Question about 2008 Toyota Camry

1 Answer

I have camry 2008 hybrid and was trying to setup my iphone6 and bluetooth is locked and asking for pin no which i don't have what to do?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 325 Answers

Try using the universal numbers sometimes used by manufacturing companys either 1111 or1234 as the pin

Posted on Dec 02, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
ftw1952
  • 10319 Answers

SOURCE: keyfob stopped working on 2008

yes a battery is needed
Any Toyota dealer will have it

Posted on Sep 18, 2010

  • 101 Answers

SOURCE: 2008 camry hybrid will

check the ground straps from doors to frame.

Posted on Dec 29, 2010

  • 82 Answers

SOURCE: I have a 2008 camry

The easiest way to clear a clogged AC drain is to find the end of the drain hose under the car. With a piece of flexible wire, run it gently up into the hose when the AC is running or has just been running. Don't use wire that is so stiff that it won't go around the curves in the hose or damage the hose. Usually a piece of insulated electrical wire about 20 ga. will work fine. Don't use a coat hanger wire! When you get to the clog you can usually feel it and water will begin to run out of the hose. Work on the clog until you break it up and the water flushes it out. The clog is usually a glob of dust. If the wire doesn't work or you don't have the correct type you can back flush the hose with a turkey baster. Back flush with clean water. Put a towell under the heater/AC unit in the car because the water is likely to leak out of the unit onto the floor.


Thanks for using FixYa.

Posted on Jun 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I can’t download my iPhone 8 phone book into my 2012 Grand Cherokee Uconnect.


Turn iPhone Bluetooth On:First you want to make sure that Bluetooth is functioning on your iPhone. Click on the Settings icon from the iPhone desktop. From the settings screen click General to show the iPhone General Settings as displayed in the below image. Notice you can see if Bluetooth is on or off from this screen. General Settings screen you can click on Bluetooth to configure the Bluetooth settings. On the Bluetooth screen shown below click to the left of Off to turn Bluetooth On.
  1. Begin Uconnect Setup:Now that Bluetooth is operational on the iPhone you can start the Uconnect process. Click the Uconnect button on the rear view mirror to begin. The voice from the Uconnect system will ask you to verbally select one of the options from the menu. Once Uconnect asks for your input say "Setup" to begin the process of syncing the iPhone.
  2. Start Phone Pairing:Once you say setup in the above step the Uconnect system will list numerous options available from the setup menu. One of these options is "Phone Pairing" so when the Uconnect system asks for the choices from the setup menu say "Phone Pairing".
  3. Pair a Phone:In the Phone Pairing menu you can modify current entries or begin pairing a new phone. After Uconnect lists all of the choices you should say "Pair a Phone" to begin the process of pairing the iPhone.
  4. Uconnect Pin Code:The first step in pairing a phone is setting the Bluetooth Pin Code that authorizes that phone to pair with the Uconnect system. When asked for the Pin Code say any four digit combination such as "1 - 2 - 3 - 4". Uconnect will repeat back the Pin Code so you can verify it has recorded properly.
  5. Connect iPhone To Uconnect:After you have set the Pin Code for the Uconnect system you need to view the iPhone's Bluetooth Settings screen which you can get to following the steps in Step 1 above. Before the Uconnect system shows up in Bluetooth the Bluetooth Settings screen will look similar to the below where you may have other Bluetooth devices showing or not.After a couple seconds the Uconnect system will display as "Hands Free" as shown in the below image. Notice it states that it is not yet paired,,,,,
  6. Click on the Hands Free device showing in the Bluetooth devices list above. This will open a new screen as shown in the below image that prompts you for the Pin Code you specified in Step 5.

    Enter the Pin Code and then click the Connect button in the top right corner of the above window. This will pair the iPhone with Uconnect and take you back to the Bluetooth devices screen where the Uconnect Hands Free device will now show Connected as shown in the below image.

    After the device is connected you will be prompted by the Uconnect voice again so proceed to the below steps.
  7. Phone Name & Priority: After connecting the iPhone you will then name the phone and set a priority between one and seven. Name the phone anything you would like and if this is your primary phone set the priority to one so this phone always connects at a higher priority than any other phone.
  8. Verify & Test:Now have a friend dial your cell phone while you are in your car to see if the music volume lowers and the Uconnect voice tells you there is an incoming call from a certain number. To make calls you can press the Uconnect button and follow the voice prompts.
  9. The Uconnect system is a great way to safely use your cell phone in the car.

Jan 13, 2018 | Cars & Trucks

1 Answer

I do not know how to turn the night driving light in my Camry


I'm pretty sure your local Toyota dealer would be happy to show you this if no one responds to your question.

Nov 14, 2013 | 2008 Toyota Camry Hybrid Sedan

1 Answer

How do I reset a 2008 Ford Escape Hybrid after a crash?


Hey Guy, We have a good number of questions to answer and yours has just come up! I'm happy you've found your answer but instead of criticising us why don't you do something useful and share what you've learned. That is what FixYa is all about! John

Aug 17, 2012 | 2008 Ford Escape Hybrid

1 Answer

Where is the air filter on the 08 camry hybrid


It is in the glove compartment, this is for the filtering the cabin air, the air filter for the motor is of course in the engine bay.

Jun 10, 2011 | 2008 Toyota Camry

1 Answer

I have had a flat battery in my Toyota Camry and I have had to break into the car to pop the bonnet and charge the battery. The battery seems fine but whenever I put the key in the ignition, the security...


Seems you have activated your alarm.Try closing the door and locking it with your key and then unlock it ,it should reset.

don,t forget to rate..

Sep 25, 2010 | 2008 Toyota Camry

1 Answer

How to remove back seat on toyota camry 2010


dog crapped on back seat ...have 2009 camary hybrid... how do I remove back seat bottom (where you sit)

May 05, 2010 | 2008 Toyota Camry

2 Answers

My 2008 Toyota Camry Hybrid navigation system does not track my location. It may start correctly, but with a 5 mile drive it is off by .5 miles. My Toyota dealer does not seem to know what to do. It worked...


May have to recalibrate the system. Do you still have the navigaton installation disc? Might need to get a new and updated version from Toyota.

Feb 05, 2010 | 2008 Toyota Camry

1 Answer

Paranoid new owner


I bought a locking gas cap recently from Pep Boys. Maybe you can check online?

As for the noise.. I don't think I've heard anything like that with my 2008 Hybrid. I do notice lots of different noises but I tend to not pay much attention to them..

Jun 11, 2008 | 2008 Ford Escape Hybrid

Not finding what you are looking for?
2008 Toyota Camry Logo

Related Topics:

75 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79024 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...