Question about 2008 Saab 9-3

1 Answer

How do i reset the sid display in 2008saab93turbo after replacing battery

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 14 Answers

Pressing the CLEAR button for 8 seconds. on older 9-5 and 9-3 SID's, that you must press CLEAR once & release, then press CLEAR a second time, and hold for 8 seconds. While holding down CLEAR for this second time period, at the 4 second mark "CLEARED" will be displayed, and you will hear 1 beep. If you release the CLEAR button at this point, the DTE and MPG will be cleared out. If you continue holding the CLEAR button past the 4 and 8 second marks, you will hear a 2nd beep, and "SERVICE" will be displayed. This now means that you have cleared and reset the Time For Service message.

Posted on Dec 01, 2014

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Batery cables hooked up backwards now no radio sid/display


Was it jumper cables or only car battery?

Either way check all the fuses - in all 3 fuse boxes, and radio may have a line fuse as well if aftermarket.

I would take battery out and allow things to settle first, though.

May 29, 2014 | Saab 9 3 Cars & Trucks

1 Answer

Saab problems


have the battery load tested for a dead cell as that may be all the problems. After fitting a new battery reset the CPU with a code reader to off set any new problems

Mar 02, 2014 | Cars & Trucks

1 Answer

Sid is displaying key not accepted 02 saab 93 t


1. Try locking and unlocking the doors five times with the remote to reset the immobilizer.

2. Key in ON position push Open button on key fob.

Dec 30, 2013 | 2002 Saab 9-3

1 Answer

Car will not start.It turns over but will not fire.Remote key control is out.Fuelpump is OK. Battery is new.There must be some electrical short somewhere.Do not have access to a code scanner.75 miles away...


equipped with an SID (Saab Information Display) unit that displays various information about the amount of fuel left, the radio station you're listening to and the key's battery status. It is time to change your key batteries if the key stops working or responds slower than usual. The SID on your car will also say "Replace Key Battery." Saab keys use either a CR 2032 or a CR 1632 battery depending on key type. There are two types of keys. The first generation key has one key and a transponder and the second generation key is a one piece key with a built in transponder.
First Generation Key
  • 1 Loosen the single screw that is located by the key ring. Use the small Phillips screwdriver to remove the screw that is on top of the transponder.
  • 2 Lift the plastic top. Remove the old battery and insert the new CR 2032 battery.
  • 3 Put the transponder back together and tighten the screw using the Phillips screwdriver.
  • 4 Press the alarm five times to re-synchronize the transponder with your car.
  • Second Generation Key
  • 1 Push the plastic catch with the pushpin to open the cover latch. The transponder has a plastic catch that is hard to depress. The pushpin will separate it.
  • 2 Lift the plastic cover. Remove the old battery and replace it with the new CR 1632 battery. Position the battery properly.
  • 3 Put the cover back and press the plastic together.
  • 4 Test the transponder with your car to make sure it is working.
  • Dec 02, 2010 | Saab 9 5 Cars & Trucks

    1 Answer

    2004 Saab 9-3 information panel(SID) went out when changing the battery. I've checked all the fuses and nothing.


    Hello,
    Same story here, How did you fix it plz. Do I need to buy new SID, since fuses are all good ????

    Waiting to hear from you

    Mar 27, 2010 | 2004 Saab 9-3

    1 Answer

    How do iturn the service light of on a sabb 93 2006


    on the SID press customise then select system settings then service info and select reset service info. If the option to reset is not there you will need to change the date to a date beyond the 'Days to service', reset option will then appear. when reset, return date to correct setting. (to change date press and hold the info select button when the date is displayed.

    Oct 14, 2009 | 2003 Saab 9-3

    1 Answer

    Resetting average fuel economy


    You only need to have the SID display the information (average fuel usage) and presse the CLEAR button for a few seconds (hold it) and it will reset to 0. When you start driving it will start avereging again. Any settins displayed with a stricked 0 can mean average and can be reset that way.

    Yanick

    Jul 24, 2008 | 2004 Saab 9-3

    Not finding what you are looking for?
    2008 Saab 9-3 Logo

    Related Topics:

    149 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Saab Experts

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22326 Answers

    yadayada
    yadayada

    Level 3 Expert

    78919 Answers

    derek oliveira

    Level 2 Expert

    85 Answers

    Are you a Saab Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...