Question about 2002 Saturn Sl

1 Answer

Saturn sl 2002 crankshaft sensor where located on engine

Nothing

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Saturn Master
  • 1,243 Answers

crawl in between the engine and the firewall from underneath, it is by the starter.

Posted on Dec 10, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 141 Answers

SOURCE: location of ECT sensor

when you open the hood take your right hand and follow the upper rad hose down to the eng. when it stops thats the themostat housing the ect sensor is screwed into that housing there are two sensor one will have one wire and the other will have two you want the two wire one. be carful remove the conector the like to break good luck kdc744

Posted on Jan 08, 2009

motor1258
  • 6674 Answers

SOURCE: Cam Shaft Position Sensor 1998 Saturn SL

Have a look at this link, scroll to your engine & click on picture to expand for better view.

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528017e904

Posted on Jan 23, 2009

  • 39 Answers

SOURCE: I need to know where the crankshaft sensor on a

the crank sensor is on the back of the engine above/behind the starter Two wires green connector
The sensor should be located to the front of the engine block to the right of the oil filter. It's only held in by one bolt and is a quick replacement. You'll need to be under the vehicle for this and it would help to jack the car up a bit to better move about. Remember to use jack stands as a fall may not kill you but will smoosh you pretty good. Usual cause is not running or jerkyness if running or from a cold start it will run for a few minutes then cut off. Crank it all you want it won't turn on. When it finally does it will only run for a bit. I suggest prior to installing a new sensor (electric parts cannot be returned) when the car dies pull a spark plug. Ground the housing to the car and crank the engine. If you have spark your CPS is fine so start looking at fuel pumps! If you don't have spark do the irish jig because your fix is simple! Hope this helps.

Posted on Sep 11, 2009

  • 1114 Answers

SOURCE: Saturn SL-1 Cam position sensor problem

replace it before you end up spending more than you want to $$$$,regee

Posted on Dec 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where on engine can a crank shaft position sensor be located on a 2002 Saturn sl


I think this saturn is the same as the opel astra /zafiro if so then its front bottom right on the engine block in line with the crankshaft ,But no doubt iam wrong as never seen this saturn car here in spain

Dec 09, 2014 | 2002 Saturn Sl

1 Answer

2001 saturn sl2 will not start gets fuel and spark


Does the check engine light come on? if yes
Could be faulty crankshaft sensor

Dec 18, 2013 | 2002 Saturn Sl

1 Answer

OBD will not pass on saturn.It tells me I need a camshaft position sencer.My garage doesnt want to mess with it.Where is this item located and is it an easy replaced piece?


The 4 cylinder engine in your 1996 Saturn SL doesn't use a cam sensor. I know, then how could there be a code for the cam sensor? Well, The electronic ignition (EI) module supplies a signal to the PCM whenever it determines that the #4 cylinder fired on its compression stroke.

You should start by checking to make sure your spark plug wire terminals on the ignition coils are not corroded. Using a multimeter, check the resistance and continuity of each ignition wire. If your car is misfiring, replace your spark plug wires and have the code cleared at your local AutoZone or Advance Auto, unless you have a code scanner.

If the code comes back, most likely you have a bad crankshaft position sensor throwing the code. While the engine is running there should be a +5 volts on the crank sensor everytime the magnetic pickup reads the crankshaft. Using a multimeter you can check the voltage to see if the sensor is functioning properly.
This site may help:
http://www.saturnfans.com/forums/showthread.php?t=69687

Jul 03, 2011 | 1996 Saturn SL

1 Answer

97 SATURN IS STARTING BUT NOT CRANKING MECHANIC DID DIAGNOSTIC & SAYS I NEED A CRANKSHAFT SENSOR IS IT TRUE U CAN ONLY PURCHASE FROM DEALERSHIP


neicie neici, No, this is not true. You can purchase a crankshaft sensor from any auto parts store. Just provide for them the year, make, model and engine size of your vehicle and they can provide a sensor for you. If you ask, they may tell you where it is located on the engine making replacement easier for you. I don't know why the mechanic told you this. Good luck with this.

Jun 20, 2011 | 1997 Saturn SL

2 Answers

2002 Saturn SL1 will not start. Has spark, good battery and gas. Just had an oil, fuel and air filter change and cranks great. Any ideas?


What your telling us, doesn't indicate a problem

If you have air,fuel & spark,how were they tested ?

Mar 30, 2011 | 2002 Saturn Sl

2 Answers

I need to know where the crankshaft sensor on a 2002 Saturn SL is located


the crank sensor is on the back of the engine above/behind the starter Two wires green connector
The sensor should be located to the front of the engine block to the right of the oil filter. It's only held in by one bolt and is a quick replacement. You'll need to be under the vehicle for this and it would help to jack the car up a bit to better move about. Remember to use jack stands as a fall may not kill you but will smoosh you pretty good. Usual cause is not running or jerkyness if running or from a cold start it will run for a few minutes then cut off. Crank it all you want it won't turn on. When it finally does it will only run for a bit. I suggest prior to installing a new sensor (electric parts cannot be returned) when the car dies pull a spark plug. Ground the housing to the car and crank the engine. If you have spark your CPS is fine so start looking at fuel pumps! If you don't have spark do the irish jig because your fix is simple! Hope this helps.

Sep 11, 2009 | 2002 Saturn L-Series

1 Answer

Why won;t my 2002 l300 saturn start back up after driving


Sounds like a crankshaft position senso that is failing when hot. 

Aug 13, 2009 | 2002 Saturn Sl

1 Answer

Location of ECT sensor


when you open the hood take your right hand and follow the upper rad hose down to the eng. when it stops thats the themostat housing the ect sensor is screwed into that housing there are two sensor one will have one wire and the other will have two you want the two wire one. be carful remove the conector the like to break good luck kdc744

Jan 08, 2009 | 2002 Saturn Sl

Not finding what you are looking for?
Cars & Trucks Logo

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...