Also look under car to find plastic rivets along edges, or sometimes plastic lock buttons.
In most cars I've seen the screws under your wheel well. Pop your trunk and look where your bumper meets your trunk. There are usually plastic screws holding it in place. The ones that attach to your wheel well are steel.
SOURCE: Bumper cover removal
It is a little more complicated than that. There are two nuts below the headlight assemblies in the engine compartment. You will need to remove the battery and overflow bottle to get at the one on the passenger side. Remove the turn signals in the bumper, then there are 2 or 3 bolts holding a mounting bracket behind the each of the turn signals. There are a number of bolts with washer heads and reatiners on the underside of the bumper as the previous responder indicated.
SOURCE: REMOVAL OF REAR BUMPER COVER ON 1997 DODGE STRATUS
See under the bumper its strap with clips,you must take it out from it,
Testimonial: "I found out there are clips on each side of the b umper under the rear 1/4 panels as well. thanks"
SOURCE: need step by step instructions on how to remove a
Rear Bumper: Service and Repair
REAR BUMPER
Removal and Installation
REMOVAL
1. Remove the LH and RH rear combination lamps.
2. Remove both the rear wheels and tires.
3. Remove the LH and RH splash shields.
4. Remove the rear bumper fascia clips and screws, then remove the rear bumper fascia.
5. Remove the rear energy absorbing foam.
6. Remove the rear bumper reinforcement.
7. Remove the rear bumper supports.
INSTALLATION
Installation is in the reverse order of removal.
SOURCE: how to remove the front bumper cover on 2002
Remove all eight small set screws (4) on each side in the fender wheel wells. Then remove the four secure bolts on undercarriage of bumper (4). Take a screw driver. (flathead) to the upper portions of both the left and right side of the bumper. Be careful....... These are extremely fragile and you may need to replace them before replacing the bumper. Then comes a bit unnerving part. Removal of the bumper........ (This scarred the **** out of me!!!!) just grab ahold of one of the corners, then gradually pull! That's it. The clips will come out gradually and evenly.
292 views
Usually answered in minutes!
×