Question about 2000 Mitsubishi Mirage
Hi Guys, I recently installed a new fuel pump in my 2000 Mitsubishi mirage, ever since then I've noticed a whistling sound coming from gas tank where the new fuel pump's installed. I wanna know if that's normal, should I be worried about it? And if so, how can I fix it?
If you run the fault codes you will probably get a code that refers to the cannister venting system. I would say that the gasket for where the pump went in is leaking and that noise is the tank venting air or vacuum as the case may be.
It is always a good idea that when finishing the job and something is not as it was then go back to what you have done and do it again as it will be simple,
Posted on Dec 02, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is pressure...you have to remove the rear seat cushion,then remove the service cover and then detach the fuel pump harness connector.Start the car and allow it to run until the engine stalls.Turn the key to off position.Then disconnect the negative battery cable, attach the fuel pump connector, and install the access cover. Now place shop rags or towels around the fitting that is being disconnected. Loosen the filter feed pipe flare nut on the bottom of the filter.Seperate the flare nut from the filter. If equiped, remove and discard the gakets. remove the mounting bolts and remove the filter.if necessary remove the filter bracket. To install: install the filter to it's bracket only finger tight. Make sure the flow arrow is in the right direction. Make sure new O rings are installed prior to installation. Insert the filter feed pipe to the lower connection of the filter and manually screw in the main pipe's fare nut. While holding the fuel filter nut with a back-up wrench, tighten the banjo bolt to 22 ft pounds and tighten the flare nut to 25 with a back-up wrench on the nut. tighten the filter mounting bolts to 10 ft. pounds. Connect negative battery cable. turn key on to pressurize the fuel system and check for leaks. If repairs on the fuel system are needed remember to release the pressure before opening the fuel system. Hope this helps. Good luck!
Posted on Mar 15, 2009
under the hood there is a second fuse and relay box on the drive5rs side, under the lid will tell you the location of each fuse and relay
Posted on Aug 22, 2009
Tips for a great answer:
May 06, 2016 | Mitsubishi Cars & Trucks
Apr 08, 2016 | Mitsubishi Cars & Trucks
May 22, 2011 | 1999 Mitsubishi Mirage
Apr 10, 2010 | 2001 Mitsubishi Mirage
Nov 19, 2009 | 1995 Mitsubishi Mirage
Oct 11, 2009 | 2000 Mitsubishi Mirage
Sep 13, 2009 | Oldsmobile Cutlass Ciera Cars & Trucks
Aug 22, 2009 | 1993 Mitsubishi Mirage
51 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: