Question about 2005 Nissan Xterra

Open Question

Location of windsheild washer pump on 2005 Nissan Xterra

How to replace?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2005 Nissan Xterra gas gauge reads empty when full of gas.

My car won't start.I put the key in the ignition, turn the key and nothing happens. It's not the chip in the key, I tried a new key. I usually have to wait about 5 min. then it starts up like nothing is wrong.

Posted on Jul 28, 2009

ZJLimited
  • 17970 Answers

SOURCE: Diagram available for 01 Nissan Xterra Knock Sensor location?

V6 3.3L The sensor is located underneath the air intake manifold on top of the engine block. This should take an experienced mechanic about 3-4 hours to replace.

9bd8ec7.jpg

Fig. Engine compartment component locations

Hope this help (remember rated this free help) Good luck.

Posted on Feb 08, 2010

  • 10 Answers

SOURCE: 2000 nissan xterra...windshield washer fluid pump

On the drivers side of the vehicle just behind the front bumper is the washer fluid reservoir. The washer pumps (2 - one for the back and one for the front) are located ont the face of the reservoir.

1) Drain the resevoir. (You can reuse this fluid, so put it in a clean container)
2) Disconnect the wiring harness for the problem pump.
3) Remove the sprayer line.
4) Remove the pump. It is held in by being snapped into a channel on the resevoir and by the rubber grommet. This may take some elbow grease.
5) Remove the old grommet.(If your new pump came with a new grommet)

Installation is reverse. Usually new pumps come with new grommets. If not, it is ok to reuse the old one.

Posted on Mar 14, 2010

SOURCE: HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA


Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Posted on Mar 31, 2010

shinehutt
  • 254 Answers

SOURCE: 2000 nissan xterra, replaced washer pump, not

have someone press washer switch and feel if pump is working if not the owners manual will have fuse location and breakdown of circuits it uses check that hope it helps you

Posted on Jan 15, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the Nissan Xterra 2005 Speed Sensor Located and what does the main speed senor look like?


could be the vehicle speed sensor (VSS) and is on the trabsmission
talk with an accredited auto specialist to get the exact location or get a workshop manual to see how to test /replace it
could be very possible wiring problem and dirty connectors in the harness

Jul 15, 2017 | Nissan Cars & Trucks

1 Answer

Location of fuel pump relay switch on 2007 nissan xterra


Location of fuel pump relay Leslie, Fuel pump relay is above drivers right knee, under dash.
Links below are manuals to your problem.
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
http://www.nicoclub.com/FSM/Xterra/2007_Xterra/ec.pdf
http://www.nicoclub.com/FSM/Xterra/2007_Xterra/pg.pdf
2007 fuel pump relay

Mar 27, 2016 | Nissan Cars & Trucks

1 Answer

Need a new plug for altenator


images for 2005 Nissan Xterra Need a new plug for ..

How To Install Replace Alternator 2.5L 2002-06 Nissan ...

? 6:01
https://www.youtube.com/watch?v=pyrs4-_4U8o
Nov 18, 2013 - Uploaded by 1A Auto Parts
http://www.1aauto.com/1A/alternator/Nissan/Altima/1AEAL00411 1A Auto shows you how to repair, install, fix, change or replace a broken or bad alternator. Thi. ... Need to report the video? ... 2005 Nissan Altima 2.5L serpentine belt tensioner replacement - Duration: 4:06. by Randy Templeton 18,489 views.

View topic - Replacing the alternator ' Xterra Firma

AUTOZONE!

Dec 26, 2015 | 2005 Nissan Xterra

1 Answer

Where is the horn fuse for a 2005 Nissan xterra


at the panel-view the owners manual or ask a partsplace--the horn cud be bad too--pick one up at a junk yard

Nov 16, 2014 | 2005 Nissan Xterra

1 Answer

2000 nissan xterra, replaced washer pump, not pushing any fluid, is there a fuse for the washer if so i havent been able to find it.


have someone press washer switch and feel if pump is working if not the owners manual will have fuse location and breakdown of circuits it uses check that hope it helps you

Jan 15, 2011 | 2000 Nissan Xterra

3 Answers

Where exactly is the fuel pump on a 2005 nissan xterra


It's in the fuel tank, which must come off to replace it. Let me know if you would like instructions for removal.

Nov 01, 2010 | 2005 Nissan Xterra

2 Answers

HOW TO REPLACE A FUEL PUMP FOR A NISSAN XTERRA



Removal & Installation

  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Relieve the fuel system pressure.
  3. Drain the fuel tank.
  4. Remove or disconnect the following:

    Negative battery cable Fuel pump module harness connectors Filler hose shield Fuel pressure and return lines Filler hose Vent hose Evaporative Emissions (EVAP) hose Fuel tank skid plate Fuel tank Fuel level sender Fuel pump

To install:
  1. Install or connect the following:

    Fuel pump Fuel level sender. Tighten the screws to 17-23 inch lbs. (2.0-2.5 Nm). Fuel tank. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). Fuel tank skid plate. Tighten the bolts to 27-36 ft. lbs. (37-49 Nm). EVAP hose Vent hose Filler hose Fuel pressure and return lines Filler hose shield Fuel pump module harness connectors Negative battery cable
  2. Fill the fuel tank.
  3. Start the engine and check for leaks.

Mar 31, 2010 | 2005 Nissan Xterra

3 Answers

2005 Nissan Xterra gas gauge reads empty when full of gas.


Sending unit died. can be expencive to replace since most sending units are integral with the fuel pump now. lots of labor too. Better to use the trip odometer till you can afford a day without your car and a $600.00 +labor repair bill.

Jul 07, 2009 | 2005 Nissan Xterra

Not finding what you are looking for?
2005 Nissan Xterra Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...