Question about 2006 Buick Lucerne
I believe it has no dipstick, just a transmission check plug. This should be checked by a trained professional because it involves jacking the car up (making sure it's perfectly level) and removing the transmission check plug. If the fluid is dripping, it's full. If it doesn't, you add fluid through the top red cap until it starts dripping and reinstall plug.
Posted on Dec 10, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
The washer pump is located on the bottom of the wash fluid bootle. you can access it by removing the front passanger fender liner..
Posted on Jan 12, 2010
Battery life is a very complicated issue, there are TONS of factors. High temperature kills batteries, if the fluid goes low, that kills batteries. If you forget and leave lights on, and the battery goes totally dead, (totally dead, zippo, not anything) that kills batteries.
Alternator diodes that fail kills batteries. So 4 to 8 years is typical life IN ABSENCE of the above types of issues. My favorite battery is Interstate. They just work really well. Costco has great battery prices, bumpy for service... Really Dislike Sears die easy.
Posted on Oct 19, 2010
Hi Dear Lov, Remove the plugs from the arm rest and behind them there will be deep seated screws. Push in a long screw driver and remove them. Next lift the window control buttons and when removed from the housings disconnect the electrics. (Keep the switches handy) next take a flat blade tool and starting at the bottom of the door, insert the blade between the panel and the door and gently pull the blade towards you. When the studs pop move to the next until all are released. Lift the panel off and then refit the switch to the cables. Reach inside the door and feel for the operating rods which extend from the handle to the latch mechanism. at each end you will feel plastic clips which will rotate away from the rods when pushed in the same plain. These clips beak easily so be careful. It is worth getting a mirror and flash light and studying them before trying to release them. Check both sides as the mechanism may be different at each end. Once disconnected you will notice two hole opposite the exterior door handle, through which a socket spanner fitted to an extension will fit. Remove the nuts and then remove the handle from the outside. When fitting everything back together make sure the rods are correctly fitted. You may find you need to lift or lower the window, or maybe remove it completely to do the job. Regards John
Posted on Feb 11, 2012
Testimonial: "Thanks johngee"
SOURCE: 2006 buick lucerne back doors
My friend just had this problem and he reached in and pulled the inside door handle back as far as it would go, and then let it go, allowing it to 'snap' back. For some reason this fixed it. We have no idea why. By doing this on one door, both rear door locks freed up and the rear locks are now working. Before, both rear locks were stuck and you could not open the doors from the inside nor the outside. Not sure why it works, but maybe it will work for you!
Posted on Apr 01, 2012
Tips for a great answer:
Oct 30, 2016 | 2010 Buick Lucerne
Aug 21, 2015 | 2006 Buick Lucerne
Feb 28, 2015 | 2006 Buick Lucerne
Feb 28, 2015 | 2006 Buick Lucerne
Jun 14, 2014 | 2006 Buick Lucerne
Jan 15, 2014 | 2006 Buick Lucerne
Jan 17, 2012 | 2006 Buick Lucerne
Jun 15, 2011 | 2006 Buick Lucerne
127 people viewed this question
Usually answered in minutes!