Question about 2002 Chrysler Sebring

3 Answers

My car won't start codes 1684,0108,1598,1391.

Posted by on

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 35 Answers

,1391 is the camshaft position sensor if you have a 2.5 or 3.0 engine
this is a distributor code ..just change the distributor and put new plugs and wires on the car also ( you must have over 120k on the engine )
you can get it at any auto parts store its about $200 i did see them on e-bay and bought 1 and it only lasted about 9 mo.
no savings because of only 90 day return .
all part stores give a life time return . 2x the work and I was out $125.
be smart you get what you pay for and the job takes about 3 hours if your a good parts changer. now you will have to reset all old codes with a obd tester checker. if you do not have one now get that on e-bay ( the cheapest one will work ) $ 35.

My car won't start codes 1684,0108,1598,1391. - 5ac802d5-4760-4b37-b89c-2fde3de5f4db.jpg

Posted on Dec 05, 2014

  • Steve D'Amico
    Steve D'Amico Dec 05, 2014

    ,1391 is the camshaft position sensor if you have a 2.5 or 3.0 engine

    this is a distributor code ..just change the distributor and put new plugs and wires on the car also ( you must have over 120k on the engine )

    you can get it at any auto parts store its about $200 i did see them on e-bay and bought 1 and it only lasted about 9 mo.

    no savings because of only 90 day return .

    all part stores give a life time return . 2x the work and I was out $125.

    be smart you get what you pay for and the job takes about 3 hours if your a good parts changer. now you will have to reset all old codes with a obd tester checker. if you do not have one now get that on e-bay ( the cheapest one will work ) $ 35.

×

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Champion:

    An expert who has answered 200 questions.

    Governor:

    An expert whose answer got voted for 20 times.

  • Chrysler Expert
  • 252 Answers

Code 1391 is probly why it wont start. cam sensors go out on these engines. i would replace it and the crank sensor. its probly only the cam sensor but i usually replace them both if one goes bad. the other codes are from a low voltage condition i would say, like a dead battery.

Posted on Dec 05, 2014

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 132 Answers

Code 1391 is the camshaft position sensor intermittent loss of signal That is where I would start I would try testing or replacing it. If you were driving it and it died the engine could have jumped time. The code 108 is the Manifold absolute pressure sensor or circuit problem.it would probably run with that problem but not well.1598 is for the air conditioning that won't cause your problem Hope this helps

Posted on Dec 04, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why does your car turn over but not start


Why does your car turn over but not start Jalani, could it be out of gas. Have checked for diagnostic codes. The list of why a car will not start is extensive, check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Engine cranks but won start Troubleshooting tips
What to do if your CAR WON START
Problem 5 Engine Cranks But won Start
Troubleshooting Car That Won Start

May 29, 2016 | Cars & Trucks

1 Answer

No spark after changing battery what could cause this


Mike, You may be having a security issue and will have to look in your manual for relearn procedure. If not this a Tech will have to check to see if there are any diagnostic codes stored in computer.
Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
If Chevrolet Suburban Won Start It Could Be Security Feature Issues
Problem 5 Engine Cranks But won Start
http://www.linnbenton.edu/auto/perform/no_start.html
Car Won Start Copyright AA1CarYOU TRY TO START YOUR CAR BUT IT WON...

May 03, 2016 | Cars & Trucks

2 Answers

My 2004 Taurus won't start and the only codes are for an 02 sensor


what do you mean won`t start. it won`t turn over or it turns over but won`t start or it will run for about 2 seconds then stop?

May 24, 2015 | Cars & Trucks

1 Answer

L have a 2003 Kia Sorento, sometimes it will just turn over but won,t crank. after a while it will start up. or l can be driving down the road and it will start poping and cut off, and won,t start.it does...


It will be a position sensor problem Check the air gap and check that the censor rotor is tight and that there is no material getting in the air gap causing a problem

Jan 06, 2014 | Kia Cars & Trucks

1 Answer

I have a 2003 nissan sentra and was having a hard time starting and now won't start.it also didn't have any power would only go 30mph. But won't start at all now.and is reading po731 po732 and...


Well code 1031 is a problem with the O2 sensor circuit which would not keep the engine from starting.
Code 731 is a problem with first gear and 732 is a problem with second gear, and again neither code should keep the engine from starting.
You may have a computer problem, or something going on with one of the wiring harnesses.
Have you figured out if you are lacking spark or fuel to keep it from starting ?

May 09, 2013 | Cars & Trucks

2 Answers

Car won't start


If you have checked fuel pressure with a gauge and the pressure is normal, are you getting spark to the plugs ?

Apr 30, 2013 | 1997 Pontiac Bonneville

1 Answer

I have 1998 five ram 1500 with 360 (5.9L) engine 4x4. Had replace transmission. Test drove pulled in my driveway it died won't start back. All gauges quit an has codes 920, 921, an 999. Won't...


Could be a wiring problem.
The first two codes are for problems with the shift position sensor, and the code 999 is for a problem with one of the pressure sensor circuits.
You may need a shop manual to troubleshoot the circuits.

Sep 19, 2012 | Cars & Trucks

1 Answer

How do you clear codes for 2004 saturn ion


Clear the codes AFTER a repair was made & the light
stayed on ?

I would purchase an inexpensive $60.00 code reader &
use that.

If you start disconnecting batteries on every vehicle you
do or will own,then bad things happen.

The radio won't work,the car won't start,etc

If you have service manuals to learn your vehicles systems,
then you can eventually know what the results will be

Again,if you fixed nothing,then the light is going to stay on
or come back

Sep 18, 2012 | 2002 Dodge Dakota Club Cab

2 Answers

Theft light blinking/car won!t start


jump the

Starter solenoid

on the passenger fire wall with the key in and on the on position. if the truck starts change it... theft-light-blinking-car-won-t-start-rbr12kxjqsqvwnu2khrshnjz-4-0.jpg

Jun 27, 2009 | 1999 Ford Expedition

Not finding what you are looking for?
2002 Chrysler Sebring Logo

97 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...