Question about Cars & Trucks

1 Answer

Van started so slow down first and then the light came on. Then the van drove normal, but the light stays on.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 1,249 Answers

What van? Not mine. Check light code with scanner and report back with year, make and model of van.

Posted on Nov 30, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
leetamara
  • 702 Answers

SOURCE: Manual code retrieval for 1989 plymouth voyager 3.0 v6 engine

Hi Wayne, what you do is turn the key to the "on" position and back to "off". Do this three times. The engine light will flash. It will flash a certain amount of times, pause, then another set of flashes. The first set of flashes is the first number of your code. The second set is the second number. For example, you see 5 flashes, your first number of your code is 5, and so on.

Posted on Jun 11, 2008

Ticodude
  • 53 Answers

SOURCE: #5 cylinder misfire

I have a corolla and had #4 cylinder misfire also diagnosed at autozone. After changing the spark plugs, problem persisted, along with the same error code, so they recommended changing the spark plug wires, and that is what fixed it. I would have changed the rotor cap too, but was low on dough. Glad that was not the problem.

Posted on Dec 29, 2008

  • 19 Answers

SOURCE: 1999 Dodge Grand Caravan Oil light stays on and dings

check your oil.
get some one to help if needed
try a part store like napa, auto zone or carquest
they will be glad help you
do not drive with out oil.

Posted on Feb 23, 2009

  • 155 Answers

SOURCE: Engine light stays on 2005 Chrylser Town/Country

If the Check Engine light is on, your vehicle will should have fault codes stored in the computer. Have a service tech perform a diagnostics test on your vehicle to extract the codes. This will give you an idea of the problem. My guess... O2 sensor since your vehicle is running fine. Codes will be necessary to verify.

Posted on Jun 09, 2009

  • 135 Answers

SOURCE: 2001venture van service engine soon light stays on

most any sensor going bad can cause the check engine light to come on,try disconnecting the posative battery cable for 15 seconds ,then put it back on,will reset the codes, or take it to auto zone,they will test your computer for codes at no charge to you.i had a venture van my was ox. sensor. thanks robert b.

Posted on Jun 17, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Starting problem (see details), on 1998 Town & Country.


Check your battery cables and starter cables especially the connectors and bolts under the hood. The bolts and connections could be loose or corroded. Check the connections near the battery and on the battery since many times mechanics mess with these the most. My guess is something is loose if it starts well most times, but fails occasionally. Did you look for blinky codes or DTCs? A '47' (or P0562) could mean a bad battery or alternator, and a '12' (or P1684) could indicate intermittent connections. Do the dome lights dim or stay well lit when the clicking is heard during cranking? If so, then the issue is most likely near the battery and if not then the issue is more likely near the starter. Good luck. There are a lot of wires under the hood.

Oct 10, 2017 | Chrysler Cars & Trucks

2 Answers

My van won't start after driving a short distance, it will start again after 3 to 5 minutes but then will act like it's going to stall while I'm driving. What's wrong?


Hi Greg, I'm AL the owner of Big As Auto Repair in St Charles Mo

Greg, I read your complete message, but nowhere did I see that you replaced the Cam Sensor. The EGR will cause it to stall at stops but usually will not prevent it from restarting. I would try replacing the Cam Sensor before anything else. If you should need further assistance go to my website by clicking here: Auto Repair

Mar 19, 2015 | 1997 Dodge Caravan

1 Answer

2004 Dodge Sprinter abrupt engine shutdown.


need more info does it run warm

Jan 29, 2014 | Cars & Trucks

1 Answer

Sprinter won't start


Glow plug faulty change them

Oct 24, 2017 | Dodge Sprinter

1 Answer

Ok, 2003 GMC Safari AWD 245,000 km. Drove 100km


sounds like an ignition switch glitch or ignition harness problem can be either depending on the amount of wear and tear with turning on and off of the ignition tumbler or possible chafing or inconsistent short in harness to ignition switch check the ground line up through harness first and check the wiring harness condition

Jan 03, 2011 | 2003 GMC Safari

1 Answer

On my 1998 dodge grane caravan, I drove 15 miles to a place, parked it for 6 hours. while parked it rained. when I got in the van to start it after sitting for 6 hours, it would not start. lights would...


No not at all. The problem may be with the anti-theft system. Sometimes in older cars, especially Dodges', the theft system starts to act up even though you put the key in the ignition. You may want to have it checked out at the dealership, shouldn't cost that much just to have it looked at.

Aug 31, 2009 | 1998 Dodge Grand Caravan

2 Answers

Oil relatied engine problem...maybe? need help


The clicking sound is from lack of oil or lack of oil pressure. When the lifters pump out then they have too much slack in them and thus the clicking or tapping sound. Sorry to say this, but the engine is either very tired or the oil pump has about had it.

Mar 02, 2009 | Ford E-350 Cars & Trucks

1 Answer

Trac light blink and the van totaly shuts down


try a different shop its going to be electrical maybe in the alternator or possibly the battery? have it looked at again

Aug 09, 2008 | 1998 Ford Windstar

1 Answer

Manual code retrieval for 1989 plymouth voyager 3.0 v6 engine


Hi Wayne, what you do is turn the key to the "on" position and back to "off". Do this three times. The engine light will flash. It will flash a certain amount of times, pause, then another set of flashes. The first set of flashes is the first number of your code. The second set is the second number. For example, you see 5 flashes, your first number of your code is 5, and so on.

Jun 11, 2008 | 1989 Plymouth Voyager

2 Answers

2000 ford fiesta courier van td di running problem


not to sure but it might be that you need new spark plugs or your carberetta neds cleaning.

Jun 05, 2008 | 2000 Ford Escort

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...