- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
If the pump runs then the nozzles are blocked. Use a pin or needle to clear the blockage from the nozzle.(Stick it in the little hole pointed at the windscreen.) Be careful not to break the pin off in the nozzle. See if you are able to pull the pipes off from the underside of the nozzles. Clear the nozzle using the pin. Then point the pipe into the underside of the nozzle and activate the washer in order to rinse the nozzle.
If you can hear the washer motor running when you operate it then the fault is most likely caused by a small filter for the washer pump inside the bottle that blocks up.
You will need to remove the washer bottle and clean out the filter.
Possible blockage in line or at the nozzle ends. There is a small screen that keeps debris from entering the lines but can get clogged. The screen is plastic and is inside the reservoir at the bottom between the pump and the outlet hose. Remove and clean the screen as needed. If the problem persists there is most likely a clog in the line. Slightly higher pressurized air (more than the washer pump can produce) could clear the clog. Be sure to check the nozzles for blockage too. Good luck to you
Take off the pipe at the pump then use the washer switch and see if the water sprays out. To check if the pump is working you will need someone to use the switch while you hold your hand on the pump you should feel or hear the pump working. If the pump is going but no water spraying blow back through it and try again. If it dosent work then you will probably need a pump.
The washer pipe comming from the tank to the jets is probably folding over of touching something between the bonnet and the check the pipe is in place where it folds with the going up and down
It sounds as if there is a blockage either in the base of the screenwash reservoir or the feed pipe from the reservoir. You could remove the screenwash reservoir tank and clean it out and at the same time check the pipe.
×