Question about Cars & Trucks

1 Answer

Whete is heat control valve located 89 chevy celebrity

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,493 Answers

That will be screwed into the intake manifold on passenger side at front. There's a hose in and hose out, a vacuum line or a cable pull on a lever to open and close it.

Posted on Dec 01, 2014


4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 319 Answers

SOURCE: how do you change the computer on my 89 chevy

changing the computer is the easy part it just plugs into the harness that the old one is plugged into. That being said, you need to find out where your computer is. Most are under (and when I say under I mean in the dash) some where. Some are under the hood, you just have to find the location.

**************Special Note*****************

I would really recamend if you are going to replace the computer in your vehicle you have the Chilton that tells you step by step procedures. If you hook up a new computer and there is a drop of juice runninng threw the car, you get the lovely experience of buying another computer. So buy a Chilton and not a haines they are just not as easy to use.


Posted on May 01, 2009

  • 15935 Answers

SOURCE: pcv valve location on a 89 camry

There is not a PCV valve on the 4cyl. 6 cyl. is located under hood, center, upper engine area, mounted in rear valve cover Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.

Posted on Jun 05, 2009

  • 53 Answers

SOURCE: 89 chevy celebrity dies when put in gear

get your fuel filters and cataltic converter checked

Posted on Jan 07, 2010

Testimonial: "thanks very helpful!!"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

WhereDo i add transmission fluid on 89 chevy celebrity

Remove the dipstick, insert a funnel. Pour a sufficient amount of fluid into the funnel.

Aug 05, 2016 | Cars & Trucks

1 Answer

Where is the blower motor located on a 1989 chevy celebrity?

Look under the hood, passenger side rear, can you see the blower motor? Depending on the engine size, with v6, I remove the alternator and bracket to remove blower motor and squirrel cage. this was for an 88, 89 may be the same?

Jan 08, 2015 | Cars & Trucks

1 Answer

89 chevy celebrity stalls when turning

Do the following service it should help the stall out.

Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Jul 17, 2012 | Cars & Trucks

1 Answer

Where is the fuse for the lighter in a 1990 chevy celebrity

not sure, but on my 89 camaro it was the courtesy fuse. the courtesy light fuse should be in the fuse box directly below the ashtray. worth a shot to see if you can get the lighter working

Nov 23, 2010 | 1990 Chevrolet Celebrity

1 Answer


Try replacing the fuel pump relay, or you may have a PCM (computer) and prom failing. Underneath your hood, behind the passenger side headlight, behind the core support, is a bank of 2-8 relays. One of those relays is the relay needed for your fuel pump. There will also be a fuel pump relay fuse located there.
Inspect that area for any corrosion or loose wire (bad ground) Good luck and here is a link for you to retrieve your DTC codes and that may help you resolve the car's issue.
Thank you for using fixya

May 12, 2010 | 1989 Chevrolet Celebrity

1 Answer

89 old ciera cross ref.

Column shift tilt wheel:

Ciera '89, '90
Buick Century '89, '90
Chevrolet Celebrity '89, '90
Pontiac 6000 '89, '98

Column shift w/o tilt

Olds Ciera '89, '90
Buick Century '89, '90
Chevrolet Celebrity '89, '90
Pontiac 6000 '89, '90

Floor shift...same options. Tilt and/or no tilt is a matter of preference as the wiring harness is the same, so either will work. Floor shift is floor shift only,'89 and '90 Ciera, Century, Celebrity, 6000.

Hope this helped.

Mar 06, 2010 | 1989 Oldsmobile Cutlass Ciera

1 Answer

Having trouble locating my idle air control valve

looking at the throttle body assembly, after removing the air filter housing, opposite side of the spark plugs, about an inch or two down, you should see a electrical connection, with four wires, the IAC has two small torxs screws that hold it to the throttle body.

Dec 22, 2009 | 1987 Chevrolet Celebrity

2 Answers

Running rich.

The next step is the throttle position sensor.

May 01, 2009 | 1989 Chevrolet Celebrity

1 Answer

Why types of problems would my 89 chevy celebrity have if the main computer was bad? would it run rich?

Yeah, and a lot of other stuff. And I thought I was bad with an 89 Ranger. At least it's a truck. I do find some really good suppliers on e-bay that can still find parts.

Apr 27, 2009 | 1989 Chevrolet Celebrity

1 Answer

My brake lights in my 89 chevy celeb are getting stuck on

Brake Light Switch Is Located above the Brake pedal, Useualy When this Happens the Switch requires ADJUSTMENT It is self Explanitory ,In the case of lights staying ON Adjust it Closer to Pedal Arm. In some cases The Switch Sticks this Requires REPLACEMENT of Switch.

Jan 23, 2009 | 1989 Chevrolet Celebrity

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

13614 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides