Question about 2004 Chevrolet Malibu

1 Answer

Where is the turn signal relay on a 2004 Malibu lt, and do you know what would cause the front turn signal lites to work then not work then work then not work?

Put dielectric grease on all connections on all three fuse boxes, (under hood center console in trunk)I even replaced both headlight assemblies, did no good.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chevrolet Master
  • 14,585 Answers

There isn't one. Since you already did the fuses. If your up to it. Take the turn signal switch out. Take it apart and fix it, the inside of it.. You need a soldering gun and solder. There is only one thing that may op out. The horn spring. Plus the button for the horn will drop,out. Just look at the contacts and solder them up( divots have to be filled in). Plastic will melt. just watch. it works. Fixed a lot of them. You can do it...You already passed the first step..

Posted on Dec 05, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi there, I have a 2005 Chevy Malibu 3.5L engine with an error code B3948. Does anyone know how to resolve this? Thanks!


See if the signal flashes, buy a new bulb. Some Chevy no longer use a flasher relay, the signal comes from the body computer.

B3935Transponder Authentication Error
B3948Left Front Turn Signal Circuit
B3949Right Front Turn Signal Circuit
B3950Left Rear Turn Signal Circuit

List of Diagnostic Trouble Codes for 2008 2010 HHR Chevy HHR Network

Dec 01, 2016 | 2005 Chevrolet Malibu

1 Answer

Where are the turn signal flashers located in a 2004 Chevy Malibu Maxx LT ?


check the bulbs when you get rapid flash normally 1 pf the bulbs are out

Jul 06, 2013 | 2004 Chevrolet Chevrolet Malibu MAXX LT

2 Answers

2004 Chevy Malibu, both front turn signals are not working. Rear turn signals are fine. Hazards will work in the rear also, but not the front. I replaced the hazard switch in the dash and the problem...


replace both bulbs,, on the chevy they use the new bulbs with the very thin wire that goes into the socket, they have been having problems with the plastic in the socket getting hot and being partially covered, which makes the connection no good,, try this, with a small, screwdriver or if you have one a small pick tool, gently pry the wire outward from the socket,, Just a very little will do the trick,, then put the bulb in the socket, you should be fine after that ,, if the rear lights are working, then nothing is wrong with the signal switch, since they are on the same circuit. your hazard switch you replaced was probably ok also. if this doesn't work, do the same thing on the bulbs,, to insure a good contact

Sep 10, 2011 | 2004 Chevrolet Malibu

1 Answer

Malibu 2006 LT. The Left Front and Right Tail Turn Signal Lamps don't blink, the light just stay on but not blinking, check bulb ok. What could be the problem here? Thanks.


The other turn signal bulbs are blown, or the turn signal unit itself is bad. it is under the dashboard and makes the ticking noise when the turn signal is on.

Oct 09, 2010 | 2006 Chevrolet Malibu

1 Answer

Horn on my 2004 Chevrolet Malibu won't work. Fuse is good and relay is working properly. Where is the actual horn?


If its like my 99 Chevy Lumina, its behind the front bumper, passenger side. You'll have to take the whole front bumper off. Stupid I know. But thats how Chevy made them.

Aug 19, 2010 | 2004 Chevrolet Malibu

1 Answer

2004 Chevy Malibu driver's side turn signal doesn't work


resistance from the bulbs activate the flasher, so if a light is out it won't flash, could be a ground or an open circuit, time to check wiring

Nov 24, 2009 | 1997 Chevrolet Camaro

1 Answer

The front right turn signal on my 2004 Malibu Maxx will not blink


try changing the peanut bulb underneath the main flasher as they should alternate when one is on the other is off & so on..

Sep 10, 2009 | 2005 Chevrolet Malibu Maxx

1 Answer

Turn signal quits


check to see if the flasher is weak, a quick way to test it is to swap it with the flasher for the 4 ways ( hazard lites ) and try it.

Oct 26, 2008 | 2004 Chevrolet Malibu

Not finding what you are looking for?
2004 Chevrolet Malibu Logo

87 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...