Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2005 Buick Allure heat problem
well if u changed thermosta did u noticed if both were same & had little hole on top of the old 1 lot of times aftermarket dont have them & u need to drill 1 urself same spot....or could b heater core going out
Posted on Dec 18, 2008
Open hood, look on top of head light assm, you will see a bolt or screw, these hold assm in. remove, and pull out assm. Turn lock collar, remove old bulb, install new, BUT DO NOT TOUCH GLASS END OF BULB WITH YOU HAND, the oil from your skin will make the bulb explode when it is heated.
Posted on Feb 04, 2010
Buick Lacrosse - The bright light fitting is the same as the dim so take it apart first to see how the cover screws off/on and the light comes out. Both the cover and the bulb are removed by a standard twist to the counterclockwise and replaced by a twist to the clockwise. Now to the dim light. You have to release the entire light assembly before you can remove the screw-on cover to reach the light. On the rear edge of the light unit closest to the engine is a white locking tab. Pull that tab up just to the point where it releases…pull too far and it locks again. Next, locate the other locking bracket which is a metal bracket in the center-rear of the light assembly. This bracket is held down by a screw. Remove the screw with a 10mm wrench. Lift the bracket just like you did the white bracket. You should now be able to pull (or pry) the entire light unit forward a little. Depending on the size of your hands this might be enough. If not, then you need to release the plastic bumper assembly to give you a little more space. This is done by removing two expansion locking pins, one that holds the little plastic strip down between the bright and dim lights and one that is located inside a rubber bumper on the engine side of the light unit. To remove these locking pins, pull or pry up the little tab in the center of the pin just like you were pulling a nail by the head. That should give you more space.
Posted on Apr 03, 2010
Tips for a great answer:
Sep 16, 2014 | Cars & Trucks
Mar 30, 2013 | Cars & Trucks
Nov 11, 2012 | Buick LaCrosse Cars & Trucks
Oct 17, 2012 | Buick Lucerne Cars & Trucks
Sep 27, 2012 | Cars & Trucks
Jul 29, 2011 | Buick LaCrosse Cars & Trucks
Feb 15, 2010 | 2006 Buick Lucerne
Feb 04, 2010 | 2005 Buick LaCrosse
Jan 05, 2009 | 2003 Buick LeSabre
Nov 10, 2008 | Buick Lucerne Cars & Trucks
13 people viewed this question
Usually answered in minutes!