Question about Cars & Trucks

1 Answer

How do i get vent to open and fan to run at a decent speed

I have checked fuse panel and checked to see if everything was plugged in to control panel

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 364 Answers

I am assuming your talking about the heater vent? there are a number of possibilities, heater switch, actuator or stuck door flap, first thing to check is slide under passenger side dash, look to see the vent control and try to operate it by opening and closing it with your hand, a faulty actuator or switch need to be determined by using electrical testers on the units. hope this helps

Posted on Nov 30, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 45 Answers

SOURCE: 1999 volkswagen beetle , a/c blow a little air on

Your a/c gas (134a) is too low, there is a safety feature for the a/c compressor to "kick off" if that gas (134a) is too low thus saving your a/c compressor from seizing up. Have a garage check to see how much is in the a/c system they can easily recharge the system for you. Keep in mind this is the simplest fix and most common problem from what you described.

Posted on Mar 20, 2009

  • 208 Answers

SOURCE: Speed control not working, where is the fuse located?

There are three fuses that have to work for the cruise to operate, including the brake lights.Check fuse numbers 53,54, and 59. It can also be affected by the brake switch (and clutch switch - if equipped). The cruise also needs a connection through the brake light bulbs, which means that it will not work if the bulbs are burnt out or if you have LED tail lights. Try pulling up on the brake pedal to see if it is the brake switch. Please post your results. Thanks.

Posted on Sep 09, 2008

  • 2 Answers

SOURCE: Fuse panel

the owners manual has the chart-if not join aztekfanclub.com and you can download the owners manual there

Posted on Jul 26, 2008

motor1258
  • 6674 Answers

SOURCE: climate control varible speed fan not working

According to the schematics on your vehicle, it has a "Blower motor control processor" either built in to your controls, or in line between your controls and blower motor. Yo may get real lucky and find some dirty connections in that area, and get away with cleaning & re-connecting, but I wouldn't get my hopes up too high. You may end up replacing the processor, as it regulates fan/blower speed.

Posted on Feb 16, 2009

Installer1
  • 97 Answers

SOURCE: 2002 honda civic Heater fan will not run and a/c will not come on

got a bad relay somewhere

Posted on Aug 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How do I change heater fan


It would help to know the make and model. Different manufacturers put them in different places and mount them different.

Feb 19, 2015 | Cars & Trucks

1 Answer

My fan blower is not working and it appears no cold or hot air is coming out of any vent at all.


all cars and truck they all have a resistor for the fan speeds it should down by the heater fan , now on the dash controller do you have power to it , some cars have two fuses ,one for fan and one for the controller

Oct 04, 2012 | 2002 Mercury Grand Marquis

1 Answer

Location for blower motor/heater/fan fuse?


Before you rip, check the 30A HEATER CIRCUIT BREAKER in the instrument panel fuse panel. The input is hot with the engine running. CB output connects directly to the heater blower motor. A cluster of heater blower motor resistors determines blower speed as selected by the blower switch in the heater control assembly. The switch setting is sent to the powertrain control module (PCM) which acts to turn the blower motor on at the selected speed.

Sep 22, 2012 | 1994 Ford Escort

4 Answers

The fan on my 2005 vw beetle has quit- could it be the fuse panel located on the car battery>


I am assuming you are referring to the cooling fan on the motor. If not and talking about inside fan jump to paragraph titled INSIDE FAN below. There are three fuse panels on top of the battery and one on the drivers side of car inside door on dash panel. Be sure and check the inside fuses first. There should be a fuse map card on the door to the fuse panel that tells you which location the FAN fuse is in. After that point look at the battery panel and the connections should have what appear to be flat silver pieces of metal flat on top of the battery, with wires connected on both sides. If you have a multimeter set it to continuity and test both sides to make sure power is flowing. Also check for corosion, etc. There are also blade fuses on top of battery that can be checked by removing and looking to see if they are blown. This would show as a burn mark and the metal would be seperated.

Not sure what makes you think its the fuse on the battery that could cause this issue unless somehow you see a defect or damage to this area. It is usually the last to blow unless exposed to water or left open, shorted, etc.

Second thing to be sure is that the car has reached temperature to cause cooling fan to kick in.

INSIDE FAN: If the inside AC/Heater fan has stopped working this is more than likely the fan control knob located in center of the three knobs. The left is temperature control knob for Hot Cold, Center is Fan speed, and Right is vent choice. Unfortunately the unit is a single piece and the fan control switch is not replaceable by itself. You have to buy the whole module. The left and right are cable actuated but the fan control is electric and can short out and cause fan failure total or not run at high speed, not turn off, etc. Suggestion is to search EBAY for your model and lookf for AC control, Fan Control, etc. I would also suggest a Bentley manual for your beetle as it is the BIBLE used by VW mechanics at the dealer to diagnose and work issues. If you fancy DIY on some minor repairs this is the book for you and has 1600 pages of very detailed troubleshooting and procedures, with pictures and is easy to follow. You can find them on ebay as well for about 80 dollars. Be sure and get the correct one for your model year

Good luck

Jun 03, 2010 | 2005 Volkswagen New Beetle Convertible

3 Answers

The heating and cooling fan on my 2003 Oldsmobile Bravada only runs on low speed. What do I check?Could it be a fuse?


I have an 03 bravada and the problem with my blower was the blower motor control module.I just had it replaced and everything works perfect.I paid 115.00 for the part and took 2 minutes to put in.The control module is below the glove box behind a panel.remove the panel and look up and you will see it.It has a rurple and black wire comeing off it.

Feb 21, 2010 | 2003 Oldsmobile Bravada

1 Answer

Blower fan does not work at any speed and I can`t locate a fuse or circuit breaker for it (not listed in fuse panel).does it have a fuse or c/b for the fan and could that be the problem ?


The fuse you are looking for is usually the third up from the bottom on the right row of fuses. You can check all the fuses quickly by using a test light and probing each end opening with the ignition key in the on position. There is no breaker but power travels from the control to a relay and also through a resistor that determines fan speed. You can check the motor itself by running a hot lead from the battery and touching the terminal on the fan motor itself (providing the motor is properly grounded. If it fails to run, the motor itself has failed.

Jan 03, 2010 | 1999 Jeep Grand Cherokee

2 Answers

No air or heat blowing from vents


if the fan is blowing this could be a problem with the climate controll switch that changes the direction of air from floor to defrost to vents, some are vacuum controlled through a vacuum operated mechanism that opens and closes a door in the vents which redirects the air to different places.

Mar 24, 2009 | 1999 Volvo S80

2 Answers

Heater blower not working on 2005 Envoy


It sound like to control panel switch. Can you get to the back of the control panel??? If so, bypass the switch, and connect the two wires with a jumpper wire to see if it start blowing????

Feb 04, 2009 | 2005 GMC Envoy

1 Answer

Fan for heater quit running on 2000 nissan Maxima


Run a 12 volt jumper lead to the fan motor connector from the battery or fuse box, if the fan runs replace the fan speed control module

Nov 20, 2008 | 2000 Nissan Quest

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

22 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...