Question about 1995 GMC Yukon

1 Answer

What are some of the reasons a 1995 gmc yukon wont start back up right away.

It starts, but once you cut the engine off it doesnt start back up right away. it takes awhile to start again. The engine has been rebuilt, a new throttle put in, a new battery put in.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 1,420 Answers

Jessica, Are you saying it will not crank over or cranks over - engine will not run?

Master Tech Lee

Posted on Dec 09, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 231 Answers

SOURCE: 89 GMC Sierra problem

there is an ignition module located rite beside the distributor cap on the distributor base these are well known for getting weak and heating up thus causing your engine to stall.

Posted on Oct 15, 2008

emissionwiz
  • 75051 Answers

SOURCE: cuts out when accelerating

Did you change the fuel filter? also did you clean the inside of the MAF sensor w/ MAF spray cleaner?

Posted on Oct 29, 2008

fastboyz
  • 674 Answers

SOURCE: 1997 Gmc Yukon wont start

when you say it wont start will the engine turn over?
if it wont turn over i think you should check your battery connections
if the engine turns over then you need to check your fuel pressure and spark and let me lknow

Posted on Jan 02, 2009

  • 580 Answers

SOURCE: 1999 gmc yukon gas gauge is slightly flickering

The sending unit in your tank is bad replace it.

Posted on Jul 10, 2009

  • 11 Answers

SOURCE: 1997 GMC Yukon won't start.

WHEN YOU REPLACED THE FP DID YOU OR THE DEALIERSHIP REPLACE THE FUEL FILTER MAYBE YOUR PROBLEM ....

Posted on Dec 09, 2009

Testimonial: "They did replace the filter but thank you very much for the tip."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I got a 1999 gmc yukon. The transmission is hanging up in third gear and wont downshift. What could be wrong with it. It has two new selinoids in it...


VSS,On the transmission at the tail shaft is the vehicle speed sensor this sensor tends to get contaminated and give wrond sppe signal and thus wrong gear engaement

Nov 05, 2012 | 1999 GMC Yukon

1 Answer

My 2005 Yukon xl doesn't start right away in the


did you tune it up after 100,000 miles check fuel filter and also inspect all vacum hoses

Mar 26, 2012 | 2005 GMC Yukon Xl Denali

1 Answer

2003 yukon cut off but start right back up


sometimes the idle is low or the engine still cold or possible low charging system.clean your spark plug make sure 30 thousand miles...or every 25 to 30 thou to change.

Apr 04, 2011 | 2003 GMC Yukon

1 Answer

2001 gmc yukon xl was jerking, cut off. will not start.


it sounds like the fuel pump might have died, or blew fuse or relay see if it gets fuel at the motor

Feb 12, 2010 | 2002 GMC Yukon XL

3 Answers

99 yukon 180,000 mi. doesn't start. cranks forever, but won't start. Should I be able to hear the fuel pump when I turn on the key?


yes you should be able to hear the fuel pump run for about 5 seconds once the key is turned to the on pos. check to make sure you have spark. if you do try having someone spray air intake or carb cleaner into intake manifold while you crank. If the truck starts right up for a second (or stays running as you keep spraying) Id say you have a bad fuel pump and id change the sending unit also. (First check the fuel pump fuse and fuel pump relay) GMC and Chevy are nororiously known for having bad fuel pump/sending unit problems. I have prob changed over 60 myself.

Nov 30, 2009 | 1999 GMC Yukon

1 Answer

How do you change a blower motor


FOR THE YUKON FAMILY THE BLOWER MOTER IS ON THE RIGHT SIDE OF THE CAB PULL BACK THE PLASTIC COVER OR CUT IT OFF REMOVE THE 3 OR 4 SCREWS THAT HOLD IT IN PLACE CUT THE WIRE TO IT AND THEN REMOVE IT THE NEW BLOWER WILL HAVE TO BE WIRE TO THE WIRE THAT YOU CUT AND THEN SCREW THE BOLTS BACK AND YOU ARE DONE .........

Oct 01, 2009 | 1995 GMC Yukon

1 Answer

Washed engine on 96 yukon now wont run will start but cuts out really bad will die not drivable replaced distributor


pull the distributor cap and spray some WD-40 in it and put it back on and try it (sounds like water inside)

Apr 13, 2009 | 1996 GMC Yukon

1 Answer

1999 gmc yukon gas gauge is slightly flickering


The sending unit in your tank is bad replace it.

Nov 19, 2008 | 1999 GMC Yukon

2 Answers

Cuts out when accelerating


Did you change the fuel filter? also did you clean the inside of the MAF sensor w/ MAF spray cleaner?

Oct 29, 2008 | 1995 GMC Yukon

Not finding what you are looking for?
1995 GMC Yukon Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...