Question about Cars & Trucks
This started with not being able to change to the floor. would change from vents to defrost now it is stuck on vents only.
Your mode actuator is the part you need to replace. Is located on driver side under the dash. is not the easy job but with the right tool you will get to the 3 screw and remove the old one. Next select different position on the gear and insure is moving free and air change to defrost and floor.install the new one.
Posted on Dec 02, 2014
Most likely either the vent switching mechanism is dirty and won't switch the flaps -or- most likely the vacuum that is used to turn the vent flaps is either leaking and not pulling enough vacuum. You will have to get underneath the dash near the center, to check and see if you can manually move the vent flaps. If so, then most likely it is a vacuum leak in a vacuum line to the flap mechanism.
Posted on Dec 02, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
These trucks have a problem where moisture builds up in the heater box then freezes. When this freezes and you change your heater settings it breaks the shaft for the blend door. If this is what happened you should be able to look under the dash above and to the right of the gas pedal and you will see two vaccuum accuators one of them you should be able to wiggle around the linkage if it is broke. To fix this you need to remove the entire dash to get the heater box out which involves discharging the AC and draining the coolant because the heater core and evaporator come out. Please rate.
Posted on Dec 13, 2008
the idea of the switch is run on vacuum and is not making contact with the switch it self either worn contacts in the switch itself **** as an obstruction as well or the vent door is stuck in just that position either behind the glove box or the ash tray are the vacuum lines one of them may be pinched off or the door needs a bit of help until you can free it up
Posted on Sep 08, 2009
The thing to do is check for vacuum leaks. In the engine bay look for any "hoses" coming from the firewall. These are for the heater contols. If any of these are broke? Replace them . Have you installed a after market radio? Sometimes heater controlls get messed up. I would take the radio out and examine the heater controlls.
Posted on Jan 10, 2011
Tips for a great answer:
Dec 02, 2013 | 2003 Chevrolet Blazer
Oct 26, 2011 | 1998 Chevrolet Blazer
Jul 10, 2010 | 1997 Chevrolet Blazer
Jan 13, 2010 | 1996 Chevrolet Blazer
Sep 08, 2009 | 1996 Chevrolet Blazer
May 07, 2009 | 2000 Chevrolet Astro
Mar 04, 2009 | 2004 Chevrolet Blazer
Dec 13, 2008 | 1996 Chevrolet Blazer
Dec 12, 2017 | Cars & Trucks
178 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: