Question about Nissan Navara

Open Question

Wiring diagram for nissan navara fuel injector pump jecs injector pump colour codes

Nissan navara D22 jecs injector pump

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: removal of stereo

there are 2 screws down at climate controls remove them and whole panel pops off, stereo is held in with 4 screws facing you. but it looks bad with a generic stereo fitted nissan have a cd changer that fits in above the stereo where the cup holder is and hooks up to stereo and looks good, not overly flashy,
good luck


Posted on May 05, 2009

  • 1 Answer

SOURCE: navara d22 on 53 plate missing at 2.500 r.pm and

i had a similar problem it turned out to be a neuteral selecter sensor located on the gear box

Posted on Jun 11, 2009

jingB
  • 19 Answers

SOURCE: my nissan navara D22

Hi james, you might have air in your injection system. ussually this air pocket could be corrected by bleeding the system; or, your fuel filter is clogged. First the filter, if your fuel filter is directly attached to a hand pump, and your filter has a sendimentary bleed port at its bottom, drain this first. Then, after its drained, close the drain plug. Next is to look for the fuel return bolt on the injection pump(usually it has a "out" word etched on it) and usually uses a 17mm hexagonal head. Loosen the bolt and slowly remove it. Take care, and watch orientation of the two copper washers that are used for gasket. You might also find a filter screen attached to the bolt on some injection pumps. Anyways, if there is no filter screen, re-screw in the bolt(remember the copper washers) but do not tighten it just let it loose for a while. Now for the sweaty part, using the hand pump, pump  the fuel in until the return bolt spits out fuel. You will see bubbles on the first few pumps but do not stop until it bellows out pure and clear fuel w/o bubbles. If you attained the goal, stop pumping and screw the bolt shut. Wipe-off excess fuel from the injection pump. Try starting the engine. when the engine turns over let it warm up for a while the with, again, with your no. 17mm open wrench, try loosening the injector feedline one at a time(while the engine is running).Watch out for squirting fuel, your engine might rattle a little but it will be fine, just let the fuel flow a few seconds then re-tighten the nut. Do this on all 4 injectors. Let the engine run a few minutes then shut it down. Let it completely cool down then re-start it. Also try checking glow plug(or heater plug) condition. If one glow plug is busted replace all 4 at the same time with the same brand. this would help to keep the engine attain a 1-click engine run.

Hope this helps.
 

Posted on Sep 29, 2009

  • 1 Answer

SOURCE: 2003 d22 3.0lt td nissan navara. Pushing air out intake

did it make a loud whistling noise went it started 2 boost up

Posted on Nov 21, 2009

  • 94 Answers

SOURCE: Nissan Navara STR 2006 d22 3lt turbo. Turbo is whistling very

Remember, what is heard as turbocharger noise may not be caused by a noisy turbocharger. Before replacing a turbocharger perform the following diagnosis.
A. If a loud whine or whistle is heard during acceleration and increases or decreases with rpm and load. This condition is most often the result of a loose clamp/hose at the turbocharger compressor outlet, charge air cooler inlet, outlet or at the intake manifold.

1. With the engine running at idle and the transmission in Park or Neutral with the parking brake set, feel for boost air escaping at each connection between the turbocharger compressor outlet and intake manifold. For limited access areas, spray soapy water on those connectors and look for bubbles.

2. Check the exhaust manifold and exhaust system for leaks.

I hope this helped.

Thank you,
Norse

Posted on May 16, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Nissan navara 2002 twin cab diesel zd30 malfunction light comes on randomly


NISSAN NAVARA questions and answers

www.roadtestreports.co.uk/vans/nissan/navara/qanda/
Results 1 - 40 of 322 - Ask and answer questions on a variety of NISSAN NAVARAmodels. Help and advice ... Have a Navarra Rally Raid 2004 double cab pick up. ... Navara V6 2011 - loss of power & engine management light on. .... ZD30 I have changed the diesel filters after noticing that it's jerking when I'm on full throttle.

Nissan Patrol GR Y61 ZD30 starting problem - YouTube

? 1:23
https://www.youtube.com/watch?v=JxHKfYDCgFQ
Jan 16, 2013 - Uploaded by sspyropoul
After replacing the diesel filter seals and water trap i had no problem .But you ... They still glow for like 15 ...Missing: twin ‎cab ‎randomly

Nissan D22 Navara receives YD25 2.5-litre diesel

www.themotorreport.com.au/.../nissan-re-power-their-d22-navara-range
Jan 31, 2008 - Nissan's popular Navara D22 workhorse range has been ... On top of the 4x4 DX single cab's equipment, the dual cab ST-R adds .... the yd25 engine have a overheating problem, so how comes nissan is ... I believe it is a ZD30 engine. .... with no problems except a cracked injector line (pretty random fault).

Jan 13, 2016 | Nissan Cars & Trucks

1 Answer

How do I tell if the stop switch on the injector pump on my D22 Nissan navara 3.0l str is not working?


remove it from the pump, place the body against the pump to earth it out and have someone turn the ignition on and off. If it is working you will feel it or see that action. Place a rest light in the circuit to see If it is actually getting power from the ignition switch

Sep 12, 2014 | Cars & Trucks

1 Answer

Nissan d22 navara 06 no vacum to brake booster??


if you are sure you have no vacum at your brake booster it could possibly mean either you have a leaking vacum pipe or if you have a pump fitted then the fault is that. If you are not sure if you have vacum at the booster end than it could also be a booster fault. Check the pipe first at the booster end (engine running)

May 26, 2012 | 2006 Nissan Navara 2.5

2 Answers

Navara d22 on 53 plate missing at 2.500 r.pm and


i had a similar problem it turned out to be a neuteral selecter sensor located on the gear box

May 09, 2009 | 1997 Nissan Pickup

1 Answer

Wiring diagram for Nissan Navara D22


ebay is a great location for those manuals ($80-100) but here is a better resource with a FSM to download:

www.nissanpathfinders.net/forum

Jan 22, 2009 | 1997 Nissan Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...