Question about Chevrolet S 10

2 Answers

How to change the transmission?

A Chevy s10 4x4 engine 4.3

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that has over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

First secure the vehicle on Jack stands remove both drive shafts disconnect linkage from transfer case unhook wiring from transfer case, if possible rent a transmission Jack they are equipped for also removing transfer cases do not try this alone have someone help you remove transfer case mount bolts raise transmission and transfer case with Jack under transfer case remove the cross member from the frame very slowly let the jack down about three or four inches with transfer case secure on Jack remove the bolts surrounding the back of the transmission there should be six bolts holding the transfer case on the back of your transmission when you start pulling the middle and bottom bolts you will loose transmission fluid once removed just shake the transfer case loose then pull it back lowering as you go, once done remove it from the jack readjust the jack under your transmission Jack up slightly to expose the transmission bell housing bolts use a swivel socket and long extension depending on the year older takes a 9/16 the newer ones take a 15mm break the bolts loose you may need to remove the flywheel cover remove 3 torque converter bolts again year determines size using a flywheel wrench or you can turn the flywheel using a good pair of players unplug wiring remove shifter linkage or cable from the transmission with some pressure on the jack remove all the bell housing bolts there are 6 of them and depending on weather the transmission has been out or not you may have to pry the transmission back some also watch your dip stick tube one of the bell bolts will be holding it in place remove the bolt then place a pan under the transmission to catch fluid when you pull the dip stick tube

Posted on Dec 02, 2014

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 742 Answers

Get yourself a service manual.

Posted on Dec 02, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Can I put a 1998 chevy silverado motor in a 1981 ford 100?


I guess you could, but it won't be easy. I'm sure the transmission won't mate up without an adapter plate. You'll have to build a whole new engine mounting system. And you'll have to bring most of the wiring along with the ECM from the 1998 Chevy engine to make it run in the Ford. You'll have no gauges that work, because the Chevy gauges get their inputs from the ECM and your Ford gauges will have nothing to provide information.

Dec 14, 2016 | Ford Cars & Trucks

2 Answers

Are there freeze plugs behind tranny on a 94 4.3 chevy engine


Gene, there are freeze plugs on the engine in which transmission would have to be removed to access. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
How To Replace Freeze Plug On GM 4 3 V6 Engine
Block Plug Basics Tech Article Chevy High Performance Magazine
4 3L Freeze Plug Locations Blazer Forum Chevy Blazer Forums

May 11, 2016 | Cars & Trucks

1 Answer

WHAT KIND OF TRANSMISSION IS IN MY RV? IT HAS A CHEVY 454 ENGINE.


454 chevy engine in motorhome - RV-Coach Online

www.rv-coach.com > Discussion Forum > Mechanic's Corner - Engines
Mar 25, 2010 - I have a 1995 winnebago elanden Chevy chasis and Chevy 454 motor.... I am trying to tighten or replace all the belt on my 1987 Fleetwood Southwind ... What type trans fluid,oil and filter does the 1984 chevy rockwood motorhome take? .... Havereplace ignition switch, check neutral safety switch at transmission, all OK. RV with Chevy 454 engine problems
Oct 18, 2015
454 P30 radiator removal
Jul 23, 2012
Overdrive Transmission Conversion
Nov 6, 2010
4L80E Transmission Problems
Nov 15, 2009
More results from www.rv-coach.com

Nov 24, 2015 | Cars & Trucks

1 Answer

Will Chevrolet malibu 4 cylinder 6 speed transmission turn black after 50k miles


Six-speed automatic transmission is available with both four-cylinder and V-6 engines in a 2009 Chevy Malibu. -----------------------------------------------------------------------------------
Digiprog 3

Apr 10, 2013 | 2010 Chevrolet Malibu 1LT

1 Answer

I changed transmission oil and filter on my 2005 chevy cobalt. i filled with 6.7 quarts of oil. How do I check the level on the transmission.


If you have the owner's manual, it should tell you. Or look on the dipstick, it may say something like "Check warm in Park". Usually, with the car warmed up, park on a level surface, put it in Park with the engine running (set the parking brake, block the wheels) and then check it.
Do not overfill! If it is too full, drain some out, or you will damage the transmission.
I assume you know where your transmission dipstick is? The tube is about 3/4 inch in diameter, the handle is usually near the firewall. (This is not the engine oil dipstick.)

Aug 29, 2010 | 2005 Chevrolet Cobalt

1 Answer

Chevy Transmission problems


First thing is to read out, with a rented scanner, whatever codes the computer is storing instead of just replacing parts. You didn't say whether the transmission is automatic or manual--there are different troubleshooting procedures for each type. Is the shift a floor or column type?

Sep 17, 2009 | 1994 Chevrolet Silverado 2500

2 Answers

1993 chevy cavalier 2.2l 4 c. sparks and wire order


it fires 1-3-4-2. The coil pack is marked 1-4, match them up with your cylinders, and you're good to go! Cylinder 1 is on the front of the engine, the side opposite from the transmission. Find your alternator and that's at cylinder 1.

Jun 23, 2009 | 2002 Chevrolet Cavalier Coupe

1 Answer

1996 chevy lumina 3.4. service engine light on


You will need to replace the valve body in the transmission.

Mar 01, 2009 | 1996 Chevrolet Lumina Mini

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

206 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...