Question about Cars & Trucks
There are a lot of wires to these remotes. Under the dash, drivers side. In these wiring harnesses are a couple of fuses. And a couple of relays. Check the fuses. Relays also. Relays don't usually go bad though. If all is good, your receiver has probably died, since the fob is still working. Before you replace the system, have the fob checked. Make sure it is sending a signal. Just a note... If you decide not to replace the remote. I recommend you take it out of the car. In my experience, when remotes start acting up, they also interfere with the BCM. Meaning today your car won't start with the remote, tomorrow it won't start at all. security issues. All from the remote.
Posted on Dec 09, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: I had a Titan Remote
Yes, change the battery in the hand held unit first.
Next could be the control unit.
Next could be that there is something brocasting in the area that is near the same frequency.
Does this only happen at home? Or has it happened in other areas also?
Is this a factory unit? Or an aftermarket install?
Posted on Sep 06, 2008
sounds like the starter is not engaging the flywheel if the starter make noise like a power saw and the engine is not cranking may be the starter solenoid is not working I have seen this happen whit brand new starters now before you change your starter again ask some one to turn the key for you and see if the crankshaft or any otter pulley is rotating. if noting turn then replace the starter again and ask them to tested for you at the store and see if the gear comes out like it shut. If you see the crankshaft and pulleys rotating but the engine wont start you have otter problem if the engine hardly turn whit a fully charge battery or jump start from another car take all spark plugs off and tray again whit out the spark plugs if coolant comes out of the engine you have a floated cylinder and a blown head gasket. Note may be a good idea to change your battery clamps wile you are at it or at leas clean then using a wire brush bad contact on battery clamps causes to lose power doing start. hope can help you good luck. :)
Posted on Jun 10, 2009
Tips for a great answer:
Dec 04, 2015 | 2012 Kia Sorento Base 4dr SUV 2.4L 4-cyl....
Feb 23, 2015 | 2009 Toyota Highlander Hybrid
Nov 11, 2012 | Cars & Trucks
Jul 31, 2012 | Jeep Cars & Trucks
Apr 14, 2017 | 2005 Chevrolet Aveo Sedan
Oct 01, 2017 | 1999 Jeep Grand Cherokee
Jun 11, 2017 | Nissan Altima Cars & Trucks
Feb 25, 2009 | 1998 Honda Civic
327 people viewed this question
Usually answered in minutes!