Question about Cars & Trucks

1 Answer

What could be the problem if KIPOR KDE 6500T Diesel generator turns off when I switch the breaker on?

I have changed the oil and also clean the oil filter. I did also change the diesel and replaced it.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Cars & Trucks Master
  • 755 Answers

Is it air bound , clear it out , or you have a short but I would go with the latter ,

Posted on Dec 03, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

Tip

I switched to the 15w40 diesel oil and my oil consumption dropped...


Believe it or not, it is normal for these engines to use about a quart every 2000 even when they are essentially new. Note that I said, "use", not "burn". The combination of higher compression and operating temperatures causes oil to pass through the engine. You might notice your tail pipes have a good coating on the inside. I managed to slow the process by converting to Mobil 1 0W40. I get much better performance and I only use a quart every 3500-4000.

on Jan 15, 2009 | 2003 Audi TT

1 Answer

Have a Tahoe 7000 diesel ,runs great except when you turn on breaker with no load. runs about 7 to 10 seconds and shuts down, Can you help


Hello dear, have you found any effective ways to solve your problem? If you haven't, visit this website to know more information about generator tech.

Generator Set Diesel Generator Cummins Volvo Perkins Generator
maintenance-safvufzmw2w3qnsosfbejnd3-4-2.jpg

Sep 06, 2017 | Chevrolet Tahoe Cars & Trucks

1 Answer

I have diesel generator Kipor kde 19 STA3 . It keeps shoutinng dowen after it starts


First check the oil, A low oil sensor will shut it down if more than a quart low. Then drain your water separator and change fuel and air filters. Anything outside of that is going to be mechanical (lift pump, injection pump)

Jul 17, 2017 | Cars & Trucks

2 Answers

Why genset not starting.


you say diesel so I assume that it is a diesel engine
The symptoms indicate low pressure in the fuel pump and that can be from air in the system or blocked filters
you mentioned deep sea controller so is it right to say that it is on a boat
If so then check the fuel tanks for a black moss like substance
this causes filter blockages and eventually gets to the pump and injectors and creates hard start problems
if so empty the tank and clean out as best you can
regularly use diesel fuel conditioner to stop the moss regrowth
It comes from condensation in the diesel tank and is a common problem in tanks that are left standing partly empty or with low fuel in them

May 25, 2015 | Cars & Trucks

1 Answer

I have kipor 6700 diesel generator when I'm trying to turn it on the starting motor works but engine doesn't start even though I tried for 8 times the battery is ok and oil level is ok 2- there is oil in...


no -it is not normal. check that it is oil as I suspect that it is diesel fuel and the reason that you can't start it is because the fuel is leaking out and letting air into the system. If so you will have to bleed the system before the engine will start.

Dec 29, 2014 | Cars & Trucks

2 Answers

Why woun't my 6500 ransond generator start its a diesel


See id it is actually pumping fuel and if so see if the glow plugs are getting hot.

Oct 07, 2014 | Cars & Trucks

1 Answer

Lifter noise top side both sides got oil presoure


put half a litre of diesel in the oil and three second squirt of fariy liquid ,no cheap stuff allowed ,run for about a week and drain oil,then with the new oil in ,using the cheapest diesel oil you can get repeat again with diesel and fairy ,by this time they should have quitened down a lot,then change oil again using a diesel oil for a turbo truck change filter as well and then change oil every 6000 miles and a filter every third oil change

Jan 12, 2010 | 2000 Cadillac Catera

1 Answer

Vibration problems in 1kz te


Check calibration. Muffler supports from the front till the back, there should be proper clearance. Is your diesel fuel of proper cetane rating for the engine? Check your belt drive system, is there any part that is excessively draining engine power, power steering pump, air con compressor, alternator or generator? Do these preliminary steps and isolate.

Nov 29, 2009 | Toyota Pickup Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14512 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...