Question about Cars & Trucks

1 Answer

How long and how difficult is it to replace gear shift cable on a 1998 dodge stratus?

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,368 Answers

It depends on your skill set and what tools you have available to you.

Posted on Dec 12, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 178 Answers

SOURCE: 1998 dodge 1500 wont shift

first of all standard or auto i am guessing its standed standard under drivers side hood near master cylinder there is a small clutch reservoir if there isnt enough fluid it wont extend the throw out bearing far enough for a shift because the clutch pedal is hitting the floor not enough fluid to extend the slave cylinder to drive the fork second faulty slave cylinder or throw out bearing as far as the light blown dash bulb or somone snipped the wire or took the bulb out

Posted on Sep 11, 2008

  • 1 Answer

SOURCE: 1997 dodge stratus with transmission problems

We have the same proplem and replaced the sensor didnt help. Could there be another reason the car will do this? ( this was the one on the front right side of transmission).

Posted on Sep 30, 2008

csmock132
  • 4669 Answers

SOURCE: 1998 dodge stratus will not shift after engine swop

Check the input shaft and output shaft speed sensors on the transmission. One is likely bad.

Posted on May 27, 2009

  • 412 Answers

SOURCE: 2005 dodge stratus - 4 cyl auto - while driving,

ANY CODES PRESENT?ENGINE LIGHT ON?YOU MAY HAVE AN INPUT OR OUTPUT SENSOR DROPPING OUT..ALSO SOME DIRT MAY HAVE ENTERED TRANSMISSION WHEN SOLENOID PACK WAS CHANGED..MAY HAVE WENT INTO SMALL FILTER SCREENS OF SOLENOID PACK WHEN ENGINE WAS STARTED,CUTTING OFF FLUID FLOW TO SOLENOIDS..HAVE SEEN THIS RECENTLY AFTER A SOLENOID PACK REPLACEMENT

Posted on Jul 19, 2009

  • 155 Answers

SOURCE: how to change gear shift cable on 2001 dodge dakota 2 wheel drive

the cable goes from the shifter to the transmittion arm,, both cable ends connect via a pin and cotter key (usually) the cable housing (black outside layer) is connected to the shifter frame usaually by a clip and is bolted to the transmittion with a couple bolts on the other end ,, i know this was pertty basic but hope it helped

Posted on Mar 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

02 Dodge Stratus for the 2.4 engine pO700 po733


P0700 is simply the ecm recognising that the tcm (tranny) has an error code stored/registered. The one to worry about is your p0733 code. This code means the tcm detected a gear ratio error in third gear. There's 5 main possible causes. Simple/cheap -> expensive/difficult. .. Low or dirty ATF. Add fluid if low or change fluid and filter If burnt smelling or dirty/discolored. Shifting solenoid . Check or have tested the shifting solenoids . They control fluid flow and transfer to various clutch packs for gears. Hydraulic control circuit and mechanical failure. Both of these require full rebuild. Control circuit is expensive and hard to get to . Mechanicalso is usually either a worn out/pourly adjusted clutch pack causing the gear to slip or a failing torque converter.

Feb 28, 2015 | 2002 Dodge Stratus

1 Answer

WHILE SHIFTING GEARS INTO 5TH GEAR THE PEDAL WENT TO THE FLOOR AND FELT LIKE THE CABLE MAY HAVE BROKE. THE GEARS WOULDNT SHIFT WHILE THE CAR WAS RUNNING


IF you have a cable actuated clutch then replace the cable complete. The gears will not change because there will be load on the teeth while the engine is running making changing very hard.

Aug 31, 2013 | 1998 Dodge Neon

1 Answer

2001 dodge stratus stuck in 2nd gear after engine and trans swap...reverse is just fine. starts in 2nd and only stays there. What's going on??


Stuck is 2nd means it's in limp in mode. Get the trouble codes scanned to find out what's going on.

Sep 25, 2017 | 2001 Dodge Stratus

1 Answer

1998 dodge stratus will not shift after engine swop


Check the input shaft and output shaft speed sensors on the transmission. One is likely bad.

May 26, 2009 | 1998 Dodge Intrepid

1 Answer

1998/99 Dodge Dakota clutch and manual transmission problems


clutch needing replaced, very common on all manuals

pedal travel adjustment,yes
gear shift adjustment,no

May 12, 2009 | 1998 Dodge Dakota

1 Answer

Transmission shifts hard down from highway gear only (D>3rd)


I had the same thing! It was a computer issue. It only cost me about $35.00.

Dec 29, 2008 | 2002 Dodge Stratus

2 Answers

1997 dodge stratus with transmission problems


sensor on the tranamission needs replaced

Sep 26, 2008 | 1997 Dodge Stratus

1 Answer

Does the 1998 dodge stratus have a floor shift indicator light?


Hi if you mean console on automatic gear indicater Yes it does just fixed mine (Wire was off) just pop the oval arround the gear shift light bulb and wires in there.

Jul 27, 2008 | Dodge Stratus Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

77169 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22258 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...