Question about Cars & Trucks

Open Question

Reset stenhoj 2.32 lift - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

When I start, panel says lift ajar. It is closed. I reset, OK. When I restart, again panel says lift ajar. What is problem


If we're talking about a pickup, then there must be a liftgate on the end of the truck bed.
If the computer says that the lift is "ajar", of course the liftgate is not up and locked in place. There must be a switch somewhere on the lift. Look for the switch.
Hope this helps.

Apr 16, 2015 | 2000 Ford Windstar

1 Answer

Reset for traction control. had car on lift running. couldve caused it?


Use your scan tool or code reader to clear all data

Running a vehicle on a lift will sometimes ruin the
planetaries in the trans & I never like to run any vehicle
in gear with drive axles & independent suspension with
it hanging

Mar 06, 2014 | 2002 Infiniti Q45

1 Answer

How do i turn on the toyota 7hbw23


This is a lift truck (pallet lift). First put the switch to the on position, then on the keypad press the number one button, then the green button.

Nov 29, 2013 | Cars & Trucks

1 Answer

How to reset a service lift light on 2006 BMW 325


hi8, we do this with a service reset tool, like this one:
10 in 1 service light reset tool

greetings

Aug 29, 2011 | 2006 BMW 3 Series

1 Answer

I put car on lift to put tires on now ba ck on the ground the air ride will not pump up why


you may have blown the compressor,must alway shut air ride off when lifting car.try turning off air ride switch then turn see if it will reset

Dec 02, 2010 | 2000 Lincoln Town Car

1 Answer

How do you reset your fuel shutoff


Open the trunk and lift the plastic cover near the right corner of your trunk. There even may be a label saying fuel shutoff switch. After lifting look for a switch with a red button. Push it down and it will reset. Thanks for using Fixya.

Aug 19, 2010 | 1994 Mercury Sable

1 Answer

Reset window motor on 2004 infiniti g35s


I'm not entirely vertain what you are requesting. Window lift motors do not have a reset. However, if your window is not moving up or down, there is a way to check to see if the lift motor is at fault. While holding the window switch either up or down with the key in the run position, bang firmly on the very bottom door edge with a heavy rubber hammer. If your window moves than you are going to have to replace the lift motor. If nothing happens than you have to check your fuses and relays that pertain to that circuit. Thank you, Dana P.S., this is most easily performed by two people.

Jan 22, 2010 | 2004 Infiniti G35 Sport Coupe

1 Answer

Resetting service interval bmw 320d


To reset the service interval indicator you need to buy a "Peake" / "Baume" or similar OBDII reader / resetter.

Cost about $150 - $200 ea.

Jan 16, 2010 | 1999 BMW 318 ti

3 Answers

How do I re boot my range rover suspension. The mechanics lifted the vehicle on a hoist to do some maintenance and when they set it down they could not get it to lift. The vehicle remains flat with the...


hi, this is due to a couple of things. 1 is this a p36 or p38.
things like the door sensors will prevent this from lifting, its to stop it crushing your leg when foot is out.
more than likely there are 2 hieght correctors.
depends on the model. i see these where leg pops out, i get them in where a air bag has popped off, loosing all your air.
when its a p38 and lifted, if u dont push the button on the dash the computer gets confused and wont let it lift, this then needs a reset. i have lifted a lot of range rovers and the p38 is the worst, i use a 2 post lift, u got to push button on dash, this tells it its getting jacked up or lifted. i have forgot to push it a couple of times, a air bag drops off, u need tough thumbs to push it on.
listen to see if the compressor is running when running.
you must open bonnet start engine then shut door making sure all doors are shut, there is a box think it says eas (black box) you can take the cover to see it pumping, u will hear it.
if not you and none of this whats mentioned is at fault u have to have it 1 plugged in or 2 reset. hope this helps u. 1 more suggestion, im not sure about a p36, is the button on the dash on, orange light on, this locks the suspension for lifting, when down wont go up.
get back to me how u got on, i will have another think. im sure the sensor on axle.

Aug 11, 2009 | 2000 Land Rover Range Rover

2 Answers

2005 BMW X 3 service interval reset


Hi geonkm, if you look on the instrument clusteryou will see 2 buttons in the lower centre part of the dash, make sure the ignition is swiched off, press and hold the left button and turn the ignition on to the first position keep holding the button down until you see the display change, then lift you finger and press and hold again untill reset appears ( normally after aprox 5 seconds ) it will also flash, once this happens lift your finger again then press and release straight away, this should reset the service indicator. regards mark ps you may want to print this off prior to trying to reset to make it easier to follow, good luck

Jan 27, 2009 | 2005 BMW X5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...