Question about Kia Cars & Trucks
In my Kia Cerato 2000cc, only heating of the driver seat is ok. The other seat not working. in addition to that, cooling of seats also does not work please help me & tel me where is its fuse
I'm not familiar with this model of Kia since it's not sold in the United States. However, if you know of the U.S. model badging, then a Chiltons/Haynes repair manual should be the same (example: if Cerato 2000cc where you're at is the same as the Spectra here, then the Spectra repair manual should work.)
Posted on Dec 14, 2014
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Page 43 in the document linked to below is a wiring diagram of the heated seats in an 850. If you're lucky some wires have come loose and are hanging under the seats, if you're unlucky you might have to do some shredding of the seats in order to replace broken parts. If so there is a fairly inexpensive repair kit made specifically for this purpose, but I don't have the part number available right now. Arm yourself with a multimeter and get to it!
Posted on May 30, 2009
Left side of the dash, to the right of the IP fuse block. Its a 25 amp circuit breaker, an aluminum cased breaker. CHECK FOR POWER ON THE SEAT SWITCH "A" TERMINAL AND GROUND ON THE "D" TERMINAL. IF YOU HAVE POWER AND GROUND THE SWITCH IS BAD.
Posted on Jun 16, 2009
Remove fuses 10 and 11 in the underhood junction box. Leave out for 5 minutes then reinstall. If the seats start working your Zephyrs dual climate control seat module will need replaced.
Posted on Jul 03, 2009
No fuse.These seats are protected with relays and a seat module.The module is under the drivers seat.There are 3 connectors and it would be hard to check all these wires for power to the motors.First look under the seat and make sure none of the connectors came apart under the seat by something that might have been left or rolled under it.The 2 main ones you can check are the connector 2 terminal C and connector 3 terminal A.C is a black wire which is ground and A is a red wire which is the feed power wire.Connector 2 is green and 3 is black.If the ground and power wires are good then you could have a bad drivers seat module.What I would do is go to the salvage yard and find a used module to try.Good luck.
Posted on Dec 07, 2009
Testimonial: "Thanks for your assistance. Great information"
Tips for a great answer:
Oct 09, 2017 | Kia Cars & Trucks
Jul 05, 2017 | Kia Cars & Trucks
Oct 18, 2016 | 2009 Kia Cerato 1.6
Jul 10, 2016 | 2007 Buick Lucerne CXS Sedan
Dec 10, 2015 | 2006 Kia Cerato 1.6
Feb 27, 2017 | Lincoln Cars & Trucks
May 04, 2015 | 2006 Kia Cerato 1.6
Dec 03, 2014 | Kia Cars & Trucks
Apr 23, 2009 | 2006 Lincoln Zephyr
124 people viewed this question
Usually answered in minutes!