Question about Cars & Trucks

1 Answer

2000 sw-2 starts but wont run .How do you check timin chain

Starts but wont run changed spark plugs .changed gas filter car has spark

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

    Governor:

    An expert whose answer got voted for 20 times.

  • Cars & Trucks Expert
  • 149 Answers

Timing chain failures are not common on these cars, fuel pump relays are. The computer sends full battery voltage to the pump for initial start up only, then switches the power to go through a relay and resistor, dropping the voltage to 9 volts instead of 12. When they go bad, it starts fine, but dies in three to five seconds

Posted on Dec 12, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a 2000 ford focus that cranks but don't starts, fuel pressure is good, good spark but spark plugs are pretty worn out can that cause it to do that?


You only need three things to start an engine.
1) Clean Fuel / Air
2) Compression
3) Spark

One of these is not working correctly. The fuel pressure is good, but the fuel line, fuel filter, injectors, or carb may be dirty or clogged. If the gas has been sitting for a long time, or could have water in it, there is potential for the gas to be gummed up, and it wont ignite. Start with clean, new gas, line, filter, and if it still wont start, move on to the #2, #3 items from the list above.
Move through the troubleshooting systematically.
Remember, you only need 3 things to get it to run!

Good luck

Mar 19, 2013 | Ford Focus Cars & Trucks

1 Answer

Motor turns over but wont start. has gas, no bad fuses


Do the spark plugs have spark?
Also check the condition of the air filter.

Is the vehicle fitted with an immobilizer?

Nov 03, 2012 | 1996 Ford Windstar

1 Answer

Why does my 86 2.9 l. ranger kill spark plugs


your truck is running too rich with fuel if you have a carburator have it check

Sep 18, 2012 | Cars & Trucks

1 Answer

How to fix a1998 buick century to start fuel filter new and airfilter turning over but not starting gets gas


Did you check for spark? It sounds like you're not getting spark. Check for spark. If you are not getting spark then it sounds like you might have to replace the coil packs. Is it running a L4 engine? If its running a standard chevy L4 its probably the coil packs. Try to replace them check again for spark.

May 25, 2012 | 1998 Buick Century

2 Answers

Car want start. motor turn but want start as if it's not getting any gas. I have over a half tank of gas in the car.


IF FUEL FILTER GOOD.CHECK FUEL PUMP FUSE AND RELAY.IF ALL IS GOOD.FUEL PUMP COULD BE FAULTY.

Sep 12, 2010 | 2000 Lincoln Town Car

2 Answers

Truck stopped running as I was driving and won't attemp to cranck.


wont turn over or wont start, if it wont turn over your alternator probably came unpluged or went out then drained your battery, if it turns over but wont start you lost the timing chain

Jul 01, 2010 | 1995 Chevrolet Silverado 2500

3 Answers

It wont Start


Well if your lucky you can replace the fuel filter add a gas stabilizer and some new gas and you might get it to go. After a car has been sitting so long the oil runs off the parts like the crank and rod bearings and could cause a dry start ruining the bearings, and after that long the gas gels and does not burn well and can plug the filter. So change the oil and filter as well as water and oil make an acid that can damage seals and engine parts.

Jun 25, 2009 | 2000 Kia Sportage

1 Answer

Starting trouble after i let it run out of gas


Sediment from the bottom of the tank could be blocking your fuel filter. Replace your fuel filter.

Feb 22, 2009 | 1988 Nissan Sentra 2 Door

1 Answer

2000 toyota tacoma 2.4l wont start when cold


clogged injectors you need to put cleaner in the fuel to help get dirt and grit out of them some times (every 3 months).
I am assuming you are saying it will turn over but not fire and run when cold?

Jan 16, 2009 | 2000 Toyota Tacoma PreRunner

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

92 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...