Question about Saturn Cars & Trucks

Open Question

2007 Saturn sky/shifter knob removal - Saturn Cars & Trucks

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
virgils
  • 39 Answers

SOURCE: shifter knob removal

the shift knob is glued and pressed on, the best way to remove it intact is to heat the knob with a heat gun and pull straight up with a lot of force, please be very careful because when the knob finally releases there is very good chance that you can hit yourself in the face, if the knob is not to be used again you cut a **** up the side with a dremal tool,

Posted on Oct 13, 2008

Ad
  • 98 Answers

SOURCE: 2007 saturn sky won't start

Anyone that runs into this needs to:
Turn the key as if cranking the engine.
Allow the key to return to the run position and LEAVE IT THERE for at least 10 minutes.
Turn off key.
Repeat two more times, or until the car cranks and runs.

I have seen this take up to 6 attempts, but most likely you will only need to make 3 cycles.


Posted on Jul 23, 2009

  • 1986 Answers

SOURCE: Can not remove the shifter knob. Need to replace

Some knobs need to be physically unscrewed while others have tiny little screws at the base that lock the knob into place

Posted on Aug 12, 2009

  • 6982 Answers

SOURCE: shifter knob removal

If it's a stickshift, many come off by prying out the shift pattern plate on top, there is a nut underneath. Best done when it's warm...colder it is the harder it is to remove. (use small screwdriver and pry up)

Posted on Oct 01, 2009

  • 28 Answers

SOURCE: How do you remove the shifter knob on a 2000 Chevy

Well it either screws off, depending on the supplier, or look for a small clip pushed into the shaft through the knob.

Posted on Nov 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

REMOVING STOCK SHIFTER FOR 4X4 ON 07 WRANGLER


The 4WD shifter knob on the 2007 JK's is ridiculously hard to remove. Pull straight-up with all your might, then after that fails, get some towels, and a chunk of would with a long pry bar. Hopefully you won't crack your center console.

Mar 19, 2014 | 2007 Jeep Wrangler Unlimited Rubicon 2...

1 Answer

My Saturn sky 2007 is leaking oil from the driver side. I think it can be coming from the starter. Is this common with a sky?


No oil leaks are common

To come from the starter, would be a
failed engine rear main seal or oil pan
gasket

Aug 31, 2013 | 2007 Saturn Sky

1 Answer

On my Saturn sky 2007 is leaking oil on the driver side. It could be coming from the starter. Is this a common problem with a sky?


Not especially with a shy but with all engines that have a failed rear main shaft seal. The oil is thrown out to the starter by the back of the flywheel and collects in the nose of the starter housing.

Aug 31, 2013 | 2007 Saturn Sky

1 Answer

2007 saturn sky


The common cause would be the power steering pump, it is rather low on fluid due to a leak in the system or it is defective.

Sep 10, 2012 | Cars & Trucks

1 Answer

2007 sky saturn trunk latch on driver side won't open


A Saturn Sky is a 2 seater and has no rear fold down seats and no key to open the trunk lid.

Jul 29, 2012 | 2007 Saturn Sky

1 Answer

Removing shifter knob on 07 chevy equinox


There is a set screw under the crome ring at the bottom of the shifter knob. use a small flat screw driver and pry down on the chrome ring and it should come down and the set screw is under the chrome ring

Dec 30, 2009 | 2007 Chevrolet Equinox LS New Cars

1 Answer

How do you remove a radio from a 2007 Tuscson city


Don't know the 'City' model... but if it's anything like the REGULAR Tucson, remove the shifter knob (remove access place to two phillips screws - remove screws). Remove shifter knob. Pop out shifter cover plate (snaps in and out). Remove approx 6 phillips head screws holding the metal plate above the shifter pedistal. Pop out the cosmetic cover around the radio, AC control panel and vents (wire harness connectors to digital clock, fog lamps and emergency flashers (and pass airbag light). You now have access to the phillips screws securing the audio/radio unit.

Oct 31, 2009 | 2007 Hyundai Tucson Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

134 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saturn Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Saturn Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...