several parts, then you have to find the short. It could be the part or the wire going to a part, or several parts. What does the fuse control?

Dec 12, 2014 | Kia Cars & Trucks

1 Answer

Where is the eng module located on kia k2700 diesel 2007


I didn't even know Kia produced a diesel engined vehicle. At any rate, there should be a Chiltons/Haynes repair manual that covers your truck. It's full of all sorts of information for maintaining and repairing your truck.

Dec 12, 2014 | Kia Cars & Trucks

1 Answer

Where is the diesel pump relay located in a 2005 kia k2700 mk2


it behind the floor brace under dash in front of the shifter

Apr 17, 2014 | 2007 Kia K2700 Workhorse

1 Answer

Eng cont1 fuse


fuses blow because of excess current draw. check for a short after the fuse . wire touching the earth or body / engine or melted on the exhaust

Dec 06, 2013 | 2000 Nissan Maxima

1 Answer

My 2004 kia k2700 tu diesel is just idling and as soon as you acelerate it stops. Just clean out fuel lines with injector cleaner and cleaned fuel tank and still does it as well as blowing blue grey s


Check the seal aroud the accelerator shaft on the pump. If the seal leaks reduced pressure in the pump will not allow the governor system to work properly The smoke color is the give away to a faulty pump

Jan 07, 2013 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

yadayada
yadayada

Level 3 Expert

75807 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...