Question about 2010 GMC Terrain SLT-1

1 Answer

Where is the knock sensor located on a 2010 GMC Terrain

Had a test done at an auto parts store; stated the knock sensor had a malfunction

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 36 Answers

Being that you have a terrain, your problem is NOT the knock sensor. Locate the 17 digit VIN on your vehicle and contact a dealer and see if there is a timing chain recall that pertains to your vehicle. The problem is the bank one chain actuator is not adjusting properly. I've had to repair a number of these, and it's costly(12-1600.00 and NOT for a DIY'er

Posted on Dec 02, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
BigBlue77
  • 59 Answers

SOURCE: 2003 GMC Yukon

You will have to remove the intake manifold to gain access to the knock sensors. There are two sensors in the valley under rubber plugs. The sensor in the rear has a tendency to fill up with water and cause trouble. You have to make a dam with RTV to stop the water from getting in there.

Posted on Sep 06, 2008

  • 116 Answers

SOURCE: 2003 GMC Sierra Knock sensor and oil pressure??

the knock sensors are located below the intake plenum,or,upper intake manifold as some call it, they screw into the lower intake, the front one is sensor 1, the rear is sensor 2. it is wise to change both if you have some miles.since you are going to be buying a gasket set to do this job.the sensors are cheaper than the gaskets.

Posted on Jun 12, 2009

  • 1608 Answers

SOURCE: where do i find a knock sensor a 1993 gmc sierra

Should be on the right side of the engine by the starter.Has a 1 wire connector.It does not go into the cooling system so you can just take it out without draining the coolant.Hope this helps.Good luck.

Posted on Jan 06, 2010

  • 538 Answers

SOURCE: trying to find out where a knock sensor is located

There are 2 knock sensors on some of those, one screws into the block drain near the starter the other near the left exhaust manifold.

Posted on Jan 24, 2010

  • 40 Answers

SOURCE: How do i set the

Check for a daylight savings on/off setting in the user setup. Once you set it, cycle the key and see if it stays.

Posted on Mar 22, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How many spark plugs in the 2010 GMC terrain and where are they located


Count the number of spark plug wires and both your questions will be answered.

Aug 27, 2016 | 2010 GMC Terrain

2 Answers

How. Many. KNock Sensors On 2010 terrain


2010 gmc terrain
https://www.parts.com/index.cfm?fuseaction=store.PartInfo&PartNumber=12621820&VehicleID=208990&diagram=FJ10135&Title%3D-2.4-LITER-KNOCK-SENSOR

1e620784-364d-46a1-a740-60b18a51f685.gif

May 10, 2016 | Cars & Trucks

1 Answer

My emissions light came on on my 2010 gmc terrain and now my remote start does not work. Emission light has been on for about 3 days now.


if and when u have a check engine light the remote start gets over ridden as a safety but have the code checked out most auto stores will access the code for you for free check out your local areas that will give you a start towards fixing your problem

Dec 11, 2014 | 2010 GMC Terrain

1 Answer

Service engine soon light came on went to auto parts store the readout on the diagnostic tool indicated it was the knock sensor. They sold me one I have a chiltons manual it states there are two located...


yes, unfortunately the intake manifold will need to be removed to get to the knock sensor. make sure you have all gaskets and tools handy before you start this procedure.

Aug 12, 2010 | Chevrolet Silverado 2500HD Cars & Trucks

1 Answer

I get the OBD-II codes of P0325 and P0326. I did a search and I found this site http://www.obd-codes.com/p0325 which explains about the knock sensor circuit malfunction. Is the knock sensor, which I read...


Your local auto parts store, or auto parts superstore should have it, if not, be able to order it. Ex.--Advance Auto Parts store has a BWD Knock Sensor, #S8815, for around $50.00. 2002 Kia Rio 1.5L/L4/FI

Apr 02, 2010 | 2002 Kia Rio

Not finding what you are looking for?
2010 GMC Terrain SLT-1 Logo

567 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...