Question about Toyota Land Cruiser

1 Answer

Hi how are y I have this trouble in my Toyota laund cruiser 2013 , b279A dts communication line high fixation

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

Get it serviced.

Posted on Dec 05, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What does u0155 mean

Your vehicle has several electronic modules onboard an they all communicate on a serial data bus network . U codes are communication failure codes , one of the modules isn't communicating for one reason or another . This is a problem best left to the dealer . U0155 OBD II Trouble Code Toyota

Feb 02, 2016 | 2013 Toyota Camry

1 Answer

The RPM of My 2013 land cruiser GXR 8 cylinder, when the gear is on neutral or parking position goes high (1200 and sometimes 1400) what is the reason and remedy? Thanks

Hi Adnan.
You said that you been informed that the gas kit was replaced !!!!!!
what gas kit they talking about? and is your toyota been serviced by an expert?
anyway, what happened is that the ECU has lost the idle position for some reason.
you just need to do this: with ignition off, pull out the 20 amp EFI fuse, located in the fuse box under the hood, for 2 minutes, then put it back, start the engine and let it idle, wait till the engine warm up, drive and enjoy.
Good luck.

Jan 22, 2016 | 2013 Toyota Land Cruiser V8

1 Answer

Hi i have a question about this faulty code b279a tds

B279A, Theft deterrent system, communication line high fixation.

Probable causes:
- Loose connection in harness wiring or connectors.
- Transponder key ecu assembly.
- ECM.
I advice you to please contact the qualified service personnel.

Nov 14, 2015 | 2012 Toyota Corolla L Sedan 1.8L 4-cyl....

4 Answers

What isthe fualt code b279a

could you confirm as OBD code sbegin with a P and have 4 numbers

Jun 12, 2014 | 2008 Toyota Prius

1 Answer

Toyota land cruiser prado 2013 model vehicle speed sensor, wire diagram .

hello dear friend its advisable is go to toyota land cruiser wiring schematic/pdf

Dec 12, 2013 | Cars & Trucks

2 Answers

Hi there i have a 2007 vauxhall zafira lossing coolent needs top up every two weeks at times smells of burning rubber and gets very somkie can run this off after about 5 minutes

Get the coolant pressure tested,its definitely leaking coolant.You will need to get the coolant running line.
Pressure test will help you to know from where exactly coolant/refrigerant is getting leaked.===========For complete step by step troubleshooting i suggest you to go through the help links mentioned below :----Click the link below :-----

Coolant enters in transmission on Toyota Land cruiser?

1991 Toyota Camry: Order Coolant Bypass Tube?


2002 Toyota Camry: Puff of Blue or White Smoke while Starting?

1994 Toyota Camry: Coolant Leak?


MAF, IAT, MAP and Coolant Level Sensor problem all together on Mazda MPV?


GMC Engine Coolant Temperature (ECT) Sensor Replacing?


Loosing Coolant?


Coolant temperature sensor dies again and again?


2000 Daewoo Lanos: Where to Add Coolant?

Blue Water Warning Light on Dash?

Replacing Oldsmobile Engine coolant sensor?

How to test Engine coolant temperature sensor?

Replace Coolant Sensor Module on Oldsmobile?


These details will help.


Nov 27, 2012 | Cars & Trucks

1 Answer

The headlights and high-beam search lights on my 1987 Toyota land cruiser wont turn on. Is this a fuse problem? If so where is the corresponding fuse/fuse-box located? I've already look on the und

The left and right headlights are on different fuses. If both are not working, you need to check the fusible link, headlight relay, and the switch itself. See diagram below.

Jun 15, 2017 | 1987 Toyota Land Cruiser

1 Answer

Hi, 1996 80 series have fitted spot lights ,having trouble finding the connection for high beam so spots only come on with high beam. thanks ron

suprise,suprise thats what they are supposed to do(it stops you blinding other drivers when you have main beam on.....)how many drivers have their fog lights on when it aint foggy???AND whats the point in having spots on with dipped lights????

Aug 11, 2010 | 1990 Toyota Land Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

299 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts


Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8269 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides