Question about 2005 Nissan Almera 1.5

2 Answers

Nissan Almera wont start with code P0345

Replaced cam and crank sensors, fuel pump, fuel pump relay, battery and ECU. Fuel getting to spark plugs, engine tumbling but there seems to be no electricity to coil packs

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert who has answered 20 questions.


    An expert that hasĀ over 10 points.


    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 28 Answers

It's more than likely your timing chains have stretched, the way to check if they have is remove rocker cover look down at the timing chains and you will see a tensioner that has a small piston pushing a guide onto the chain, if that piston is out more than 10mm then your timing chain is stretched, you will need a new timing chain kit, not cheap and not a simple job to do!

Posted on Jan 24, 2015


Why would anyone replace those parts?

I guess the car was never tested to find any problems

No more to say

Common sense-- tells you that not all those
parts failed at one time or any at all

Posted on Dec 03, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

98 buick regal tries to crank but floods the plugs what is the problem

Yup. Fuel supply problem. Could be a number of things. Check if the injectors are clicking when you crank. no click, no power to the injectors, problem with sensors data to the Ecu. If click, that part is not the problem. More likely Fuel pressure regulator is bad, not enough pressure, or fuel pump relay which controls the fuel pump. So either may be bad or connections are bad or wires cut. Fuel filter may be clogged. To test th fuel pump, you can jump from the battery positive to pump terminal for a short time to verify the pump is good. so then connections at pump, or from the fuel pump relay or it's connections to the ECU. Most disastrous may be the Ecu itself. Other sensors to the Ecu could contribute, but usually with code problems including sensors it goes into a "limp home" mode. overriding bad sensor inputs. If somehow you can get the error codes read at auto parts store, that may give you more clues than I can guess at. Good luck, hope this helps you out. I gave this answer to another query, but most of it applies in the opposite way, you are getting too much fuel (we used to call it flooding)

Mar 28, 2015 | 1998 Buick Regal

2 Answers

2006 nissan x terra. spins over, wont start. replaced fuel pump assembly, crank sensor, left side cam sensor. not getting any cranking rpm from scanner. HELP !

This already sounds all kinds of bad.
Lets start with spark. Did you verify it can make 30kv at all plugs while cranking? f you havent...start there. Do you have any codes in any modules? Engine, theft, trans, body?
Do you have vacuum cranking, do you have MAF reading cranking? do we know if its mechanically still in time? Did you do a cranking compression test? If you have spark, and you remove the fuel pump relay...does it start when it isnt flooding? What is your system and reference voltage...what is cranking vacuum? And what tests did you run that inspired changing all that stuff? Check the c ranking rpm in Generic mode just rpm onscreen, some OEM software doesnt update well during cranking, with one pid selected, solus should update better than 10x a sec, If you still have no need to measure the crank sensor wires or verify the crank sensor ring is even turning,

Jan 05, 2015 | 2006 Nissan Xterra

1 Answer

Nissan Almera wont start with code P0345

Code 345 means the cam sensor on bank two is not sending the correct signal to the engine computer. So no spark.
If you have replaced the sensor, the problem could be the cam or the wiring from the sensor to the computer.

Dec 03, 2014 | 2005 Nissan Almera 1.5

2 Answers

My 1998 beetle won't start. I have replaced cam sensor and it still won't start. Any suggestions?

gas answers, not diesel. and USA only. cant do non USA>
so did you check spark at every cylinder never just 1.
the 1998 cars in USA all have OBD2 puters, ECU.
all scanners scan 1998 here. all.
and all will tell you cranking if any sensor is wrong, IT WILL
crank for 5 seconds, all ECU report CMP or CKP failure.

why not just look,. a scan tool is $9 off fleabay. or?
car dont move, so.... id bet town charge is like 10x a tools.

  1. battery charged?
  2. Compression good on all cyl.
  3. spark good all cylinders.
  4. fueling now>? injection too much , too light>
this order works, all others are dog chasing tail/
sure scan it is first. its what 5min work?
the fuel can not burn if there is no spark
the both fuel and spark are useless to no compression (physics)

Jun 23, 2014 | 1998 Volkswagen Beetle

2 Answers

No spark ferom coil

Probable Causes: Fuel Pump (P0230 to P0233) PCM (P0600 to P0606) Crank Sensor (P0355 to P0399) Fuel Pressure (P0190 to P0194) Chances are the Check Engine Light is not on, but you may find any of the following codes: P0230 to P0233 Fuel Pump codes P0600 to P0606 PCM related codes P0335 to P0339 Crank Sensor codes P0190 to P0194 Fuel Pressure Sensor codes No spark due to a bad crank position sensor, a faulty ignition module or PCM, a problem in the ignition circuit (ignition switch, antitheft system, wiring, etc.), a faulty park/neutral safety switch, a bad ignition coil (only on engines with a single coil ignition), or wet plugs or plug wires (did it rain last night, did you just wash the engine?) A less common cause is a worn starter that draws so many amps while cranking the engine that there's not enough juice left to adequately power the ignition system and fuel injectors. Contributing factors might be a weak battery and/or loose or corroded battery cables. No fuel because of a dead fuel pump, bad fuel pump relay, blown fuel pump fuse, plugged fuel filter or line, or failed PCM injector driver circuit or injector power supply relay. Or, the fuel tank might be empty (don't believe what the gauge is telling you), or the fuel tank might contain contaminated fuel (water or too much alcohol) or the wrong type of fuel (whoops, somebody put in diesel instead of gasoline). No compression because the timing belt or chain is broken, the timing belt or chain is loose and jumped out of time, or the overhead camshaft has snapped.

Dec 20, 2013 | 2000 Hyundai Sonata

1 Answer

2007 NISSAN QUEST It starts and then dies within 2-3 seconds.

hello good day, reverse your air filter, make the bottom to top,, if is not work change the high tension wires

Mar 07, 2013 | 2007 Nissan Quest 3.5 Minivan

1 Answer

2007 NISSAN QUEST It starts and then dies within 2-3 seconds.

It's might be immobilized try the spare key or get it code read that should point u in the right direction

Aug 10, 2017 | 2007 Nissan Quest 3.5 Minivan

2 Answers

My 2002 nissan sentra will crank but won't start. i've replace the ecm/ecu, the cam/crank sensor or position, checked the fuel pump/pressure, and it still is doing the same thing. sometimes it

I assume you checked the fuel pressure and it is normal.
Are the spark plugs getting spark when it fails to start ?
Are you getting injector pulse from the computer ?
Any trouble codes stored in the computer ?

Mar 06, 2013 | 2002 Nissan Sentra

1 Answer

Car wont start. it is not getting any fire. i have replaced fuel pump, computer, cam sensor, crank sensor an the sensor on the flywheel.

have you pulled a spark plug to see if they are getting wet with fuel? Have you got power to the ignition coils with the ignition switch in the on position? The coils get power and are then grounded by the ECU. if power to coils, then replace coils.

Sep 05, 2011 | 2000 Nissan Maxima

Not finding what you are looking for?
2005 Nissan Almera 1.5 Logo

181 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts


Level 3 Expert

76649 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides