Question about 2011 Jeep Patriot

1 Answer

I need the instation program gps in ST-8104

The gps is not activated you could tell me how to activate.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Jeep Master
  • 20,706 Answers

Goto jeep> ask.

Posted on Jan 19, 2015

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What does a red circle with a red triangle an ! Inside triangle mean on a 2004 audi


Electronic Stabilization Program (ESP)

The light will flash if you are driving and the traction control system is activated (it detects wheel slip on ice, water, etc.). This just tells you it is actively working. You should adjust your driving to the current road conditions to prevent loss of control.

If it stays on continuously, the traction control system (ESP) is off, or there is a problem with the ESP system. Usually, the ABS light will also illuminate if the ESP light is on due to a fault.

Apr 06, 2016 | Audi Cars & Trucks

1 Answer

When i lock my 2006 chevy aveo with the remote button the alarm does not activate


You need to look up the programming codes for the remote. You can set it to where the doors lock but alarm does not activate. I am sure you can find it easily through Google.

Jan 20, 2015 | 2006 Chevrolet Aveo

2 Answers

Trying to figure out how to bleed abs block on 2000 chevy silverado 1500


I am in the UK, so do not know this model, but I am a Bosch service tech and can tell you, if you have air in the ABS unit itself, you well need to connect to diagnostic tool with bleeding/venting program on it. The ABS pump needs to run and operate the solenoids to get the air out...

Sep 13, 2013 | 2000 Chevrolet Silverado 1500

1 Answer

Just bought a x reg ford puma but the key fob does not work, bought a new battery and fitted it, needs re-programming but don't know how to do it.


Telephone: Fax: VAT Registration No.:
Infrared remote control
NOTE: Infrared emitter can be seen at front edge of key.
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system.
Programming
When
Key batteries completely discharged. Key batteries not replaced within 15 seconds. Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Turn ignition switch to position I. Wait approximately 10 seconds. Ensure clock LED illuminates.
NOTE: LED illuminates for approximately 5 seconds.
Switch ignition OFF and remove key, while LED illuminated. Programming mode activated for approximately 20 seconds (LED illuminated). Proceed as follows: Point key at receiver (located near interior lamp). Press and hold unlock button Fig. 1 [1]. After approximately 1 second key LED will flash once [3]. Press lock button 3 times Fig. 1 [2]. Release unlock button Fig. 1 [1]. Continue to point key at receiver until LEDs in clock and key have flashed 5 times. Ensure LED remains illuminated. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode and extinguish clock LED: Switch ignition ON and OFF. Wait approximately 20 seconds.
NOTE: A maximum of 4 keys can be programmed. Fig. 1
Radio frequency remote control
System operation
Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds.


Pressing tailgate release button twice within 3 seconds unlocks the tailgate - if fitted. Pressing key lock button once activates central locking and alarm. Pressing key lock button twice within 3 seconds activates double locking system. Interior lamp illuminates when disarming system.
Programming
When
Key added or replaced. System malfunction.
How
Obtain all keys fitted with remote control. Fasten seat belts and close all doors. From position I, turn ignition switch as follows: To position II. To position I. To position II. To position I. To position II. To position I. Programming mode activated for approximately 20 seconds. LED or fog lamps ON warning lamp illuminates (some models) or the system will emit an acoustic signal to indicate start of programming mode. Proceed as follows: Type 1: Press and hold unlock button Fig. 1 [1]. Type 2: Press unlock button Fig. 2 [2]. Ensure clock LED or fog lamps ON warning lamp flashes (some models) or wait for acoustic signal (indicates correct programming). Wait 2 seconds. Repeat above procedure within 20 seconds to program remaining keys. To exit programming mode: Switch ignition ON. Wait 20 seconds.
NOTE: A maximum of 4 keys can be programmed.

Aug 25, 2010 | Ford Focus Cars & Trucks

1 Answer

Air suspension wont inflat on hummer2 2003 rear suspension


what have you done to try to fix. 1 st I would jack the body up leaving the tires on the ground which will then activate the sensors that it is save to inflat. They have to be at least half way up. If that doesn't take it to the dealer and they will program the computer to do it.

Nov 21, 2009 | 2003 Hummer H2

1 Answer

2005 Nissan Sentra - Car locks, but security system no longer activates. Used to horn churp when activated with remote, now no security at all.


Hello and thank you for using FixYa!

I would try to see if you can get your remote to program. Here is a link on how to program your remote. When you get to the point you need to press the button to program it. If the lights don't flash, it's possible you need a battery for the remote, or a new remote.

http://www.ehow.com/how_4669678_program-nissan-remote.html


Thanks Jay!

Jul 12, 2009 | Nissan Sentra Cars & Trucks

2 Answers

What components do I need to activate the XM radio, Scion 2009?


The radio has a code. If you have the car's manual it will tell you how to display the code on the radio screen. Subscribe to xm and give them the radio code, and that is it. Helpful Hint : If you just want music and news and not all the other programs . XM has a 9.99 per month subscription, they won;t tell you unless you ask.. Good luck

Apr 05, 2009 | 2009 Scion xD

1 Answer

Door key pad, won't unlock door


  1. Enter the permanent factory remote keyless entry (RKE) keypad code.
  1. Press the 1/2 button within 5 seconds to activate the programming mode associated with the memory position 1 settings. Holding the 1/2 button for more than 2 seconds after activation erases the stored personal code.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 1 settings. Entering any new personal code automatically erases the old personal code.
  1. Press the 3/4 button within 5 seconds to activate the programming mode associated with the memory position 2 settings. Holding the 3/4 button for more than 2 seconds after activation erases the stored personal code.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed and associated with the memory position 2 settings. Entering any new personal code automatically erases the old personal code.
  1. Press the 5/6, 7/8, 9/0, 7/8 and 9/0 button within 5 seconds to activate the programming mode or allow the system to timeout.
  1. Within 5 seconds, enter the new 5-digit RKE keypad code. The door locks lock and unlock to confirm the new code is programmed. Entering any new personal code automatically erases the old personal code.

Jan 23, 2009 | 2005 Ford Freestyle

Not finding what you are looking for?
2011 Jeep Patriot Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...