Question about 2009 Volkswagen Jetta

1 Answer

How do I Replace the high beam bulb on a 2009 VW Jetta

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Master
  • 755 Answers

They are easy but goto youtube,

Posted on Dec 02, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

threecs3
  • 2 Answers

SOURCE: cost to replace clutch in 2000 VW Jetta

from what is was told locally is that it would be around $800 - $1000 and can take just around a full day to do. it is not a quick job, so labor costs can be high and the price of parts play a big factor in it just because it is a vw.

Posted on Jul 24, 2008

  • 10 Answers

SOURCE: replace low beam bulb in 2005 jetta

  1. Open the vehicle's hood and secure it in an upright position.
  2. Disconnect the negative battery cable.
  3. Remove the socket cover by pulling it straight off, or turning it clockwise then pulling it off.
  4. Carefully twist the bulb and socket counterclockwise, then pull the assembly from the headlight housing.
  5. Holding the base of the bulb, detach it from the connector harness.

To install:
  1. Holding the base of the bulb, install it securely in the connector.
  2. Install the connector and bulb assembly in the housing and twist to lock into position.
  3. Install the sealing cover by pushing it on and/or turning it counterclockwise. Make sure the cover is installed securely or the lens will be out of focus, or water may get into the light unit.
  4. Disconnect the negative battery cable and check the headlight operation.

Posted on Jun 02, 2009

n8binc
  • 33 Answers

SOURCE: changing high beam and parking light bulb any

Buy, ($20 at your local auto parts place) or flip through the Chilton Manual for your car, it will show you the exact steps.

Posted on Jul 09, 2009

  • 33 Answers

SOURCE: high beams don't work

......No other History, symptoms, clues, things already checked?
Would check the fuses and relay box
Would check the manual (haynes or ?), if separate relay(has contact points that can fail by repeated arc damage like a switch) for high beams, if so could potentially test by switching high relay with low or a test patch wire from battery to the high beam terminal of the relay.
...if not fuses or relays, then potentially the column light/dimmer stalk which is a much bigger pain...
...could also spray some electrical contact cleaner into the column dimmer/light stalk switch and see if any result.
...So, start with the headlights and work back toward the switch---verifying that can get each stage to cause the lights to function by bypassing direct to battery current source.
...hope may have helped

Posted on Aug 09, 2009

FixinFax
  • 3085 Answers

SOURCE: 2005 VW Jetta TDI Wagon: Left brake light doesn't

Very difficult. You have to open the inside access door on the drivers side, remove the amp and wheel well cover, pinch the tabs and the bulb cluster will release. The taillight assembly is bolted from inside of the car, so it can't be done outside.

Posted on Sep 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

If both my regular headlight bulb and high beam head light bulb on a 2009 VW Jetta are both burned out and I only replace the regular bulb and not the high beam, should the regular highlight bulb stil


no --there are two separate light power systems for the bulbs but a shared earth wire. Bulbs blow from power fluctuations that occur from loose earth wires, dirty earth points so check the way the bulbs are put back in and ensure that they are tight.

Dec 02, 2014 | 2009 Volkswagen Jetta

1 Answer

How do I reinsert the pin that holds the high beam headlight in place on a 2009 VW Jetta


remove the wire terminal to the bulb first and roll the black cover back so that you can get to the spring clips holding the bulb in. lift the bulb out and then the black cover will pull of the end of the bulb

Dec 02, 2014 | 2009 Volkswagen Jetta

1 Answer

Headlights turn signals


Check high beam fuse, refers to owner manual for fuse map. If fuse ok, remove high beam bulb, don't break anything, look the filament for breakage, yes you can see it, replace bulb.

Apr 28, 2014 | 2009 Dodge Ram Pickup 1500

1 Answer

High beams working on aveo but low beams won't come on


You have to replace the headlight bulbs. There are two elements in each bulb one for low beam and both for high beam. The low beam burns out first...

Mar 09, 2014 | 2009 Chevrolet Aveo

1 Answer

1996 vw jetta problem with the headlights. The daytime running lights work fine the high beams work fine, but when you turn on the lights from the switch the driver side headlight turns off. I've checked...


I don't have a wiring diagram ,but on most cars I would say your low beam bulb is bad. Try swapping sides to see if the problem goes with it, or just replace the bulb. You can always keep the new one until needed someday... shadetree mech by necessity.

Dec 09, 2010 | 1996 Volkswagen Jetta

1 Answer

How d i adjust my 2007 vw jetta headlights bacause i can practically see the sky at night when i'm driving instead of the road


The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Sep 03, 2009 | 2007 Volkswagen Jetta 2.5 Sedan

3 Answers

Low beam headlights don't work


The problem is in the high beam switch assembly which also houses your turn signals and possibly cruise control, and yes, I'm sure. There are some electrical contacts in the assembly which dis-connect the low beams when you put the high beams on. Constant use of the high beam switch will create arcing on the low beam switch which makes the contacts not conduct electricity anymore. The daytime running lights send power to the low beams on a separate circuit. .

The repair is to either replace the assembly, $300 at dealer, $100 or less do it yourself, or take the assembly apart and clean it for free. (2 hours or less)

Instructions on taking your steering wheel off here: http://forums.tdiclub.com/showthread.php?t=151557

Instructions for fixing the switch here: http://forums.tdiclub.com/showthread.php?t=167831&page=4

P.S. If you own a VW, especially around model years 1999 to 2004, there is a rare but devastating problem with engine coolant being literally pumped through all electrical parts of your car.... destroying it. Repair cost = $8,000. It is called coolant migration. Check your VW right now (takes two seconds, literally), and do a two-minute procedure to fix your car to prevent the problem here: http://www.myturbodiesel.com/1000q/multi/coolant_migration.htm

Jan 19, 2009 | 2001 Volkswagen Jetta TDI

1 Answer

Headlight


the headlight fuses are always the first four going from left to righ on a volkswagen 1 for left lowbeam rigth low beam left high beam right high beam.

May 27, 2008 | 1997 Volkswagen Jetta

Not finding what you are looking for?
2009 Volkswagen Jetta Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75797 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...