Question about Cars & Trucks

1 Answer

I have a 99 Chrysler the will not start. Pit in new Battery and replaced the starter. Starter engages but but will not turn over. Any thoughts.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Habit-Forming:

    Visited the website for 3 consecutive days.

    New Friend:

    An expert that has 1 follower.

  • Cars & Trucks Expert
  • 176 Answers

Are ground and battery cable good?

Is the engine can be turn by hand?

Posted on Dec 06, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 200 Answers

SOURCE: car will not start

Recheck the battery, the starter doesn't care if your battery gives 12 volts, it needs CCA (Cold Cranking Amps),  Autozone will test this for free where I live, most likely where you live too.

Posted on Oct 25, 2008

alicantecoli
  • 22219 Answers

SOURCE: starter runs but won't engage flywheel

engine crank thrusts worn and crank moved back enough to not engage ,with a manual the clutch would push it forewards.or the flex plate on the back of the torque converter damaged and broke in teh centre where bolts to the crank

Posted on Dec 27, 2008

  • 1596 Answers

SOURCE: 1998 buick lesabre wont start

Do you have a Chip in the Key? if so that Could be the Problem,Ya see the chip is a resistor and if it looses its ELECTRONIC VALUE in its Case Resistance it wont start to test this Turn the Key in the ON posission then do the Screwdriver thing If it Starts Key is Good and Most Likely the Ignition (SWITCH) is Bad <<ELECTRICAL Side NOY LOCKEST SIDE For More Info Recontact Me
rejakwilson@aol.com<<<<<<<<<<<<<<<

Posted on Jan 21, 2009

  • 36 Answers

SOURCE: 99 kia sportage starter

if knocking on the starter makes it work everytime then it might need a shim installed between the starter and the block to hold it in a slightly different position to keep the drive gear from wedging into the flywheel

Posted on Feb 13, 2009

  • 8 Answers

SOURCE: 99 vw passat won't always start

That would be your Ignition switch my friend, happens to most the vw's within their 200k mile life span. if you turn the key and it doesn't start, try (as you have the key engaged to start the engine) lightly leaning the key up, down, left, right, sideways, which ever way possible, or even pushing the key its self into the ignition as far as it will go, if its the ignition switch, the car will most likely start. Now, for saftey reasons i will tell you not to drive the car once you do get it started, for the only problem i had with doing that was as i was driving down the road, the started engaged when ever i would push the clutch in, so i had to resort to "speed shifting", and something like that could lead to an accident. if you bring it to a local repair shop it shouldnt cost you more the $100 to fix.

Posted on Mar 29, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 saturn sl1 replaced new starter car wont start no crank battery is good new spark plugs aand boots. Car still no start no crank has dash lights and dings


You still have a problem with your starter. Sounds like you missed the wires going to the solenoid which engages the bendix.
Recheck the wiring.
It could also be a bad starter from the parts store. Won't be the first time.
See if this helps -


Saturn SL SC SW Starter Replacement

Sep 21, 2017 | Saturn Cars & Trucks

1 Answer

Problem with 1999 Chrysler 300M My Chrysler 300m


If the engine doesn't turn over, it may be the solenoid not operating and not engaging the dog on the starter motor, if you get a healthy clunk when you turn the key but the engine does not turn, could be seized or there could be a transmission lock issue.

Oct 28, 2013 | Cars & Trucks

4 Answers

My van will not turn over,i thought it was the starter cause it wasnt starting it will turn over but not start.so i put a new battery in it cause i was told the old one wasnt kicking out enough amps.and it...


If the starter motor spins and does not engage, thump the case of the starter motor with a piece of 4 x 2 or a lump hammer handle. If that fixes it, the fix will be temporary. Take the motor off and lubricate the bearings, paying attention to the dog wheel slider.

Oct 01, 2017 | 1992 GMC Safari

1 Answer

1998 Chrysler Concorde 3.2L Intermittent starting problem. Can hear the starter solenoid kick but will not turn over. The starter, battery and cables have been replaced. After replacing the battery today...


Thoroughly check the battery to chassis to engine ground system is properly connected and in good order.
Check/replace any solenoid control relay if fitted -(slave relay interfacing between ignition start sw and starter motor engage solenoid).
Check condition and connections of any fusible link (or in line Maxifuse).

Oct 19, 2009 | 1998 Chrysler Concorde

2 Answers

Chrysler 2004 starter doesn,t turn ,battery has 12.7 volts lights and horn works good but starter doesn't even click


My 2004 Sebring did just that. it was a fusible link. a tiny square box in there with the fuses. they are a cube that plugs in about 3/8" of an inch square. Find the bad one replace it and the starter starts working again.

Sep 08, 2009 | 2004 Chrysler Sebring

1 Answer

2001 Sebring convertable, 3.3L, Turn the key


you have a crossed wire thats blowing the fuse. Check all wires to the starter also to the fuse box and to the battery

Sep 01, 2009 | 1998 Chrysler Sebring

1 Answer

Have a 99 sebring just changed battery and car wonk crank


Hi I am Vortash when you turn the key is there a sound from the engine a clicking noise this would be the pre engaged starter motor solenoid trying to engage if you do then the starter motor may be jammed or faulty or possibly has a bad earth check all your body earthing straps .. ( the lights would work as they dont take much drain but the amperage of the starter motor wouldnt ) .
If after checking the earths you dont hear this then I would suspect that the ignition switch is at fault and the starter motor contacts in the switch have burned out or the starter relay hope this is of help regards vortash

Jul 22, 2009 | 1999 Chrysler Sebring

2 Answers

99 kia sportage starter


Theres a solenoid on the starter to engage the starter onto the flywheel. The solenoid could be going out.

-Captain Jake

Feb 13, 2009 | 1999 Kia Sportage

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...