Where is the iat sensor on a 2002 golf v5 170bhp located

It is located in the air intake to the engine, either the flex hose or the air cleaner housing..

On newer vehicles, the IAT is often integral with the mass airflow sensor. Your dealership's parts department will be able to confirm this.

It should be located on the side of ur engine block. Is ur golf 2.0 or 1.8t?

hi,


The Intake Air Temperature (IAT) Sensor is usually incorporated into the Mass Air Flow (MAF) sensor
u can see it on the following picture.
ok

Hi,
On2.7L models, the IAT sensor is located on the left side (driver) of the Intake Manifold plenum, if you are standing in front of the car, it is the sensor right before the two vacumm hoses plugged into the Intake Manifold.

On 3.2L/3.5L models, the IAT sensor is incorporated whthin the Map sensor which is also located on the left side (driver) of the upper Intake Manifold plenum. Right by the coolant reservoir tank.

Good Luck

I assume you are looking for the wiring for the IAT because MAT sensors are no longer used..

here you go

black / white - PCM ground
pink - fused 12-volts
yellow - MAF signal
tan - IAT sensor signal
black - IAT sensor ground

manifold temp. sensors are no loner used.

I believe you are looking for the IAT "intake air temp sensor" which is part of the mass air flow sensor.

good luck

[email protected]

The inlet air temp sensor is part of the Mass Airflow Sensor, it is located between the engine intake manifold and the air filter box, on the air tube. Easy to get to, unplug it and remove 2 screws.

where is IAT sensor located in toyota yaris?

Depending on what size engine you have, it could be on the air filter housing,or somewhere along the intake tube that goes to the throttle body. It's round in shape and has 1 or 2 wires connected to it.Without the size of the engine, I can't tell you exactly where it is.

Hi

Follow the plastic intake tubing from the air box. You will first come across the MAF sensor which is located right next to the airbox. Keep following the tubing. You are looking for a small sensor plugged into the tubing. It should only have a two wire plug to it.

If you cant find it then look on the intake manifold itself, and if it is not there then it is built into the MAF sensor.

Regards

Geordie