Question about Cars & Trucks

1 Answer

My pump has stopped working

Tested the electricity supply

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 373 Answers

Which pump? Windshield washer pump? Did you check the fuses?

Posted on Dec 03, 2014

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 1997ford tarus will not start right away after i drive it . it has to sit a while before it will start. and sometimes when it start is act like it is going to stop

I would have the fuel pump pressure tested when it doesn't start, I will bet the fuel pump is failing. The electric pump is located inside the fuel tank.

Aug 22, 2016 | 1997 Ford Taurus

2 Answers

What may cause low fuel pressure 00Linc ls v8

Could be pressure regulator, clogged filter, or pump going bad

Jan 11, 2016 | Cars & Trucks

3 Answers

Every time i try and start it i blow the fuel pump fuse and the starter is suckin a lot of juice out of the battery hooked up jumper cables and a battery charge all it does is pop and spark at negtive

The only thing on the 10amp fuel pump circuit should be the pump. So you could disconnect the harness at the gas tank to make sure it is the pump and not a wiring problem.
Have you had the battery tested ? Does the cables spark before you turn the key to crank ?

Mar 03, 2013 | 1990 Nissan Sentra

1 Answer

Have jcb skid steer that was running and then shut down at idle. it will not restart. have plenty of battery and the starter is working fine.

Check the fuel solenoid stop control on the injection pump in case the wire's off/loose. This can be tested by a length of wire and 2 croc clips direct from the pos terminal on the batt. If it fires up, the supply via the harness is lost somewhere. It needs a supply to keep the pump running.
Bleed the fuel system, if it fires up, its drawing air into the system. Check seals/o rings on fuel filters and any loose unions.

Oct 17, 2012 | Cars & Trucks

1 Answer

2000 mercury grand marquis 4.6 fuel

Voltage drop test the electrical circuit , do know how to do automotive electrical testing . Lose connection , resistance in the circuit , lose ground Mastering Voltage Drop Testing with Pete Meier and Jerry Truglia Testing Electric Fuel Pump Problems with Voltage Drop Test

Feb 27, 2017 | 2000 Mercury Grand Marquis

1 Answer

I have a 1991 nissan maxima,i tried to start the car for work today and it would not start,it cranks but it wont start it has 3/4 of a tank of gas,what could be the problem?

Have the fuel pressure tested, the pump is electric and more than likely has stopped working, it is located inside the fuel tank

Sep 16, 2010 | 1991 Nissan Maxima

1 Answer

Warning signs on dash of volvo s40 2005 saying power supply emergency service I then stopped car lost electrics

alternator most likely entered the spirit world--batt usually takes over from reserve supply--hav it tested at a discount place--scan vehicle too if posible

Aug 26, 2010 | 2005 Volvo S40

1 Answer

Getting no fuel to the engine

Check the fuse for the fuel pump under dash fuse panel...its a red plastic one 10 amp if good turn off all electrical like radio fan etc....real QUIET.... turn on the key.... do you hear the electric fuel pump sort of a whirring noise then it stops quickly( a few seconds)
if you do hear it then have the fuel filter checked for clogging/dirt contamination in the tank...drain flush tank replace fuel filter clean injectors with a flush madditive to a tank of fuel.
If you dont hear the pump have the fuel pump relay tested underhood fuse box, if ok drop the tank and replace the fuel pump you may want to replace the relay as well for safeties sake later on.

Aug 10, 2010 | Dodge Ram 1500 Cars & Trucks

2 Answers

My fuel pump has got power but doesnt work

Replace fuel filter and fuel sock. Even if fuel pump runs does not mean it is building pressure, needs to build 30 to 50 PSI, if it will not hold pressure for 30 seconds the pump is still bad. The pump supplies the pressure for the injectors and the injectors are operated by electrical impulse when injector opens if the fuel pressure is not high enough it will not push fuel threw the pintal of the injector.

Jul 05, 2009 | 1993 Subaru Loyale

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides