Question about Cars & Trucks

1 Answer

How do you find a grounding wire that blows fuses?

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 755 Answers

It is not the grounding wire , what is happing is that the hot wire is grounding out on a ground , you have it backwards , what fuse is blowing , start there ,

Posted on Dec 10, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Eec engine fuse blowing. is the red injector wires supposed to be reading an engine ground in a continuity test with multimeter?


red wires are normally hot or power wires and if going to ground then that is a short that will blow fuses

Jun 07, 2015 | Cars & Trucks

2 Answers

Blown starter fuse


Check the starter solenoid for a short to ground.

May 20, 2014 | 1996 Mitsubishi Galant

1 Answer

Headlight keeps blowing


hi,

use the process of elimination, disconnect both headlights at the bulb and put another fuse in it and see if it blows. if the fuse blows without the headlights plugged in then its the wiring to the bulbs. if the fuse doesn't blow while the headlights aren't plugged in try plugging the lights in one at a time to see which headlight or socket is shorted. possibly corrosion at body to ground connections near the headlights, you may not see the corrosion, remove the ground wires and sand those ground wires down..

Oct 11, 2013 | 1993 Ford Taurus

1 Answer

Blowing starter fuse


check ignition wires to starter relay and check electrical wires to starter see if wires shorting out to ground see if any wires exposed or look burned touching engine or body shorting to ground that will cause fuse to blow.

Jan 03, 2012 | 1999 Dodge Stratus

1 Answer

What would cause the number 9 maxi fuse to blow?


The first time this fuse blows you could assume that heat and age were the culprit. If it is replaced and blows a second time you will need to check for an improper ground (broken wire or loose ground wire or bad connector) at each device powered by the fuse.

Aug 03, 2010 | 1995 Ford F250

2 Answers

I have a1994 gmc Sonoma. Fuel pump fuse keeps blowing. Dealer said it was fuel pump. I replaced it and it still will not hold a ffuse. I disconnected the fuel pump wiring harness and it still blows a...


Somewhere you have a ground fault in the wiring system. Sometimes if the O-ring on the fuel pump assembly is bad it allows a improper ground. Be sure to also check the fuse box wiring to assure that all grounds are tight. Some fuse boxes have multiple grounds.

May 18, 2010 | 1994 GMC Sonoma

1 Answer

On my 1972 duster,when i blow the horn,the fuse blows and the tail lights go out also. the same fuse runs both.what could be the problem?


This sounds like the horn may have a short in it somewhere. Does the horn blow at all? Try this: Make sure you have a good fuse installed to this circuit again. Disconnect the horn and place a volt/ohm meter set to DC volts on the horn connections. If there is just 1 wire going to the horn, put that wire on the red wire of the meter. Put the black wire of the meter to a good ground, preferably the negative battery terminal. Now press the horn and see if there is a reading of around 12 Volts. If so, replace the horn. If not, and the fuse blows again, check the wiring for a fray/short to ground. When you're looking at the horn of course, make sure the positive lead isn't shorting to ground as well.

I hope this helps! Let me know if you need any more assistance! :)

-Jason

Feb 11, 2010 | 1983 Plymouth Gran Fury

3 Answers

Reverse lights fuse blew


hi
check the wire because if the fuse keep blowing there's a wire somewhere on the car that has contact with the frame so everytime you put your car on reverse the 12V wire shortcut on the frame so the fuse blow check all your positive wire and your bulb as well
Good luck

Jun 19, 2009 | 1997 Ford Explorer AWD

1 Answer

Blows fuel pump fuse


The most common thing when a fuse blows is a short to ground condition. A short to ground is basically a wire that is being grounded in the wrong place. If the wire has a any open spots touching metal it is grounding out in the wrong spot. Seeing that it is blowing fuel pump fuses, your problem is in the fuel pump circuit. Check the wires running along the floor board on the driver side. You will have to use a wiring diagram to know what wire exactly. You will have to remove the tape around the wires to get to the wires. Look for breaks or exposed portions and repair correctly.(a saudering gun) I have the same problem right now and have started to look for the short. Is your alternator bad?(making loud growling noises)

Jul 25, 2008 | 1995 Plymouth Neon

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...