Question about 2006 Mitsubishi Lancer

1 Answer

2006 Mitsubishi Lancer, gauge fuse keeps blowing. Have replaced the fuse twice, first time it was fine for a week but now it blows after a few minutes of driving...anysuggestionso

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Mitsubishi Master
  • 1,108 Answers

I would normally say to replace with a higher amp fuse, from a 15 to a 20. But it's possible you have a short somewhere in your system, grounding a power wire. A higher amp fuse could cause that grounded wire to overheat and burn making smoke. First thing to do is to check the ground wire(white)where connected to the firewall under dash and make sure they are clean and tight, for a good connection. The power may be backfeeding and causing the fuse to pop because of a week ground.

Posted on Dec 01, 2014

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 03' Pajero blows Instrument Cluster fuse each time car started...

Has it had an aftermarket Stereo Fitted? This is the first place I ould look if it has..

Posted on Jan 19, 2010

  • 1 Answer

SOURCE: engine management fuse keeps blowing

My car stopped running without any warning, its a 2005 ford focus, 2.0 and the 20 amp fuse for the engine management keeps blowing, it's number 9 in the panel and I have replaced it twice, both times it blew again, any tips? Also the odometer reads ------ and that's it.

Posted on Aug 21, 2010

  • 5370 Answers

SOURCE: blowing fuses on blower motor 2006 e250 econoline

Both are possible.But it can be blower motor issue mostly.Its taking too load and that's blowing the fuse.How to Test and Replace Blower motor on car? http://repairhelpcenter.blogspot.com/2011/12/how-to-test-and-replace-blower-motor-on.html--------- How to Replace Blower Motor Wheel? http://repairhelpcenter.blogspot.com/2011/12/how-to-replace-blower-motor-wheel.html
----------

Also more help solutions recommended. Click the link below :---
Blower motor replacing for all vehicles? http://repairhelpcenter.blogspot.in/2012/02/blower-motor-replacing-for-all-vehicles.html
----------Blower motor Resistor shorting problem? http://schematicsdiagram.blogspot.com/2011/12/blower-motor-resistor-shorting-problem.html
--------This will help.Thanks.

Posted on Feb 19, 2012

  • 286 Answers

SOURCE: tail light fuse keeps blowing

Seen this before ,,, You have to disconnect the ground wire from the radio to the vehicle... What has most likely happened is that the radio earth has been connected to the previous radio's illumination wire.
What will appear to be a ground connection while the side lights are OFF is in fact a positive that acts a a ground connection untill the side lights are turned ON
The radio should be earthed properly there after..

Posted on Aug 26, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Mitsubishi l200 indicator lights keep blowing a fuse


Put in a fuse that's rated 5 amps higher than the ones you are currently using. This won't harm anything. Otherwise you may need to install a current dampener on the line.

Dec 16, 2014 | Mitsubishi Cars & Trucks

1 Answer

Ignition fuse switch keeps blowing


you have a short in that circuit chck your harness for wiring that might be exposed to ground or pinched

Apr 13, 2014 | 2006 Kia Sedona

2 Answers

Error code U1108 in Mitsubishi Colt 2006-Check Engine lights on


have you had the instrument cluster programmed, if not this might be your answer. i work for iveco and e
we have to programme new instrument clusters, if it was a second hand one this also might cause the problems

Jan 20, 2014 | 2006 Mitsubishi Colt

1 Answer

I have a 2003 mitsubishi lancer. Everytime I try to turn my key from the ignition to start my car my fuse 4 (40A) blows up I replaced it twice but the new fuse just keeps blowing up:/ what's going on?...


There is a major electrical fault that keeps blowing the fuse. The fuse protects that part of the electrical circuit, 40 amps is heavy electrical circuit, it it wasn't protected by a fuse it car could catch on fire.
You need to get an auto electrician or your Mitsubishi service center to locate the fault and repair.
If you had a wiring diagram for your car then you can trace the wiring from the 40A fuse to the various components to locate the wiring fault or component fault.

Dec 30, 2012 | Cars & Trucks

1 Answer

Fuse for horn keeps blowing on outlander 2007


Someone will need to troubleshoot the circuit to find the short to ground.
Could be in the wiring or the steering wheel.

Oct 02, 2012 | 2007 Mitsubishi Outlander LS

1 Answer

I have a 2002 Mitsu Lancer , the Battery light & Handbrake started to Lit. I have checked the Fuse under the hood and found out the 7.5 amp fuse is blown, so i replaced the 7.5 fuse & keeps...


Make sure that is the correct amp fuse for that ,the alternator,also,check the large wire on the alternator,make sure it is not touching anything.

Apr 04, 2010 | 2002 Mitsubishi Lancer

1 Answer

Engine management fuse keeps blowing


My car stopped running without any warning, its a 2005 ford focus, 2.0 and the 20 amp fuse for the engine management keeps blowing, it's number 9 in the panel and I have replaced it twice, both times it blew again, any tips? Also the odometer reads ------ and that's it.

Jan 09, 2010 | 2001 Ford Focus

1 Answer

03' Pajero blows Instrument Cluster fuse each time car started...


Has it had an aftermarket Stereo Fitted? This is the first place I ould look if it has..

Apr 18, 2009 | 2003 Mitsubishi Outlander

2 Answers

Engine Fuse keeps blowing


Not sure what you mean by engine fuse..depending on where it is . will determend why it is blowing out..I will tell u this. any time a fuse is blowing out.. their is an object that is over loading, something that turns off and on.. like a radio, ac unit,,you have a over load or,, a dead short somewhere,,need to know where this fuse is be for I can help any more..

Oct 13, 2008 | 2002 Mitsubishi Lancer

2 Answers

Lancer 02 Timing Belt


at least 90,000 kilometers

tnx 4 using fixya,

drcool
...

Aug 28, 2008 | 2002 Mitsubishi Lancer

Not finding what you are looking for?
2006 Mitsubishi Lancer Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...