Question about 2000 Honda Odyssey
Checked climate control, water is hot, was told to blow out drain tube dont know where is it, has had air block before
I've never known of any vehicle to have a heater drain. Most do have radiator drains witch is the same fluid, it is on bottom of radiator.
Posted on Dec 01, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you may have an air mix motor problem or a mode control motor problem. there is a test you can do that may help: 1. turn the ignition switch on. 2. turn the fan switch off. 3. press the recirc control button to select recirc (recirc indicator light comes on.) 4. press and hold the recirc button to select fresh (recirc indicator goes off). Continue to hold the the button down until the recirc indicator comes on for two seconds and then goes off. If the system is okay, the recirc indicator will stay off. If there is a problem, the recirc indicator blinks a code to indicate a fault. 1 blink=air mix control motor/circuit fault. 2 blinks= mode control motor/circuit fault. 3 blinks= evaporator temp sensor circuit fault. In case of multiple problems, the recirc indicator will only blink the code with the least number. write back if this test shows a code and we'll go from there.
Posted on Feb 05, 2009
Sounds like a thermostat or cooling system issue. Change the fluid and the thermostat. It will do your engine good so it's money well spent.
Posted on Dec 31, 2009
SOURCE: my 1995 honda heater is
try back flushing your heater core find the 2 hoses to the heater and start the motor let it run for a bit feel the hoses 1 should get hot and 1 should be a little cooler the 1 that gets hot is the inlet and the cooler 1 is the outlet remove them after the motor has cooled down and use a garden hose to back flush the core flush water through the outlet you dont need to use high pressure if you do there is a chance the core can crack and leak.
Posted on Dec 30, 2010
Tips for a great answer:
Sep 20, 2015 | Pontiac Grand Prix Cars & Trucks
Feb 24, 2015 | Cars & Trucks
Jul 01, 2012 | 2001 Hyundai Elantra
Sep 19, 2011 | 2000 Buick LeSabre
Jun 14, 2011 | Ford F-150 Cars & Trucks
Feb 02, 2011 | Honda CR-V Cars & Trucks
Jan 31, 2011 | 2000 Ford Expedition
Oct 28, 2010 | 1990 Isuzu Trooper
Oct 31, 2009 | Ford Taurus Cars & Trucks
Dec 15, 2008 | 2001 Acura 3.2TL
40 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: