Question about Ford Cars & Trucks

2 Answers

Manuals ford taurus

Picture of relay for ac

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

I will need the year of your vehicle please.

Posted on Dec 10, 2014

Ad

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 104 Answers

If you need one go to ford service department

Posted on Dec 10, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is fuel pump relay located on 1994 Ford Taurus 3,8 motor


Here's the solution of your problem
http://www.reliable-store.com/products/1994-ford-taurus-workshop-repair-service-manual-pdf-download 1994 Ford Taurus Workshop Repair Service Manual PDF Download

May 27, 2016 | Ford Cars & Trucks

1 Answer

AC will not blow through the vents of my 2002 Ford


You have to try all the vent blend positions-- manually

You have 5 combinations to figure out & a factory service
manual, sure would help you, but not for the cost, if your
not an experienced car person

When you decide where the air or heat does not flow,
you have found your problem

Then you go to Motorcraft Parts Web Site & blow up
a parts picture of the HVAC Blend Door Motors, under the dash

Looking at the picture, if your have any vehicle repair experience,
you can see which one needs to be replaced

Write down the ford part # & buy the part on amazon

Use your picture to remember what motor location your replacing

Sep 26, 2014 | 2002 Ford Taurus

1 Answer

Blows cold when first started and then blowes warm


I would replace the AC compressor cycling switch it may be sticking have seen it a number of times. The switch is located in the receiver dryer on the passenger side of the engine compartment. See picture below.


9_14_2012_7_34_09_pm.jpg
If this isn't the problem the AC compressor relay may also cause this, flip a coin.

Sep 13, 2012 | 1999 Ford Taurus

1 Answer

Location for ac relay on 97 ford taurus


Are you talking the ccrm? Those relays are soldered into the circuit board. Some of my ford info, says if the relays in the diagram have no terminal pin numbers, the relays are soldered into the circuit board, you can't pull it out. Sometimes It may be possible to use an external relay, wire it up properly and it should work.
If your talking about the ccrm/ constant control relay module, I'd probably just replace it, if that is the problem.
If your talking about a different relay then, I need more info?

ccrm-n3nk3f5j1gnnqecfgqcmbpzk-2-0.jpg

May 30, 2012 | Ford Taurus Cars & Trucks

1 Answer

2001 Ford taurus #22 fuse (A/C clutch relay PCM keep alive power fuse) blows. Replaced A/C clutch relay....still blows even with A/C off


Remember that when you THINK the AC's off,it's really not.Almost all cars have the AC compressor actuate every time you set the dial to `defrost' or `mix' positions.
On a TAURUS there are only two positions(maybe three)which DON'T kick the AC on.On some cars,that's the 11 o'clock and 2 o'clock positions on the selector.

SO...........the odds are that the compressor magnetic clutch or wiring to it has shorted.Because you really have power going there even when you think you don't. (:^) don-ohio

Oct 29, 2011 | 2001 Ford Taurus

1 Answer

Am trying to recharge the air conditioner on 2000 Ford Taurus and cannot locate the low service pressure port


I have 2000 Ford Taurus. The ac just stop working. I checked all the fuses and relay and all are ok. The clutch is not coming on. Please help Bob P

Jun 29, 2010 | 2000 Ford Taurus

1 Answer

Radiator cooling fan fuse location for Ford Taurus


The cooling fan on a ford car usually does not have a fuse. The cooling fans are controlled by a relay in the power distribution box inside the engine compartment. The box is usually located near the battery. Your owners manual should have a guide showing you what each relay in the box is for.

Jun 29, 2009 | 2001 Ford Taurus

1 Answer

Ford Taurus Heater won't switch over to AC


I guess first thing to find out is why compressor is not coming on, as without that running you won't get any cool air. May just need a recharge, but I would have that checked out first. If system is low on freon, it won't engage, and if it is low, why, as in where is leak & how much to fix it, would be my first concern.

Jun 28, 2009 | 1998 Ford Taurus

1 Answer

Diagram and to know what each fuse is for on a 2000 ford taurus


the diagram is on the lid of the box and in the owners manual if no manual try one online from www.edmonds.com

Mar 18, 2009 | 2000 Ford Taurus

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...