Question about Cars & Trucks

1 Answer

I DONT KNOW MY PASSWORD

I TRY TO APPLY ON LINE

Posted by on

  • harish katt
    harish katt Dec 04, 2014

    just let me know., clearly of which password., is that related to online., or computer security password

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Cheetah:

    An expert who has answered 20 or more questions within one hour.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 59 Answers

Reset password

Posted on Dec 05, 2014


1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2002 hyundia santa fe v-6 about 2 months ago i took it to a shop because i was leeaking brake fluid so i bought a new master cyclinder for the brakes well it wasnot the master cyclinder it was the...


rubber o rings around the brake lines are unusual as the pressure generated when you apply the brakes would push the fluid past them. Best bet is to see a different brake mechanic or see a dealer to see if the o rings are available as a spare part

Jan 14, 2013 | 2002 Hyundai Santa Fe

2 Answers

Having a problem with my p0742 will I need a new transmission?


How would some know that?

I assume you haven't even had it road tested yet
by a trans or repair shop

There are no new transmissions,only new when the
car is assembled

Nov 26, 2012 | 2001 Chevrolet Monte Carlo

1 Answer

I have aveo 2004.Once its battery (AC Delco) stop working.I get a new one, machanic unpluged the wires ,removed the old one and adjusted the new battery.when i reached home after 10 KM drive i switched on...


You will have to take it to the dealer to fix your problem. It is in anti theft mode. There is a procedure that you or the mechanic must do before the power is compleetely shut off. every car is different. Any way it has to be reset at the dealer now. Unless you can find the code that goes in it.

Nov 13, 2010 | 2004 Chevrolet Aveo

1 Answer

I have a leak right on the oil filter and dont know how to fix it


replace the filter and try to apply a thin film of oil before installing. Do not over tighten.

Jul 10, 2010 | 1987 Dodge Ramcharger

1 Answer

Detroit diesel injector installation


thoroughly clean area around injectors,and then blow with compressed air so no bits will fall in the holes when injectors removed.loosen main injector pipe nut,remove return fuel line,dont lose copper washers,put special fuel bolts back in top of injector firm[by hand] undo holding down bolts evenly,undo fully injector pipe nut,.gently pry injector loose,and remove,making sure sealing washer at bottom also comes out..while I dont specifically know this particular engine,this guide applies to most diesel motors.I have rebuilt a 6v72 detroit motor,yrs ago.Assembly is reversal.may need to crank over to bleed diesel at injector,always use new sealing washers.

Jul 01, 2010 | 1990 Mercedes-Benz 300 Diesel

1 Answer

Replaced rack and power steering pump, bled the system, no steering shutters low and high speeds and parking...jerry akhan117@aol.com


try taking the vehicle out in the parking lot and cut the wheel to hard lock, apply light throttle and do circles to the left, stop cut the wheel to hard lock on the other side and repeat this three or four times, also you can apply throttle while in park and rotate steering wheel lock to lock many times, the explorers are known for having air trapped in lines,try this and let me know.

Jul 14, 2009 | Ford Explorer Cars & Trucks

1 Answer

Loosing power 1&2 start dies when apply gas


Hesitation can be caused by the spark dropping out. This could be related to a faulty distributor. Try installing an in-line spark tester (can buy at any auto parts store for a few bucks) and see if the spark drops out when you rev the motor up and it begins to hesitate. If so, it is likely the distributor has gone bad.

Dec 17, 2008 | 1994 Ford Aspire

2 Answers

Front brakes will not release after you apply brakes. brake light stays on. truck has set for a year.


hey it is mr goodwrench here , try replacing the master cylinder , works 98% of the time, your welcome!

Jul 29, 2008 | Chevrolet C1500 Cars & Trucks

1 Answer

Front Brakes


Replace the brake pads, then sand the lines and spray them with undercoating. If you dont want to sand lines just spray the undercoating. They will last longer if you sand them. This is available at your local auto parts store

May 30, 2008 | 1993 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...