Question about 2000 Nissan Maxima

1 Answer

2000 NISSAN MAXIMA WONT STAY ON..KEEPS TURNING OFF

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 59 Answers

Need more info but it could be its not getting fuel or a sensor see if you can get someone to use an obd 11 on it it plugs into your car and will read the codes they sell them at any autoparts store prices vary depending on how much you want it to read but you can get the codes and then look them up on the computter the obd11 plugs in just below the steering wheel be carful when you plug in as to not bend the teeth on the obd11

Posted on Dec 05, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
pal03246
  • 726 Answers

SOURCE: FILLING UP THE FREON IN MY 2000 NISSAN MAXIMA SE

2000 maxima is filled with R134, not freon. You don't need retro fit kit. Get couple of cans of R134 and pump it into the low side valve /small fiting, while A/C compressor is engaged. If your compressor is not coming on, jump the low side pressure switch to make the compressor come on and than the R134 will get sucked in to your system through the low side line. The proper way to do this is to put a/c system under vaccum for 15 minutes at least and watch for leak/gauges coming/loosing vaccum. Than pump R134 into the HIGH side valve with engine OFF.

Posted on Jul 17, 2008

pal03246
  • 726 Answers

SOURCE: starter 2000 maxima se

Firts disconnect battery. Remoce air filter box. You will see the starter right under neith the air box. You will see a rubber bute. Under the boot is a 12mm wrench size nut. Remove nut. There is a single wire connector. Unplug connector. There are 2 bolts holding the starter to the trans. One of them is pretty big.(19mm socket size ?) and the other is smaller. Remove them both and the starter will come out. Reverse install procedure. Good luck

Posted on Jul 19, 2008

pal03246
  • 726 Answers

SOURCE: Need to locate oil filter in my 2000 Nissan Maxima GLE

Filter is next to the right tire (pass.side) behind a splash shield.

Posted on Jul 19, 2008

  • 82 Answers

SOURCE: AC blower motor resistor Nissan Maxima 2000

yeh its located under the passenger side glove box,its in the heater box beside the heater motor ,,2 scews hold it in and it looks like a credit card when its out,,,,

Posted on Apr 19, 2009

  • 31 Answers

SOURCE: TCS SLIP KEEPS COMING ON ON A NISSAN MAXIMA JUST

this could be a damaged sensor issue, return the vehicle where you had it serviced with your complaint.

Posted on Sep 30, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2000 Nissan Maxima car ran fine till battery was disconnected for several weeks after reconnecting battery car fails to stay started wont idle also clock dosnt work now


I suspect you will need to take the car to Nissan service to reset the ECU. Tell them the problem and let them advise you what they will need to do.

Dec 16, 2015 | Nissan Cars & Trucks

1 Answer

Nissan Maxima cooling fans stay on 2000 Maxima GLE The wont cycle off after the engine temp is cooled down, I replaced the Rad.tstat,sensor,relays& pulled the water pump to make sure is it my?


did this just happen ?? Out of the blue ??,,,, sounds as if it is hard wired ,,,,look for any jumper wires attached to the plug on your fan

Apr 24, 2015 | 2000 Nissan Maxima

1 Answer

2000 Nissan Maxima Stalls out


Check engine light on ?
Could be one of the sensors such as the mass air flow or tps.

Feb 19, 2014 | Cars & Trucks

1 Answer

My 2000 Nissan maxima wont rev above 2RMP.


Have you inspected the catalytic converter for blockage? The other issue could be fuel pressure...the fuel regulator could be defective. Hope this helps.

Jun 12, 2012 | 2000 Nissan Maxima

1 Answer

Evap control malfunction& acceleration not ok after heavy traffic


Is a black cannister with vaccum hoses usually small size in front of engine by the grill. The cannister acts as a recycle unit for your gasoline fumes. Try uncapping your gas cap once to depressurelize the tank. you may nee a new gas cap?

Jun 29, 2010 | 2000 Nissan Maxima

2 Answers

My nissan maxima wont start


Starting motor is a likely culprit.

Jul 04, 2009 | 2000 Nissan Maxima

1 Answer

2000 Nissan Maxima will not start


BAD STARTER.... need to be replaced. Good Luck

Jan 02, 2009 | 2000 Nissan Maxima

2 Answers

2000 maxima won't stay started on a cold morning


Have the plastic intake manifold and gasket replaced. I have posted this fixed at least once before and have seen it numerous times.

Nov 23, 2008 | 2000 Nissan Maxima

Not finding what you are looking for?
2000 Nissan Maxima Logo

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...