Question about 1994 Toyota Pickup
Looked at the wiring
Battery is dead (discharge)
the engine will not run with low battery,
cause by 3 things.
1: bad battery
2: bad change system.
3: phantom drains.
a volt meter for $7.88 at walfart solves this riddle, ask
Posted on Dec 22, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Have you pulled out the spark plugs to see if there are any tell tale signs on them.They are a good indicator of many problems that occur and can save a lot of time isolating the problem.They should all be the same colour.Is the air box and lid properly secured with no leaks or splits in the intake tube.Have you put injector cleaner in the fuel tank to clear up any possible dirty injectors.Therse a few things your problem could be including engine vacuum leak which you can find by lightly spraying carburettor cleaner around suspect places such as inlet manifold and around injector seals.
Posted on Oct 24, 2008
I just worked on this problem a couple of days ago. If the motor is a 3.0 liter. The idle control valve is located at the bottom of the throttlebody assembly right below the bore for the throttle butterflies..What usually causes this valve to go bad is the mechanical part of the sensor sticks as it becomes sludged or carboned up. Manufacturer claims that the valve cannot be cleaned and should only be replaced....It's a high dollar repair to replace this sensor as your engine coolant flows through this electrical valve. The valve idles the car fast when cold, as the antifreeze gets hot the valve drops the idle down.....I have successfully cleaned several of these valves and cured the dying problems...
First remove the air filter top cover and the tubes that connect to the throttlebody. In the right throttlebody you will see a port right before the butterfly. Under the throttlebody you have a black plastic sensor with a 2 wire terminal. Remove the 2 phillps screws and pull off the electrical part of the valve. you will feel a magnetic pull while removing. Remove slowly and catch the black sealing oring, and there will be a metal washer also.. The shaft that is exposed is the mechanical control of the valve. Rotate the shaft and it should feel sticky if bad..Using a throttlebody spray cleaner spray into the small square port of the right bore, rotate shaft and spray until stickfree.....Reassemble
Posted on Apr 05, 2009
i guess it has carbs on that year, which means
1.your main jet is blocked or
2. fuel filter is clogged,
3. fuel pump worn out
4.blocked fuel line
you simply have just enough gas to idle but when you demand more there just is not enough,
Posted on Dec 05, 2009
Tips for a great answer:
May 23, 2013 | Toyota Cars & Trucks
a hot start issue.
be related to low fuel pressure or problem with crank sensor.
it can be weak battery or starter.
possibilities are to be inspected to confirm what exactly it is.------
troubleshoot and confirm the issue,i suggest you refer few solved help links
with similar types of problem like yours:------
the link below:------
details will help.
Nov 28, 2012 | 2003 Mitsubishi Galant
Apr 01, 2010 | 1994 Ford Mustang
Dec 15, 2009 | 1994 GMC Suburban
Sep 09, 2009 | 1994 Pontiac Grand Am
Jul 17, 2009 | 1988 Dodge Shadow
Jul 06, 2009 | 1994 Toyota Pickup
Oct 12, 2008 | 1991 Toyota Camry
100 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: