Question about 2008 Nissan 2WD Titan
The answer to my problem of titan NOT firing was due to a chip in my "key" that cost me $150 for local dealer to reprogram
I know that ace hardware has keys but working with Nissan&infinity for 20 years u will probably need new key programed at dealership !
Posted on Dec 02, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: blower for nissan titan
The picture I will try to attach will show you the blower motor housing. The white electrical harness rt hand upper corner is attached to the blower motor resistor. If you have checked the relay and its working ( you can check with a tester) the resistor is probably the problem. It's the most common a/c blower issue I see weekly hope I can send it and hope it helps.
Posted on Nov 08, 2008
Ha this used to happen to me with my sunfire. Just wiggle the steering wheel while trying to wiggle the key out. Sometimes the steering wheel locks up and then keys will get stuck in ignition. Hope this helps.
Posted on Dec 02, 2009
The firing order is 1-8-7-3-6-5-4-2 and the #1 cylinder is located at the left front of the engine and the spark plug and ignition coil for the #1 cylinder will be the first ignition coil and spark plug on the front of the left side of the engine on top of the valve cover, and to remove an ignition coil dis-connect the wire connector to the ignition coil, then remove the bolt securing the ignition coil (usually this is one 10 mm bolt) and give the ignition coil a twist as you pull it straight up and out of the spark plug well, and if you are removing the spark plug then use a socket with an extension and swivel to loosen up and tighten the spark plug, but use about a 6 inch length of 3/8 inch fuel line pushed onto the spark plug to actually remove the old spark plug and also to start the new spark plug down inside of the spark plug well to reduce the possibility of cross-threading or damaging the threads for the spark plug. Here are some images to assist you and the ignition coil location image shows the right side of the engine for reference, with cylinders 2-4-6-8 and this was just the best image that I could find to make that diagram, however they are laid out the same on the left side of the engine 1-3-5-7, and let me know if you require any further assistance.
Posted on Oct 24, 2010
Tips for a great answer:
Sep 16, 2015 | 2007 Nissan Titan LE
Jun 19, 2015 | 2005 Nissan Titan
Feb 22, 2013 | 2004 Nissan Titan
Jun 03, 2011 | Nissan Titan Cars & Trucks
Apr 14, 2011 | 2006 Nissan Titan
Jun 03, 2009 | 2004 Nissan Titan
72 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: