Question about Suzuki Cars & Trucks

1 Answer

Indicator light no longer flash when I lock car doors. .ignis suzuki

Still locking but indicator lights no longer flash .could it be a fuse

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Suzuki Master
  • 1,147 Answers

Yes, could be a fuse. I think a little more likely to be in your remote though, not sending a strong enough signal.

Posted on Dec 01, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

232K7
  • 26 Answers

SOURCE: when locking my hyundai tucson with the remote fob

have they always been that way?

these setting can be changed with a Hy-Scan at any hyundai dealersip.

Posted on Apr 14, 2009

  • 1 Answer

SOURCE: indicator lights stay on perminently

its the signal switch on the colunm NOT the hazard switch

Posted on May 22, 2009

jaysonemanme
  • 500 Answers

SOURCE: 1998 Ford Windstar fuse problem - dome light stays on etc

you most likely have a bad door ajar switch- the door panel has to be removed to access it, its on the door latch- you can unplug them this will take care of the batt drain prob.as for the locks it may be a switch problem- most ford vehicles will not let you lock the vehicle from the driver's door when it's open to prevent locking the keys in.

Posted on May 27, 2009

  • 1 Answer

SOURCE: clk 320 alarm lights(indicator Lights)flashing

hello, i live in Mexico and I got the same issue with my MB, the problem is the Alarm Battery, it must to be replaced. Meanwhile remove Fuses 8 and 9 (into the trunk) and 41 (next to dashboard), this will disconnect the anti theft system. for safety when lock/unlock the car press the remote in front of the infrared port. Good luck solving this issue, for me was very very stressing.

Posted on Jan 26, 2010

  • 435 Answers

SOURCE: door open indicator stays on and lights stay on

One of the doors "thinks" it is open.That will make light stay on, power door locks will not operate and alarm will not arm itself. If the indicator shows which door is open, then check on the door frame for the door ajar pin / switch. Move it by hand repeatedly to see if it is stuck or misaligned. If unable, then pull the pin out to check the connection, and if still no help, then bridge (short) the cables to see if dome light goes out. If this is the case, then replace the pin.

Posted on May 19, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I lost the fuse diagram for my dads 95 dodge grand caravan. Can anyone help me out with one?


#1: Panel Illumination
#2: Guages,Right High beam headlight and the high beam indicator
#3: Rear Wiper, Left headlight High Beam
#4: RH park, backup lights switch and relay,Speed porpotional steering module,power door lock switch illumination and daytime running lights(Canada)
#5: Power Door locks,Power Mirrors,vanity,dome,map,ignition and trunk lights,sunroof,radio,power antenna,body control module and power for the data link connector
#6:Heated mirrors,heated rear window indicator
#7: Instrument cluster illumination,park and tail lights
#8: Cigarette lighter,Radio Amp and horns
#9: Power door lock motors
#10: Not used
#11: Radio
#12:Left low beam head light
#13,14,15,16 not used
26153814-2qh1jtrzfrcszgktlooiom5o-3-0.jpg

Apr 05, 2016 | Dodge Cars & Trucks

1 Answer

Remote locking system is erratic


You may have a dodgy door light switch or the doors are not closing completely. Does the courtesy (interior) light work? Does it extinguish when operating the remote?

Mar 04, 2014 | 2003 Toyota Camry

1 Answer

Automatic door lock 1999 toyota prerunner


hi jerome
I have the procedure for Toyota auto lock, is worth to try it
AUTOMATIC LOCK SETTING
1) Step in the vehicle and make sure that all doors are closed completely
2) Insert the key into the ignition key cylinder.
3) Wait for more than 5 seconds.
4) After turning the key to the ACC position, turn the key from the ACC to the
ON position 5 times within 10 seconds (Last position : ON).
? Status Monitor LED will illuminate for 30 seconds.
Note : In case you implement 6 times or more by mistake,
action steps 6)-8) you made will be canceled.
Please retry from step 2).
5) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key to the ACC position.
? LED will continue illuminating.
? Indicator lights will flash 2 times.
Ignition controlled door lock ON :
6) While the LED is illuminated:
• Open and close the driver's door 1 time.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 1 time.
? LED will extinguish.
Ignition controlled door lock OFF :
6) While the LED is illuminated :
• Open and close the driver's door 2 times.
• Turn the key ACC-ON-ACC 1 time (Last position : ACC).
? Indicator lights will flash 2 times.
? LED will extinguish.

Jan 28, 2014 | Toyota Camry Cars & Trucks

1 Answer

VW red Beetle, now the car is opening by itself, the hazards flash and then the doors open. I then lock with key fob and they open again on their own. The passage door still does not open. The little...


It looks as if you may have to go back to the dark-ages and forget the remote key options, pull the door locking fuse, go back to the old manual way, the key in getting into it. Be ready to spend a few bucks to repair the driver's switching, remote module. Find a local auto-electric business.

Jan 08, 2014 | 2008 Volkswagen Beetle

1 Answer

Hazard light and interior lights problem on 2001 A3


the indicator lights flashing constantly might be a warning from the car that all the doors have not been closed properly

after writing this ^^ i think that the system that tells the car if the door is open or closed it damaged or broken
and needs replacing

try leaving all the doors open and lock the car do the indicator lights flash contantly?

you need to get a dianostics done but due to the reson that it is intermmitant the problem will not exist when you get to the garage

check all the sensors that tell the car if the door is open firstly

Dec 31, 2009 | 2007 Audi A3

1 Answer

How to activate alarm 2001 bmw 325ix doors lockand unlock with key but alarm doesn't activate, lights don't flash (new car to me) if the indicator light flashes, does it mean that you have the alarm...


The flashing light does not mean you have an alarm. They were not standard in the 3-series.
You can get one installed or if you want the dealer can program the lights to flash when locking and unlocking doors even with out alarm. This is called "acknowledgement without DWA"

May 26, 2009 | 2001 BMW 325

1 Answer

While driving my hazard lights keep going off at will what should i do ? The central locking unit is in situ but the there is no actual alarm and although you press the key and the indicator lights flash...


a hazard fuse is big and round mainly silver in color usually under the steering wheel or in the glove-box or on the side of the dash when you open the door

Apr 22, 2009 | 2007 Audi A3

1 Answer

ABS light


It is picking up a signal from one of the wheel sensors probably.

Go here to read files on ABS issues

http://autos.groups.yahoo.com/group/villagerquest/

  • Anti-Lock Brake Warning Indicator Always On
  • Fuse(s).
  • Circuit.
  • Hydraulic solenoid relay.
  • Hydraulic pump motor relay.
  • Brake anti-lock sensor(s).
  • Hydraulic anti-lock actuator assembly.
  • Anti-lock brake control module.
  • GO to ABS Quick Test .

QT5 PERFORM ABS TROUBLE CODE RETRIEVAL
  • Key OFF.
  • Jump Pin 4 of the data link connector to ground.

    5939e8a.gif

  • Key ON.
  • Observe the anti-lock brake warning indicator.
NOTE: The first code to flash will be the start code (12). Also, each code is repeated three times before proceeding to the next trouble code.

Does the anti-lock brake warning indicator flash codes? Yes No RECORD code(s). GO to the following ABS Trouble Code Identification Chart in this section and PERFORM Pinpoint Test specified for first code retrieved. If indicator is illuminated constantly, GO to Pinpoint Test D1 . If indicator is not illuminated, GO to Pinpoint Test A1 .


df42bc3.gif

Jan 02, 2009 | 1993 Mercury Villager

4 Answers

Program garage door opener


You must first erase what's in the memory.
1.) Simultaneously press both buttons 1 and 3 on the Audi's built-in remote. Hold them until the indicator light flashes (20 seconds or longer).
2.) Now hold your garage door remote close to the Audi remote.
3.) Simultaneously press and hold both your garage door remote button and the button you would like programmed. The indicator light will first flash slowly then rapidly.
4.) You may release both buttons once the light flashes rapidly.

Jul 01, 2008 | 2000 Audi A6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

100 people viewed this question

Ask a Question

Usually answered in minutes!

Top Suzuki Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Boyet Soriano
Boyet Soriano

Level 2 Expert

293 Answers

Are you a Suzuki Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...