How to fix the cigarette lighter ?

Between the two cup holders is a 12v lighter socket.

Using a 12v lighter socket to usb will solve your problems

https://www.ebay.co.uk/p/?iid=262676908405&&&adgroupid=44594567914&rlsatarget=pla-298926473889&abcId=1088856&adtype=pla&merchantid=115148351&poi=&googleloc=9045169&device=c&campaignid=805978797&crdt=0&chn=ps

Nowhere near enough information for me to figure out what you've done and what you need help with...

some of them dont have lighters in them. you have to insert your own.

There is another fuse wire in connecting side of holder itself. it is "C" like wire 3 to 4 mm length. Just behind the fuse holder.

Not really but i would check the bulb holders first ,rear light make sure its the right bulb ,look inside the bulb holder at the contacts ,one or two ?? check it out you would be surprised how many people fit the wrong bulb ,then if ok check the front light its a c?pless bulb and again the tiny contacts get bent and short it out .

I had this problem as well. Start by removing the small plastic plate by the emergency brake (Pull the brake up). It just pops off, Then remove the left side of the middle console that includes the cup holders and ash tray. It will loosen and you will have to manuever it to take it completely out - turn it sidways to get it out from the shifter, You will need to do this to get to the two screws holding in the front panel where the cigarette lighter is at. Using a phillips screw driver, unscrew the two screws at the very botton of the panel near where it would meet the center console. These screws are hard to get to but can be done. Once you have removed the screws, starting at the bottom, begin to remove the panel slowly as the wiring will still be attached. Unclip the emergency blinked power clip. The cigarette will have two plus that will clip off. The wiring will still be harnessed to the panel, By using a flat screw driver, you can push in the plug clips from the opposite side and the wiring plug will come out. Now you have the panel completely out. Position the cigarette holder in, the metal clip with the little handle goes to the rioght hand side in between the two plastic plugs.holding this all together, there should be a metal ring that will screw back in to hold the cigarette holder in place. once this is secure, plug in the three wiring clips and then plug in the wiring harness once you have the panel positioned to put this back in. once your wiring is back in re-mount the panel and put the two screws back in. Put in the center console molding and then put in the small molding by the parking brake.

I am a woman with no mechanical experience , so goes to show you that this is possible. Time it took me to repair - 30 mins including figuring out the panel screws etc.

It is right behind the cigarette lighter itself.

You need to get at the back of the socket (female part) to unthread the nut that holds it in. These are sold at any auto parts store, and are kind of common. Replace the socket and element both.

They hyundai service manual says the following.

(1) After removing the ashtray remove the facia panel mounting screws
(2) Then disconnect the connector from cigarette lighter
(3) Disconnect thermal fuse case from socket end
(4) Remove the ring nut and separate cigarette lighter socket from the thermal protector.

I hope this helps. I have never had to replace one (yet) so I can't give exact directions. Even if the fuse looks good you may want to replace it and see if that fixes it first. Sometimes they have miniscule hairline cracks that are hard to see. Hope this helps

yes, its under the dash on the drivers side near the hood release.